Why is there water leakage at the sunroof switch of a car?

1 Answers
LaSteven
07/30/25 7:58am
The reasons for water leakage at the sunroof switch of a car are as follows: Check the drainage holes: If you find that the sunroof of your vehicle is leaking, the first thing to do is to check the drainage holes of the sunroof to see if they are blocked. This is because if you often park your vehicle under trees by the roadside, fallen leaves can easily clog the drainage holes, leading to sunroof leakage. If the sunroof leakage is due to blocked drainage holes, timely unclogging of the drainage holes can resolve the issue. Check the seal strip: If the seal strip of the sunroof is damaged, it can easily cause water accumulation on the roof to seep through, resulting in sunroof leakage. Timely replacement of the sunroof seal strip can prevent leakage from occurring.
Was this review help?
9
1
Share
More Forum Discussions

What to Do When the Bulb Failure Warning Light Comes On?

First, check if the light fuse is short-circuited to rule out any electrical issues. Inspect the car lights, locate the damaged bulb, and replace it with a new one. If the bulb failure warning light is on, it indicates that there is a damaged bulb on the car.
2
2
Share

How to Quickly Whiten Yellowed Car Light Covers?

If the car's light covers have turned yellow, you can opt for sanding or polishing them. If you prefer not to sand or polish, you can directly replace them with new covers, as plastic products tend to yellow over time with use.
3
5
Share

How to Turn Off Volvo's Start-Stop Function?

When the auto start-stop is activated and you need to park and turn off the engine, you must first press the brake pedal, which triggers the auto start-stop function. The green auto start-stop indicator light will illuminate. At this point, if you shift the gear to P (Park), the engine will restart. Then, you need to press the "start/stop" button to completely shut off the engine.
2
0
Share

How to Solve Corrosion on Automotive Plastics?

When applying, it's best to apply horizontally or vertically, similar to waxing, as this will result in a better appearance once dried. During the application process, many small bubbles may appear. It's essential to wipe these bubbles clean; otherwise, they will leave small pits once dried. After the black plastic parts regain their black color, they should be waxed. Even the plastic parts that haven't turned black should also be waxed.
16
3
Share

How to Remove Bird Dropping Stains from a Car?

Use a wet wipe or damp cloth, drip water onto the dried bird droppings, then cover the droppings with the wet wipe or damp cloth and wait for 2-3 minutes before wiping it off directly. If you find it troublesome, you can simply go to a car wash for cleaning. To remove bird droppings from the car, you can directly rinse them with water, wait until the droppings soften, rinse again, and then dry with a towel.
18
2
Share

How to Navigate a Roundabout?

When approaching a roundabout, reduce speed to 50-100 meters away and observe the traffic conditions at the roundabout. As you get closer to the roundabout, enter at an appropriate time based on the flow of vehicles inside. Always drive counterclockwise in a single direction when passing through the roundabout, paying attention to directions and exits. Before exiting the roundabout, turn on the right turn signal and observe the movements of vehicles and pedestrians on the right.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.