Why is there no response when pressing the car key?

2 Answers
LePaislee
07/24/25 7:50pm
Here are the reasons why there is no response when pressing the car key: 1. If you find that the remote key does not respond when unlocking or locking the car, and you observe that the small light on the key does not flash, it is very likely that the battery in the key is low and needs to be replaced. 2. Another possibility is that the key code does not match the vehicle, and it needs to be re-matched using a computer. For the case where the remote key is out of power, you can solve it by replacing the battery. The steps to replace the battery in the remote key are as follows: 1. First, take out the mechanical key so that you can see the gap in the plastic shell. 2. Use a tool to twist along the gap when it is large enough to open the key cover. During the prying process, be careful not to touch the internal circuit to prevent damage to the electrical components, especially before operating in winter, you can touch metal to release the charge in your hand. 3. Pay attention to the positive and negative directions of the key battery and remember them, then take out the battery and replace it. The original battery uses a Panasonic-CR2032 3V button battery, and the installation direction should be consistent with the original direction. 4. Then close the key cover, making sure the position is aligned correctly to prevent damage to the internal circuit during pressing. After installation, you can try whether the functions on the key are normal. If there is still no response, it needs to be sent to a repair shop for inspection.
Was this review help?
3
4
Share
MacSerenity
08/11/25 10:53am
I've driven quite a few cars and encountered situations where the car key didn't respond when pressed several times. The most common reason is usually the remote control battery running out. When the battery is old and low on power, it can't send signals. I usually try replacing it with a new battery first, which can be bought at supermarkets or convenience stores. If that doesn't work, it might be due to internal damage to the key, such as a stuck button or a circuit malfunction. I've tried using a spare key before—if it works, it indicates an issue with the primary key. Another possibility is a malfunction in the car's receiver, which could be caused by a weak battery or signal interference, like nearby high-power appliances blocking the signal. In such cases, trying a different location might help. For safety, use the physical key to open the door or start the car first to avoid being locked out. Remember, don't force it—calmly inspect the situation before deciding to take it to a repair shop. To prolong the key's lifespan, store it away from heat and moisture.
Was this review help?
16
3
Share
Expand All
More Forum Discussions

How to Check and Display the Engine Oil Level in a Range Rover Sport?

To check and display the engine oil level in a Range Rover Sport, follow these steps: 1. Open the hood and turn on the ignition; 2. Access the instrument cluster menu and select the maintenance information menu; 3. After entering the oil level selection menu, press the Cancel button on the steering wheel twice consecutively to update and view the oil level. The Range Rover Sport is a mid-to-large-sized 5-door, 5-seat SUV with the following dimensions: length 4879 mm, width 2073 mm, height 1803 mm, and a wheelbase of 2923 mm. It is equipped with a 3.0T twin-turbocharged engine, delivering a maximum power of 265 kW and a maximum torque of 495 Nm, paired with an 8-speed automatic transmission.
7
4
Share

Should You Brake or Depress the Clutch First When Downshifting a Manual Transmission Car?

When downshifting a manual transmission car, you should brake first. A manual transmission, or manual gearbox, operates by using the gear shift lever to alter the meshing gear ratios, thereby changing the driving torque to suit different driving conditions. The driving method for a manual transmission car is as follows: 1. Fully depress the clutch pedal; 2. Push the gear lever to engage the 1st gear, the starting gear; 3. Gently press down the turn signal lever to activate the left turn signal, alerting vehicles in front and behind; 4. Press the horn button to notify pedestrians in front of the vehicle that you are about to start; 5. Release the vehicle's handbrake; 6. Lift the left foot gradually until the clutch reaches the half-engaged state, at which point the vehicle will begin to vibrate slightly; 7. As the vehicle starts moving, release the clutch and gently press the accelerator.
12
1
Share

Is Dongfeng Renault a joint venture car?

Dongfeng Renault is a joint venture car, which belongs to the small SUV category. Taking the Dongfeng Renault City K-ZE 2019 E-Fun model as an example, its body dimensions are: length 3735 mm, width 1579 mm, height 1484 mm, wheelbase 2423 mm, minimum ground clearance 151 mm, and trunk capacity 300 liters. The Dongfeng Renault City K-ZE 2019 E-Fun model is equipped with a permanent magnet synchronous motor, with a total motor power of 33 kW and a total motor torque of 125 Nm. It is paired with a 1-speed fixed gear ratio transmission. The front suspension uses a MacPherson independent suspension, and the rear suspension uses a torsion beam non-independent suspension.
10
1
Share

What are the effects of a tire being crushed by a curb?

The effects of a tire being crushed by a curb are: 1. It can easily damage the suspension system; 2. It may lead to bulging and increase the risk of a tire blowout. The functions of a tire are: 1. To ensure good ride comfort and smooth driving; 2. To cushion the impact during driving; 3. To ensure good adhesion between the wheel and the road surface, improving traction, braking, and passability; 4. To bear the weight of the vehicle. Precautions for tire usage include: 1. Avoid starting the car too abruptly; instead, start smoothly at a low speed; 2. Drive straight on good roads without swerving or making sharp turns; 3. Control the speed appropriately when going downhill based on the slope's gradient, length, and road conditions.
17
0
Share

How to Connect a Dash Cam to the Lynk & Co 03?

The method to connect a dash cam to the Lynk & Co 03 is: 1. Insert the memory card into the dash cam; 2. Connect the dash cam to a communication device. The Lynk & Co 03 is a compact car with body dimensions of: length 4639mm, width 1840mm, height 1472mm, and a wheelbase of 2730mm. It is equipped with a 1.5T turbocharged engine, delivering a maximum power of 115kW at 5000rpm and a maximum torque of 245Nm between 1450 to 4000rpm, paired with a 6-speed manual transmission.
8
5
Share

Is Mercedes-Benz Owned by Volkswagen?

Mercedes-Benz is not owned by Volkswagen; both are German automotive brands. Mercedes-Benz models include: A, B, C, E, S, CLA, CLS, etc. Taking the 2021 Mercedes-Benz E300l as an example, it belongs to the mid-to-large-sized car category, with body dimensions of: length 5078mm, width 1860mm, height 1484mm, a wheelbase of 3079mm, and a fuel tank capacity of 66 liters. The 2021 Mercedes-Benz E300l is equipped with a 2.0L turbocharged engine, delivering a maximum power of 190kW at 5500rpm, and a maximum torque range between 2500 to 5000rpm.
19
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.