Why is there no airflow from the rear heating vents in the Haval H6?

What does 'mode' mean in car air conditioning?

mode is used to switch the air outlet mode of the car air conditioning, usually cycling between modes such as foot-level air, head-level air, and windshield defrost. Below are relevant details about mode: 1. 'mode' translates to 'mode' or 'direction' in English, and the mode button is commonly found on multifunction steering wheels and center consoles. 2. If the MODE button is located on the steering wheel, it is used to switch between multimedia modes, typically cycling between FM/AM online radio, USB local, Bluetooth music, etc. 3. It represents the set mode, and pressing it once switches to another mode. For example, there are modes like cooling, heating, air supply, dehumidification, etc.

1

2

Share

What is the wading depth of the Buick Regal?

The maximum wading depth of the Buick Regal is 325mm. The wading depth of the Regal is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, when facing most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Regal is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause serious damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before wading, always turn off the auto start-stop function to prevent the vehicle from automatically restarting after stalling in water, which could cause severe engine damage due to water ingress; Judge the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration; On water-prone roads, observe warning water level markers, trees, or other reference points such as the wheels and doors of other vehicles to estimate water depth before deciding whether to proceed; Be aware of your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed recklessly and choose an alternative route instead.

7

1

Share

Is the Corolla transmission AT or CVT?

Corolla transmission is CVT. More information about AT and CVT is as follows: 1. AT is a hydraulic automatic transmission with a complex structure, consisting of a hydraulic torque converter, planetary gears, and a hydraulic control system, achieving speed and torque changes through hydraulic transmission and gear combinations. 2. CVT is a mechanical continuously variable automatic transmission, composed of two pairs of variable-diameter pulleys and a steel belt, connected to the engine and drive wheels respectively. During operation, speed can be changed by altering the diameter of the pulleys. 3. AT advantages: strong load capacity, high speed; AT disadvantages: high fuel consumption, complex structure. 4. CVT advantages: fuel-efficient and environmentally friendly, small size, low cost, simple structure; CVT disadvantages: low speed.

1

Share

Why Does the Window Roll Down Automatically When Locking the Car Door?

When the window rolls up and then automatically rolls back down, it is usually because the window's anti-pinch function has been triggered. Slight deformation of the rubber seal or excessive force when closing the door can activate the anti-pinch feature. This issue is more common with frameless doors. Since frameless doors lack a frame, the friction increases significantly as the window nears the top when closing. The car's sensors interpret this increased friction as an obstruction, causing the window to automatically roll down. Here are a few methods to try and resolve the issue: 1. When raising the window, do it slowly and incrementally. 2. First, open the car door, raise the window to the top, and then close the door. 3. You can also purchase a specialized window seal cleaner and conditioner spray to soften the rubber seal. 4. If none of the above methods work, you may need to visit a 4S shop or a professional auto repair shop for assistance from a technician.

15

4

Share

Is It Serious If Water Reaches the License Plate Position?

Water reaching the license plate position is serious because it has already exceeded half the height of the tire. If water accumulates to half the height of the car tire: There is a possibility of water entering the engine, and seepage may occur inside the car. Under no circumstances should the engine be started to avoid damage to the engine or electronic components inside the car. Additionally, if the car is damaged due to ignition after being flooded, insurance companies will not cover the costs. Extended Information: Below is an introduction to car maintenance: 1. Exterior Inspection: Before driving, check the doors, hood, trunk, and glass condition. Inspect the car body for damage, tilting, oil or water leakage, etc. 2. Engine and Various Fluids: Check the fixation of engine components and inspect for oil or water leakage at the engine joints. Adjust the tightness of the belt and check the fixation of pipes and wires. Top up engine oil, coolant, and electrolyte as needed. 3. Tires: Inspect tire wear and clean the trunk. Replace tires when they approach the wear indicators. Check for bulges, abnormal wear, aging cracks, or hard damage on the tires. 4. Cleaning and Lubrication: Clean oil stains from the engine hood, door hinges, and trunk hinge mechanisms, and lubricate them. The general service life of antifreeze is 2 years; it should be replaced during maintenance, and the cooling system should be thoroughly cleaned. Due to the hygroscopic nature of the braking system, brake fluid should be replaced every two years.

4

2

Share

What Causes Abnormal Noise When Depressing the Clutch?

Abnormal noise when depressing the clutch may be caused by insufficient lubrication of the clutch pedal's return spring. Here are some relevant details about the clutch: 1. The clutch is installed between the engine and the transmission, serving as the component in the vehicle's drivetrain that directly connects to the engine. 2. Typically, the clutch is mounted together with the engine crankshaft's flywheel assembly, functioning as the part that engages and disengages power between the engine and the vehicle's drivetrain. 3. Throughout the entire process from starting the vehicle to normal driving, the driver can operate the clutch as needed to temporarily separate or gradually engage the engine and the drivetrain.

6

1

Share

Why is there no airflow from the rear heating vents in the Haval H6?

What does 'mode' mean in car air conditioning?

What is the wading depth of the Buick Regal?

Is the Corolla transmission AT or CVT?

Why Does the Window Roll Down Automatically When Locking the Car Door?

Is It Serious If Water Reaches the License Plate Position?

What Causes Abnormal Noise When Depressing the Clutch?

What are the differences between driver's licenses?

Can a car seat bought 10 years ago still be used?

What do the letters on an automatic transmission car represent?

Can the car air conditioning be left on for a long time?