Why is the Lavida's dashboard not illuminated during the day?
5 Answers
The reason why the Lavida's dashboard is not illuminated during the day: Because the brightness of the Lavida's dashboard lights is automatically adjusted, it is a light-sensing dashboard. The dashboard lights turning off is a reminder for the owner to turn on the headlights. Below is some relevant information about the Lavida: 1. In terms of power: The Shanghai Volkswagen LAVIDA Lavida uses a 1.6L engine derived from the Polo and a 2.0L naturally aspirated engine from Volkswagen's new engine platform. Its performance is much more advanced than the old 2.0 engine used in the Passat. 2. In terms of configuration: It adopts a three-spoke sports steering wheel. In high-end models, side airbags, a sunroof, perforated leather seats, a reverse radar, a Bluetooth system, and a luxury audio system with MP3 function are all equipped.
This issue is quite common. If the dashboard lights don't illuminate during daytime, the most likely causes are either the brightness setting being too low or a faulty light sensor. The Lavida's dashboard has an auto-adjust feature with the sensor located near the windshield. If it's covered by dust or dirt, the system may mistakenly think there's sufficient ambient light and won't activate the dashboard illumination. Other possible causes include a blown fuse (usually found in the fuse box under the driver's seat - refer to the manual for numbering), which would cut off power supply. Poor wiring harness connections could also be the culprit, as aging may cause looseness and poor contact. I recommend first trying to manually adjust the brightness knob. If that doesn't work, clean the sensor - a handy trick is to gently wipe the small protruding area at the base of the windshield with a soft cloth. If the problem persists, don't delay; visit a repair shop promptly to check the battery or control modules to ensure nighttime driving safety. During regular maintenance, have technicians inspect the dashboard system as preventive care. This can save you significant trouble down the road.
My own Lavida car also experienced the dashboard lights not turning on during the day, making it hard to see the speed and fuel gauge while driving, which was quite dangerous. Possible reasons could be the dashboard being set to low brightness mode or the sensor not being calibrated properly. I found out from forums that Lavida's automatic brightness system sometimes malfunctions—the sensor is located in the corner of the windshield and can misjudge light if it's dirty or blocked by window tint. Another common issue is blown fuses, especially after driving on bumpy roads where the wiring gets jostled. From personal experience, first try adjusting to maximum brightness; if that doesn’t work, check the fuse box yourself—the manual has a location diagram. After solving the issue, I felt like I saved on repair costs, but for serious cases, it’s recommended to have a professional shop inspect the wiring and connectors for safety. Preventive measures include regularly cleaning the sensor to avoid dust buildup affecting its sensitivity.
The dashboard not lighting up during the day is likely due to a setting issue or sensor malfunction. The Lavida's lighting system automatically adjusts based on ambient light, with a sensor at the front detecting light intensity—if dirty, it may assume sufficient brightness and keep lights off. Other possibilities include the knob being set too low, a blown fuse cutting off power, or module aging/failure. A simple fix is restarting the car to reset defaults, then manually adjusting brightness to test. If needed, inspect the fuse box and replace any blown fuses. Don't delay addressing this, as nighttime driving could become hazardous. Prompt action is crucial.
I found that when the Lavida dashboard doesn't light up during the day, usually check three points: whether the brightness adjustment knob is set to the lowest setting, try manually increasing it; whether the light sensor is obstructed or affected by dirt, clean it to ensure the sensing area is clear; and whether the fuse is blown, open the car's fuse box to find the corresponding label and replace it. Additionally, poor contact in the wiring harness could be the issue, aging or loosening may require reconnection. If unresolved, go to a professional shop to use equipment to test voltage and module status, don't tamper with it yourself to prevent short circuits. Safe driving comes first, fix any issues early.
