Why is there a humming noise after changing to snow tires?

1 Answers
VanSilas
07/30/25 2:47am
After changing to snow tires, a humming noise may occur, possibly due to bearing issues caused during the tire replacement process. Solution: When replacing tires by yourself, it is recommended to pay attention to the torque of the wheel hub nuts. However, self-replacement is only an emergency measure. It is advisable to visit a repair shop as soon as possible for a four-wheel alignment to ensure even force distribution among all tires. Snow Tire Selection: Different tire tread patterns have varying degrees of noise suppression. Therefore, owners who prioritize quietness should try to choose tires with quiet tread patterns. Additionally, when the tread is excessively worn or exceeds the specified usage time, the noise suppression ability will decrease, so timely tire replacement is necessary.
Was this review help?
4
2
Share
More Forum Discussions

What is the fuel consumption of the 2018 Sagitar 1.6?

There are four models of the 2018 Sagitar 1.6L, including the 2018 1.6L Manual Fashion, 2018 1.6L Manual Comfort, 2018 1.6L Automatic Fashion, and 2018 1.6L Automatic Comfort. All four models are equipped with a 110-horsepower engine, with an NEDC fuel consumption of 6.5L per 100 kilometers. The fuel tank capacity varies among different models of the 2018 Sagitar 1.6L. The distance that can be covered with a full tank of fuel is as follows: For models equipped with a 110-horsepower engine, the fuel tank capacity is 50L. The distance that can be covered with a full tank is 50/6.5*100=769KM. The fuel consumption of a car is directly related to five major factors: driving habits, the car itself, road conditions, natural wind, and environmental temperature. Specific factors that can increase fuel consumption are as follows: Driving habits: Aggressive driving, such as rapid acceleration, frequent overtaking, and not easing off the throttle before a red light, can increase fuel consumption. The car itself: Cars with larger engine displacements generally consume more fuel than those with smaller displacements because larger displacements usually mean higher power, requiring more gasoline to burn and perform work. Heavier cars also consume more fuel because greater weight requires more driving torque. Road conditions: Driving on dirt roads, muddy roads, soft surfaces, or mountainous roads increases resistance and fuel consumption. Natural wind: Driving against the wind or on windy days increases the car's resistance and fuel consumption. Low environmental temperatures: When the engine block is cold, the injected gasoline does not atomize easily, requiring more gasoline to be injected for combustion, which increases fuel consumption. Additionally, at low temperatures, the engine's computer may control the engine to run at higher RPMs to warm up, which also increases fuel consumption.
16
0
Share

Is it better to use 92 or 95 octane gasoline for the Nissan Sylphy?

According to the official vehicle user manual recommendation, the Nissan Sylphy should use 92 octane gasoline. In addition to checking the appropriate gasoline grade in the vehicle user manual, you can also find it on the fuel tank cap, which will be marked accordingly. Generally, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. However, with the application of some new technologies, the gasoline grade cannot be solely determined by the compression ratio. A high compression ratio can still be adjusted to use lower octane gasoline because, besides the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline octane number, the higher the octane value and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If the Nissan Sylphy occasionally uses the wrong gasoline grade, simply switch back to the correct grade after consumption. However, long-term use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower octane gasoline, using higher octane gasoline will not cause damage, but the increase in octane value will alter the fuel's ignition point, leading to delayed combustion in the engine. This means both the engine's power output and thermal efficiency will decrease, resulting in poorer performance. For vehicles recommended to use higher octane gasoline, using lower octane gasoline can cause engine knocking. Because the octane value is too low, the gasoline's ignition point decreases, causing premature ignition during the compression stroke. If combustion occurs before the spark plug ignites during the compression stroke, resistance will arise during the upward stroke. This resistance makes the engine run very unstably. If it's only slight knocking, the noise increases, but the damage to the engine is not significant. However, if there is noticeable knocking, it indicates severe engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring.
20
3
Share

What Causes the Engine Shaking Warning Light to Illuminate?

Car engine shaking warning light illumination can be attributed to the following reasons: 1. Poor fuel quality leads to incomplete combustion, causing excessively high concentration of mixed gas in the cylinders which triggers the engine shaking warning light. 2. Faulty spark plugs, high-voltage wires or ignition coils. Malfunctioning ignition system or poor spark plug firing condition can activate the engine shaking warning light. 3. Aging rubber components in engine mounts and transmission mounts may cause the engine shaking warning light to illuminate. 4. Faulty intake pressure sensor. Insufficient fuel supply from the fuel pump or malfunctioning intake pressure sensor can also trigger the engine shaking warning light.
14
1
Share

How many amps should be added for a motorcycle air switch?

Motorcycle air switch installation requires 10A to be sufficient. Introduction to air switch: Air switch, also known as air circuit breaker, is a type of circuit breaker. It is a switch that automatically disconnects when the current in the circuit exceeds the rated current. Function of air switch: The air switch is a very important electrical appliance in low-voltage distribution networks and power drive systems, integrating control and multiple protection functions. In addition to completing the connection and disconnection of circuits, it can also protect against short circuits, severe overloads, and under-voltage in circuits or electrical equipment, and can also be used for infrequent motor starting.
6
0
Share

How many days after selling a car will the indicator be available?

Car indicators will usually be available within two to three days after selling a vehicle. Definition of car indicators: Car indicators are primarily implemented as a regional information platform management system to address the increasing demand for vehicles, exercise certain regulatory controls over automobiles, achieve 'orderly growth' of vehicle quantities according to specific standards, alleviate urban road traffic congestion, and improve climate conditions (air quality) through 'multi-functional, rapid operations'. Main services updated by car indicators include: For example: car purchase, license plate information, vehicle transfer, and other related automotive business information can be queried through the platform. Generally, you can check your results within 3-5 working days.
14
5
Share

How many days does it take for water accumulated in the chassis to dry under sun exposure?

It takes about three days of sun exposure for the soundproofing cotton in the chassis to dry completely after being soaked. Check the following factors: whether the sealing strips are aged, cracked, or incomplete, leading to poor sealing and water ingress; whether the waterproof membrane is damaged—inspect the waterproof membrane inside the rear door trim panel and recall if any repairs or modifications were previously done that might have affected the membrane; whether the drainage holes on both sides of the sunroof are clogged—if blocked, rainwater cannot drain through the pipes, causing the water level to rise continuously until it overflows along the headliner and sealing strips, eventually soaking the soundproofing cotton on the floor panel.
8
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.