Why is the tire pressure low in a new car?

2 Answers
LukeAnn
07/29/25 4:56am
New cars may experience low tire pressure due to the following reasons: The vehicle has been parked for an extended period, causing the tire pressure to decrease. When a car leaves the factory, the tire pressure is typically set closer to the upper limit of the safe range. However, as the car remains stationary over time, the tire pressure will naturally drop. Some manufacturers intentionally lower the tire pressure to prevent excessively high speeds. Since it's a new car, even experienced drivers need an adaptation period. During this time, reducing the tire pressure slightly helps prevent potential traffic hazards caused by high speeds. Tire damage. Although rare in new cars, it's not impossible. There might be an issue with the tires from the factory, or the tires could have been punctured during use. When the low tire pressure warning activates in a new car, it's essential to thoroughly inspect the tires for any damage. Reasons for abnormal tire pressure: Generally, the system will issue a warning if the pressure falls below 1.8 bar or exceeds 3.0 bar. In such cases, tire inspection and pressure adjustment are necessary. The tire pressure monitoring system hasn't been reset. After inflating the tires, if the tire pressure reset isn't performed promptly, the monitoring system will continue to display the previous data, causing the tire pressure warning light to illuminate. Simply performing a tire pressure reset will resolve this issue. Damaged tire pressure sensor. The tire pressure sensor, which monitors tire pressure, is installed inside the tire and connected to the inflation valve. If the sensor is damaged during driving (e.g., by hitting a curb), it can trigger the tire pressure warning light. In case of sensor damage, the only solution is to replace it with a new one.
Was this review help?
6
2
Share
AdalineDella
08/12/25 8:35am
I noticed low tire pressure shortly after buying my new car. This is usually caused by incorrect factory settings, as the pressure naturally decreases over time during transportation from the factory. It could also be due to significant temperature changes after parking, where thermal expansion and contraction lowers the pressure. Check the label on the door frame for the recommended tire pressure, use a portable gauge to measure it, and if it's low, fill up at a gas station. Long-term low tire pressure is dangerous—it makes driving unstable, increases the risk of blowouts, accelerates tire wear, and wastes fuel. Developing a habit of checking tire pressure monthly can save a lot of hassle. After getting a new car, a full inspection, including tire pressure, is essential to ensure road safety.
Was this review help?
19
2
Share
Expand All
More Forum Discussions

Why does the Civic have high RPM at startup?

The elevated RPM when starting a Civic is a normal phenomenon. During a cold start, the vehicle requires higher RPM to allow the engine to quickly reach normal operating conditions, necessitating a richer air-fuel mixture. Consequently, both the intake air volume and fuel injection quantity are increased, leading to higher RPM. Once the engine attains normal operating conditions, the RPM will decrease to the normal range. Relevant explanations regarding high RPM are as follows: Reasons for high startup RPM: In a cold state, the vehicle needs to bring the engine into its normal working environment as quickly as possible after startup. Therefore, during a cold start, the engine's computer automatically increases fuel injection, burning more fuel than during normal idling to rapidly raise the engine's coolant temperature and allow the engine to quickly reach the appropriate operating temperature. This primarily manifests as higher engine idle speed when the engine is cold. Engine air intake volume: Under normal circumstances, the engine's air intake volume must be strictly regulated. If abnormalities occur in the intake system, throttle body, air flow meter, or idle control valve, it can cause unstable engine idling. If the fuel injectors become clogged, it can also lead to reduced engine power and unstable idling.
3
0
Share

How to reset the maintenance light on Audi Q3 dashboard?

Audi Q3 dashboard maintenance light reset method is as follows: 1. Turn off the ignition switch, shut down the engine, and press and hold the right button "0.0" (reset) on the dashboard with your left hand. 2. While continuing to hold the right button "0.0" (reset) with your left hand, turn on the ignition switch. When "SERVICE" appears on the dashboard display, release the right button "0.0". 3. Press the left button "SET" (setting) within 20 seconds to reset. When "SERVICE-IN-10000MI" appears on the dashboard display, it indicates the reset is complete.
1
1
Share

How long is the warranty period for the Geely Binyue?

Geely Binyue offers a whole vehicle warranty of 4 years or 100,000 kilometers. Below is some information about the Geely Binyue: 1. As the first SUV model based on the BMA architecture, the Binyue is equipped with a 1.5T three-cylinder engine jointly developed by Geely and Volvo, delivering a maximum power of 177 horsepower and a peak torque of 255N·m. It is paired with a 7-speed wet dual-clutch transmission, achieving a 0-100km/h acceleration time of just 7.9 seconds. 2. The Geely Binyue is positioned as a compact SUV with a more youthful overall design and is equipped with L2 autonomous driving assistance technology.
10
3
Share

How to Replace the Cabin Air Filter of Besturn B50?

The method for replacing the cabin air filter of Besturn B50 is as follows: 1. The cabin air filter of Besturn B50 is located inside the glove compartment on the front passenger side. 2. Open the glove box, grasp both ends with both hands, lift it upwards forcefully to remove the glove box. The cabin air filter is inside. Remove the cover plate to see the cabin air filter, pull out the old filter, and insert the new one, paying attention to the correct orientation. Below is a brief introduction to the functions of the cabin air filter: 1. A high-quality cabin air filter can absorb dust particles, alleviate respiratory discomfort, and reduce irritation for allergy sufferers. 2. It enhances driving comfort and also protects the air conditioning cooling system.
7
3
Share

Which country does Citroën belong to?

Citroën is a French automobile brand. Here is some information about Citroën: 1. It is a joint venture brand under Dongfeng Motor Group, and in China, it is known as Dongfeng Citroën due to the partnership with Dongfeng Group. Dongfeng Motor Corporation was established in 1969 and is a key player in China's automotive industry, having undergone years of development. 2. Founded in 1915 by André Citroën, Citroën's headquarters are located in Paris, France. 3. Dongfeng Citroën is a major joint venture brand in China between Dongfeng Motor Corporation, one of China's largest automobile companies, and the French PSA Group.
12
4
Share

Which engine is used in the MG6?

The engine used in the MG6 is a 1.5T turbocharged engine, with the engine model being SGE20T. Below is some information about the MG6: 1. The MG6 is a mid-size car designed to meet the needs of global market consumers, catering to the demands of young and energetic individuals. 2. The new MG6 will be equipped with a 1.5T turbocharged engine, model SGE20T, which is domestically produced. It delivers a maximum power of 169 horsepower and a peak torque of 250 Nm, paired with a 7-speed dual-clutch transmission.
14
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.