Why is the tire pressure of the left front tire lower than the other three?

1 Answers
CharlieLynn
07/30/25 8:09am
It may be due to a slow leak in the underinflated tire, causing the pressure to naturally decrease over time. Alternatively, the tire might have been punctured by a nail, leading to air leakage. When low tire pressure is detected, it should be promptly inspected and repaired or replaced to prevent safety hazards. What to do if the tire pressure is insufficient: If no visible damage is found, simply inflate the tire to the normal pressure and reset the tire pressure system. If a puncture is discovered during inspection, drive to a tire shop immediately for repair, then reinflate the tire. If the tire pressure warning reappears after inflation but there is no puncture, it might be due to a leaking rim caused by deformation. In this case, check the rim and consider replacing it. According to the international GBT2978-2008 standard, the recommended tire pressures are as follows: Standard tires: 2.4-2.5bar; Reinforced tires: 2.8-2.9bar; Maximum pressure should not exceed 3.5bar.
Was this review help?
14
5
Share
More Forum Discussions

How to Use the Gear Positions on the Land Cruiser Prado?

The gear shift lever is located in the center of the cabin. The topmost position is the P (Park) gear, which is used for parking. The R (Reverse) gear is for backing up; engage this gear when reversing. Shifting into the N (Neutral) gear puts the vehicle in neutral, which can be used for short stops.
10
1
Share

What is the detailed explanation of automotive engine oil grades?

Automotive engine oil grades can be explained through the following aspects: W: 15W-40, 5W-40 - The 'W' stands for Winter. The smaller the number before W, the better the oil's low-temperature fluidity and engine protection capability. The number after W: The number following W represents the oil's kinematic viscosity at 100°C. A higher number indicates higher viscosity. 40: 40 indicates that the kinematic viscosity standard at 100°C is between 12.5mm2/s and 16.3mm2/s.
15
2
Share

How to Remove the Speed Limit on Xinri Electric Bikes?

First, the method to remove the speed limit on Xinri electric bikes is the same for all models. Hold the brake with your left hand. Finally, turn the throttle a few times with your right hand to remove the speed limit. This method is both discreet and convenient, allowing you to successfully remove the speed restriction on Xinri bikes.
2
3
Share

What are the six steps when first getting into the car for Subject 3?

Before getting into the car, walk around the vehicle to inspect tire pressure and ensure everything is normal. After confirming safety, open the door and enter the cockpit. Adjust the seat to a suitable position, sit upright, and place both hands straight on the steering wheel. Adjust the interior and exterior rearview mirrors. Fasten the seatbelt. Check the handbrake and ensure the gear is in neutral.
10
0
Share

How to Use the Cadillac Factory-installed Dash Cam?

Scroll down to select the menu bar or switch between front and rear cameras. Scroll up to select the menu bar or switch between front and rear cameras. Press and hold to return to the main menu. After selecting an option, press the OK button to confirm your choice. You can switch between video or playback modes, or toggle between normal mode and snapshot mode.
5
5
Share

Do new tires require wheel balancing?

Wheel balancing is essential when installing new tires or after any tire disassembly and reassembly. Due to manufacturing variations, new tires may not have perfectly uniform mass distribution. When the vehicle reaches high speeds, this imbalance in wheel rotation can compromise driving safety. The hazards of skipping wheel balancing include: 1. Regular tire hopping during driving, causing steering wheel vibration. 2. Vehicle resonance occurring at specific speed ranges. 3. Long-term uneven tire wear, affecting tire lifespan and driving safety. 4. In severe cases, potential damage to suspension components and bearings.
7
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.