Why is there no sound from the car radio?

1 Answers
GarrettMarie
07/29/25 3:45pm
There are two possible situations that may cause the car radio to not produce sound: 1. The audio output wire of the car radio (the wire connected to the speaker) is broken, and the product is in the form of a connector: disassemble it yourself or take the audio system to a car repair shop to remove it, then follow the wires behind to check if the connector has come loose. Check the radio circuit to see if the fuse is blown. If it blows again after replacement, do not replace it again, as this indicates a fault in the circuit board or the entire loop, requiring professional repair. 2. Accidentally pressing the mute button on the radio: press the mute button or volume button again to confirm.
Was this review help?
7
2
Share
More Forum Discussions

How to Coordinate the Clutch and Throttle When Starting?

Since it is in neutral, if you press too deeply, the engine speed will rise too quickly, so you can only press lightly. When the speed rises to 2000 RPM, you can lift the clutch to the semi-engaged position. When semi-engaged, if you want the car to accelerate steadily, the throttle must follow up steadily. At this point, the clutch disc and clutch pressure plate have reached the same speed, and then gently release the clutch.
3
2
Share

How to Shift into Reverse Gear in a 6-Speed Manual Pickup Truck?

Depress the brake pedal of the 6-speed manual transmission vehicle. Press the one-touch start button of the 6-speed manual transmission vehicle. The dashboard lights up, and the vehicle starts. Depress the clutch and shift into the desired gear according to the relative speed. To engage reverse gear, pull up the lock ring. Depress the accelerator pedal to drive.
3
2
Share

What is the installation method for eccentric screws?

First, the screw needs to be installed directly. Then, align the other plate with holes to the previously installed eccentric screw. Once aligned, there will be two holes at the front, and at this point, the clip should be pressed in. Finally, tighten the clip with a screwdriver, but not too forcefully—just enough to secure it.
19
2
Share

What is the steering wheel technique for S-turns in a pickup truck?

For left turns, stay to the right and align the left reference point with the right line; for right turns, stay to the left and align the right reference point with the left line. If one side gets too close, make small steering adjustments in the opposite direction. Additionally, maintain a slow speed as going too fast can hinder observation and judgment, increasing the risk of crossing the line.
8
3
Share

How to Identify the Cylinder 1-2-3-4 Sequence?

The flywheel end of the engine is the rear end, while the pulley end is the front end. The cylinder numbering of the engine increases sequentially from front to back. For an inline 4-cylinder engine, the cylinder closest to the pulley is cylinder 1, and the one nearest the flywheel is cylinder 4.
1
2
Share

How to resolve the persistent wrench light on Chery Flagcloud 2?

The method to reset the wrench light on Chery Flagcloud 2 is to insert the key (note: only insert, do not turn it); Hold down the trip meter stalk for 5-10 seconds, then turn the key to the "ON" position; After another 5-10 seconds, start the engine. Maintain continuous pressure on the stalk throughout this process without releasing. This will clear the wrench indicator.
2
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.