Why is the Toyota car constantly making noise?

1 Answers
LeCharles
07/29/25 6:03pm
Toyota car constantly making noise may be caused by lack of lubrication in the door hinges. In this case, adding appropriate lubricant to the hinges should solve the problem. Here is some related information about Toyota: 1. Introduction: Toyota Motor Corporation is an automobile manufacturer founded by Kiichiro Toyoda in September 1933 and officially established on August 28, 1937. 2. Development: The founder of Toyota Motor Corporation established Toyota Motor Industries Co., Ltd., fulfilling his father's wish to produce "Made in Japan" automobiles. 3. Logo: This logo was released in October 1989, on the 50th anniversary of TOYOTA's founding. The design focuses on a symmetrical composition of ellipses. The ellipse, a curve with two centers, represents the heart-to-heart connection between car manufacturers and customers.
Was this review help?
10
5
Share
More Forum Discussions

Does a Car Air Conditioner Not Cooling Mean It Needs Refrigerant?

Not necessarily. Below are the specific reasons and solutions for a car air conditioner not cooling: 1. Insufficient or low refrigerant: This could be due to a minor refrigerant leak. You can observe this through the sight glass on the dryer tank. If there are continuous bubbles in the sight glass while the air conditioner is running, it indicates insufficient refrigerant. If there are obvious bubble flips, it means the refrigerant is severely low. In this case, simply adding refrigerant will solve the issue. 2. Loose compressor drive belt: If the drive belt is loose, the compressor may slip during operation, reducing transmission efficiency and causing the compressor speed to drop. This results in decreased refrigerant compression and delivery, leading to poor cooling. If the compressor drive belt is too loose, it should be tightened. If it cannot be turned by hand, the belt is too tight and should be slightly loosened. If tightening doesn’t help, or if the belt shows cracks, aging, or other damage, it should be replaced with a new one.
4
3
Share

What does the menu in the car mean?

The menu in the car refers to the menu button, which usually appears on the multifunction controls of the steering wheel or the center console controls. However, their functions are similar—pressing the menu button opens the corresponding menu. For example, each press of the menu button on the multifunction steering wheel switches the information center on the dashboard to a different menu page, allowing you to make adjustments based on your selection. Functions of various buttons in the car: 1. The SEL button is the menu selection confirmation button, typically found on the multifunction steering wheel; 2. The AC button is the compressor switch, which is the air conditioning cooling switch, as the car's heating system does not require the compressor; 3. MUTE is the mute button, allowing you to mute with a single press; 4. MODE is the mode switch button.
5
5
Share

What are the symptoms of a motorcycle generator failure?

When a motorcycle's generator is damaged, the battery warning light on the dashboard will remain lit after the engine starts, indicating that the battery is still supplying power even after the engine is running. In this case, the generator is neither generating nor supplying electricity. If this occurs, it is recommended to repair the engine immediately. A simple test method is to disconnect the negative terminal of the battery, start the motorcycle engine, and turn on the headlight to see if it lights up. If it does not light up, it indicates that the generator is not functioning properly and cannot generate electricity. If the motorcycle generator is not generating sufficient power, the main components to inspect are the magneto coil, rectifier-regulator, and connecting wires. During troubleshooting, focus primarily on the electrical components, then carefully examine the connecting wires to identify and resolve the issue. Magneto Coil: The magneto is the primary power source for any vehicle. When the vehicle fails to generate electricity, the magneto coil should be the first component considered, as it is the source of current generation. Therefore, it is the first item to check. Rectifier-Regulator: The current generated by the magneto can only flow to the vehicle's electrical devices through the rectifier-regulator. In practical repairs, this component has a relatively high probability of failure. Connecting Wires: These are the conductors through which current flows. Issues such as short circuits, open circuits, or poor connections can lead to inadequate power generation.
16
3
Share

How to Reset the Wrench Light on a 2021 Honda CR-V?

First, ensure the CR-V's power is in ON mode. Repeatedly press the display button until "Maintenance" appears on the screen. Then, the engine oil monitor will appear on the display. Press and hold the Enter button for approximately 10 seconds to complete the maintenance light reset.
16
0
Share

Detailed Explanation on How to Use the Buick Velite6 Charging Station

Open the fast charging port and directly use the DC charging station for charging. In addition, you can also use the 8A portable charger provided with the car purchase to plug into a 220V household socket for charging. The charging power is approximately 1.6KW, which means it charges 1.6 kWh per hour.
8
5
Share

How to Determine if a Car's Air Conditioning is Low on Refrigerant

Methods to determine if a car's air conditioning is low on refrigerant: 1. After turning on the air conditioning normally for a period of time, if the air blowing on you feels cool and quickly reaches the set temperature, and the system cycles on and off intermittently, this indicates normal operation. Otherwise, refrigerant may be needed; 2. Use a thermometer to measure the temperature difference between the air inlet and outlet of the indoor unit. A difference of more than 8 degrees is normal, indicating better air conditioning performance (can reach around 15 degrees). If the difference is less than 8 degrees, refrigerant may need to be added; 3. After running for more than ten minutes, open the panel of the indoor unit. You should see the copper tubes of the evaporator covered with aluminum fins for heat exchange, evenly covered with condensation water (this is normal - more when air humidity is high, less otherwise). If only half is covered, it may indicate a refrigerant shortage.
14
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.