Why is there no sound when playing music via Bluetooth in the new Sagitar?

What is the wading depth of the Focus?

The maximum wading depth of the Focus is 500mm. The wading depth of the Focus is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake of the Focus is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. Alternatively, installing a snorkel can increase the height of the engine's air intake, thereby improving the maximum wading depth. If wading is unavoidable, the following safe and correct operations should be performed: Before wading, always turn off the auto start-stop function to prevent the engine from automatically restarting after stalling in water, which could cause severe damage due to water ingestion. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, use warning water level markers, trees, or the wheels and doors of other vehicles as reference points to estimate water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half the tire height or the engine's air intake, avoid entering the water and choose an alternative route.

2

3

Share

How to Turn Off the Vehicle's Power Supply?

Without pressing the brake pedal, press the one-touch start button once to turn off the engine. Under normal circumstances, after the driver exits the vehicle and closes the door, the sensor switch will automatically cut off the power. Some vehicle models have a manual control switch located on the interior ceiling; pressing it once will turn off the power.

18

2

Share

How to Check if a Car is a Flood-Damaged Vehicle?

Open the car's hood to inspect the engine compartment; many flood-damaged vehicles have engine wires covered in sludge. Check the interior of the car for unusual odors and rust. Pull out the seatbelt to see if the front and back ends are consistent. If they are not, the car may be flood-damaged.

2

3

Share

How to Determine if the Car Body is Aligned Properly?

When the center divider line or edge line of the road in both side mirrors is parallel to the car body, then the car body is in an aligned state. When the front part of the car is perpendicular to the edge of the road, it indicates that the car body is aligned. If in a parking space, check if the front of the car is perpendicular to the reference object ahead.

14

0

Share

How to Determine if a Vehicle Has Been Flooded?

The simplest method is to check the color of the engine oil for any abnormalities. If the oil turns milky white, it indicates the presence of water in the fuel tank or engine. Inspect the air filter and the lower housing of the air filter for obvious signs of water ingress, and check the intake pipe and its interior for noticeable water traces. Remove the spark plugs from each cylinder and check if they are damp. If they are, it suggests that the engine may have been flooded.

1

0

Share

How to Determine When Tires Need Replacement

When the tread wear reaches the level of the tire's drainage groove protrusions, it indicates that the tire has worn to its limit and needs to be replaced promptly. Observe whether the tire rubber has aged and cracked. If severe aging and cracking are found on the tire sidewalls, the tires should be replaced immediately. When tires exhibit severe uneven wear or have suffered strong impacts leading to deformation and other phenomena, they should be replaced without delay.

19

4

Share

Why is there no sound when playing music via Bluetooth in the new Sagitar?

What is the wading depth of the Focus?

How to Turn Off the Vehicle's Power Supply?

How to Check if a Car is a Flood-Damaged Vehicle?

How to Determine if the Car Body is Aligned Properly?

How to Determine if a Vehicle Has Been Flooded?

How to Determine When Tires Need Replacement

What to Do When There Are Cracks Along the Tire Sidewall?

How to deal with water leakage in the Roewe RX5 trunk?

How to Check Traffic Violation Records?

How to Check if a Vehicle Has Passed Annual Inspection?