Why is there no sound when playing music after Bluetooth connection in Buick?

1 Answers
VonRicardo
07/29/25 4:45pm
There may be no sound when playing music after Bluetooth connection in Buick due to connection errors. It is recommended to turn off Bluetooth and reconnect. Here is some related information about Buick: 1. Buick is an automobile brand marketed by General Motors in the United States, Canada, and China. It is sold in North America, China, CIS countries, and the Middle East. 2. The Buick (BUICK) logo features a pattern resembling "three shields," which serves as its graphic trademark and is the emblem of the Buick division. 3. The logo is installed on the car's radiator grille. The three bullets in different colors (from left to right: red, white, and blue) are arranged at varying heights, conveying a sense of proactive advancement and continuous climbing. It signifies that the Buick division employs top-tier technology, sharp and precise in every aspect.
Was this review help?
2
3
Share
More Forum Discussions

How to Replace the Key Battery for Volkswagen CC?

The method to replace the battery for Volkswagen CC key is as follows: 1. Place the remote key facing upwards, use a small flat-head screwdriver to gently pry into the middle of the gap. The key will separate slightly, creating a gap of about 2mm. Then, carefully separate the key into two parts to access the battery compartment. The prying action is intended to release the hook from the groove in the red circled area shown in the diagram. 2. Gently separate the key along the middle gap, then remove the old battery and replace it with a new one. Below is additional information: The basic principle of the Volkswagen CC remote key is that it emits a weak radio wave, which is received by the car's antenna. The electronic control unit (ECU) identifies the signal code, and then the system's actuator (motor or electromagnetic coil) performs the locking/unlocking action.
3
3
Share

How Often Should Brake Fluid Be Changed?

Different vehicle models have varying intervals for brake fluid replacement, so always refer to the owner's manual. Here's some relevant information: 1. For most family cars, the brake fluid should be changed every 40,000 kilometers or approximately every 3 years. If you frequently drive in rainy or humid areas, shorten the replacement interval accordingly. Periodically open the hood to check if the brake fluid level is low. If you top up the brake fluid and notice it's low again shortly after, immediately inspect for possible leaks. 2. Note that brake fluid is corrosive to car paint and skin, so clean it promptly if spilled. Since brake fluid is hygroscopic (absorbs moisture), always tighten the cap securely after adding fluid to prevent moisture absorption from the air.
8
4
Share

What brand does Mini belong to?

Mini is an automobile brand under BMW. Here is more information about this vehicle: 1. Taking the 2021 Mini Countryman as an example, it is a compact 5-door 5-seat SUV with body dimensions of: length 4310mm, width 1822mm, height 1612mm, and a wheelbase of 2670mm. 2. The 2021 Mini Countryman is equipped with a 1.5T turbocharged engine and a 7-speed dual-clutch transmission, with a maximum power of 100 kW and a maximum torque of 220 Nm. Its drive system is front-wheel drive, with a front suspension using MacPherson independent suspension and a rear suspension using multi-link independent suspension.
16
2
Share

What is the reason for the P2185 fault code?

P2185 fault code generally refers to the coolant temperature sensor circuit being too high or poor internal contact of the sensor. The usual solution is to check whether the coolant temperature sensor is damaged or if there is poor contact. Below is extended information: 1. Introduction: The P2185 fault code, applicable to all car manufacturers, means Engine Coolant Temperature (ECT) Sensor 2 Circuit High. The Engine Coolant Temperature (ECT) sensor transmits the temperature of the engine coolant to the Electronic Control Unit (ECU) in the form of an electrical signal based on the principle of a thermistor, serving as a basis for adjusting fuel injection and ignition. 2. Principle: The coolant temperature sensor is installed in the engine block water jacket or coolant pipeline, in contact with the coolant, to detect the engine's coolant temperature. After receiving this temperature signal, the ECU adjusts the fuel injection time and ignition timing. The slender head of the engine coolant temperature sensor contacts the coolant, and its interior contains a negative temperature coefficient thermistor. When the engine coolant temperature gradually increases, the resistance of the thermistor gradually decreases, and vice versa. When the engine coolant temperature changes, the sensor's output voltage also changes accordingly. After receiving the signal from the coolant temperature sensor, the ECU adjusts the engine's fuel injection time and ignition timing. To determine whether the coolant temperature sensor is functioning properly, it is necessary to measure the sensor's resistance value, signal voltage value, and power supply voltage value.
20
3
Share

Is the Prado produced by FAW or GAC?

Prado is produced by FAW, also known as the Land Cruiser Prado, and it is an SUV model under FAW Toyota. In terms of body dimensions, the Prado measures 4840mm in length, 1885mm in width, and 1890mm in height, with a wheelbase of 2790mm. For power, the Prado is equipped with Toyota's six-cylinder electronic fuel injection 1GR-FE V6 engine, delivering strong output power and torque, along with a highly robust frame and reinforced suspension system. In terms of appearance, the Prado adopts Toyota's family-style design philosophy, featuring a large front grille, with the headlight assembly connected to the grille. The headlight assembly uses a flat design similar to the current Land Cruiser, giving the overall shape a more sharp and domineering look.
5
3
Share

Is it dangerous to sleep in a car with the air conditioning on?

Sleeping in a car with the air conditioning on is dangerous. When the vehicle is idling in place, the gasoline does not burn completely, and a large amount of gas can enter the car through the ventilation system in an enclosed environment. If a person stays in the car for an extended period, it can easily lead to carbon monoxide poisoning. Here are some additional tips: 1. If the driver must rest in the car, they should first park the vehicle in an open and well-ventilated area. Then, lower the window slightly by about two fingers' width for ventilation. Finally, switch the air conditioning mode from recirculation to fresh air intake to ensure proper air circulation inside the car. 2. Alternatively, the driver can run the air conditioning for a while until the temperature inside the car becomes comfortable, then turn off the engine and the air conditioning before resting. This will help avoid potential dangers.
14
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.