Why is the Ora charging pile flashing red?

1 Answers
HarrisonRose
07/30/25 4:07am
Red light flashing is a prompt due to poor network signal, but it does not affect charging. The following are the installation instructions for the Great Wall Ora charging pile: 1. Classification: Charging piles are generally divided into two types based on their ownership: public piles and private piles. Public piles are universal but require payment for electricity and service fees, making the cost relatively high; private piles are only suitable for one's own vehicle and are not universal. 2. Scope of application: When using a public charging pile, make sure to check whether it is suitable for large vehicles or small vehicles, as some old standard piles cannot charge small vehicles, and vice versa. 3. Inspection: Before charging, check that the charging pile equipment is intact, the cables and connectors are in good condition. On rainy days, it is best not to use the charging pile outdoors without a canopy to prevent the risk of electric leakage. After charging is completed, disconnect the charging pile in time to prevent overcharging.
Was this review help?
11
4
Share
More Forum Discussions

Why won't my Kia K5 start?

Reasons why the Kia K5 won't start: 1. Low fuel level or fuel gauge showing below the red line; 2. Faulty sensor shared by the ignition system and fuel injection system; 3. Burned-out power supply cable from the battery or damaged starter relay; 4. Excessive carbon buildup causing valve leakage, engine misfire, and poor acceleration. Correct starting procedure for the Kia K5: 1. Insert the car key into the ignition switch and turn it up one notch, pause briefly to allow the fuel pump to activate and for the fuel supply and electrical systems to self-check; 2. Ensure the gear shift is in the neutral position and depress the clutch pedal; 3. Turn the key further upward until you hear the engine start, then release the key; 4. Once the dashboard lights up, release the clutch pedal with your left foot according to proper technique while moderately pressing the accelerator pedal to allow the vehicle to start smoothly.
8
5
Share

Can the Chery Ant Submerge in Rainy Days?

The extent to which the Chery Ant can submerge depends on its wading depth. The maximum wading depth of the Chery Ant is approximately 135mm. The wading depth of the Chery Ant is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, off-road vehicles and SUVs have obvious advantages. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Chery Ant is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before the vehicle enters the water, always turn off the automatic start-stop function to prevent the engine from restarting automatically after stalling in the water, which could cause severe damage due to water intake; Judge the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration; On roads prone to waterlogging, observe warning water level markers, trees, and reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed; Know your vehicle's safe wading depth. If the water depth exceeds half of the tire height or the engine's air intake, do not enter the water recklessly; choose an alternative route instead.
6
5
Share

What are the differences between Toyota Land Cruiser and Prado?

Toyota Land Cruiser and Prado differences: 1. Different appearance: The front grille of the Toyota Land Cruiser is horizontal; the front grille of the Prado is vertical. 2. Different performance: The Toyota Land Cruiser has stronger off-road performance, better adaptability, and a more stable chassis, with no feeling of floating even at 130km/h; the Prado's chassis is less stable, exhibiting floating phenomena at high speeds. 3. Different displacements: The Toyota Land Cruiser comes with three displacement options: 4.0L, 4.6L, and 5.0L; the Prado has two displacement options: 2.7L and 4.0L. 4. Different dimensions: The Toyota Land Cruiser measures 5080mm in length, 1940mm in width, and 1900mm in height, with a wheelbase of 2850mm; the Prado measures 4760mm in length, 1885mm in width, and 1845mm in height, with a wheelbase of 2790mm.
13
0
Share

What to Do When the Wrangler Key is Locked in the Car?

Solutions for when the Wrangler key is locked in the car: You can use the spare key to open it. If the spare key is far away or cannot be found, then you will have to call a professional locksmith to unlock the car. Typically, you will need to provide proof of ownership, such as an ID card or vehicle registration. The Wrangler is a Chrysler Jeep model, and it is the top-tier version of the Chrysler Jeep Wrangler series. The Wrangler is one of the toughest models in the Jeep lineup, a true off-road vehicle. The Wrangler Rubicon is distinguished by its off-road performance integration, which enhances its rugged capabilities, features that were previously only available through aftermarket parts and high-performance modifications.
6
1
Share

How to test if ETC is working?

Methods to test if ETC is working: First, remove the card and insert the chip-side of the card into the electronic tag. When you hear a "beep" sound and the electronic tag screen displays "Debit Card" or "Balance," it means the system is functioning normally. If the ETC card is inserted into the electronic tag but the screen shows messages like "Electronic Tag Invalid" or "No Card Inserted," it indicates an issue with the electronic tag, and you need to visit an ETC service center to reactivate and reinstall it. ETC (Electronic Toll Collection) is a system that allows for non-stop toll payments. ETC lanes are dedicated to vehicles equipped with ETC onboard units, using electronic payment methods without manual toll booths. The ETC system works through microwave-based short-range communication between the onboard electronic tag installed on the vehicle's windshield and the microwave antenna in the ETC lane at toll stations. This data is then processed via computer network technology for backend settlement with banks, enabling vehicles to pass through toll stations without stopping to pay bridge or road fees.
16
5
Share

What do Volvo's T3, T4, and T5 mean?

Volvo's T3, T4, and T5 refer to different types of engines. Here are the details: Introduction to Volvo T3, T4, and T5 engines: T3 represents a 1.5T turbocharged engine, T4 represents a 2.0T low-power version turbocharged engine, and T5 represents a 2.0T high-power version engine. Additionally, in Volvo's lineup, T6 stands for a turbo + supercharged dual-charged engine, and T8 represents a 2.0T hybrid version. Differences in power among Volvo engines: T3 is a 1.5T three-cylinder engine with a maximum power of 120KW and a maximum torque of 265N·m. T4 is a 2.0T inline 4-cylinder engine with a maximum power of 140KW and a maximum torque of 300N·m. T5 is also a 2.0T inline 4-cylinder engine, but with a maximum power of 185KW and a maximum torque of 350N·m.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.