···
Log in / Register

Why is the fuel consumption of the Sylphy getting higher and higher?

4 Answers
McLiam
07/29/25 6:06pm
Here are the specific reasons why the fuel consumption of the Sylphy is increasing: 1. Affected by temperature: Temperature changes can cause fluctuations in fuel consumption. In winter, lower temperatures generally lead to higher fuel consumption. 2. Long-term lack of vehicle maintenance: Dirty engine oil and air filters can also increase fuel consumption. Dirty oil leads to poor lubrication, increasing resistance in the engine's moving parts, which requires more energy to overcome, thereby raising fuel consumption. 3. Insufficient tire pressure: Low tire pressure increases the contact area between the tires and the ground, resulting in greater friction and driving resistance, which in turn increases fuel consumption. 4. Excessive carbon buildup in the vehicle: Carbon deposits commonly accumulate in the throttle body, fuel injectors, intake manifold, and piston tops. Excessive carbon buildup in any of these areas can lead to incomplete combustion, thereby increasing fuel consumption.
Was this review help?
7
1
Share
Deborah
08/14/25 10:19am
As a seasoned owner of a Nissan Sylphy, I certainly have a say. After driving 80,000 kilometers, I noticed the pedal feel wasn't quite right anymore, and fuel consumption had increased significantly. First and foremost is tire pressure – insufficient air in the tires is like running in soft-soled shoes; it's extra laborious. Secondly, there's carbon buildup, especially in direct injection engines, where sticky deposits accumulate on the fuel injectors and intake ports, making fuel injection less smooth. Then there's engine oil – if you overfill it or use oil with too high a viscosity, the engine works harder and naturally consumes more fuel. Oh, and the air filter is like a mask; when it gets clogged over time and restricts airflow, that can also drive up fuel consumption. Finally, driving habits matter – frequent hard acceleration and sudden braking without restraint will definitely burn through more fuel.
Was this review help?
10
1
Share
Expand All
AbelAnn
10/14/25 4:08am
I've been repairing Nissan cars for ten years, and increased fuel consumption in older Sylphy models is a common issue. First, check how many kilometers your car has run. For high-mileage vehicles, focus on exhaust components like the catalytic converter and oxygen sensors—inaccurate data from these can lead to imprecise fuel injection. Also, inspect the battery voltage, as low voltage can affect the engine control unit's commands to the fuel injectors. Worn or improperly gapped spark plugs reduce ignition efficiency, causing incomplete combustion and higher fuel consumption. A dirty or faulty mass airflow sensor is even more problematic, as it can misreport air intake and prompt the ECU to inject more fuel. Additionally, don't overlook the brake calipers; if they're slightly stuck or dragging, the extra effort required from the tires will directly increase fuel consumption.
Was this review help?
12
0
Share
Expand All
MacMackenzie
11/27/25 5:04am
I drive a 2022 Sylphy and found three main factors affecting fuel consumption. First is the AC—now that it's hot, I use the cold air daily, increasing compressor load, so the engine has to work harder and consume more fuel. Then there are the tires; if you notice higher fuel usage, squat down and check the rims—you might find a nail slowly leaking air. Gas quality matters too; I used to fill up at cheaper stations and noticed less power and higher consumption, but switching to better-quality gas actually improved mileage. Lastly, driving conditions—with daily traffic jams and constant braking, it's normal to see 8-9 L/100km on the gauge.
Was this review help?
16
2
Share
Expand All
More Forum Discussions

How many seconds does the Kawasaki H2 take to accelerate from 0 to 100 km/h?

The Kawasaki H2's 0-100 km/h acceleration time is approximately 2.8 seconds, with a top speed reaching 300 km/h. Acceleration performance is determined by torque: Torque, also known as rotational force, is the moment that causes an axis to rotate. The common unit for torque is kg-m (with Nm being the international unit). When driving torque remains constant, the force generated decreases as the distance from the rotation center increases. Kawasaki H2 engine: The Kawasaki H2 is powered by an inline four-cylinder liquid-cooled engine equipped with a supercharger. This engine has a displacement of 998cc, features four valves per cylinder, and delivers a maximum horsepower output of 200 hp.
17
3
Share

Is it safe to drive through accumulated water on rainy days?

Driving through accumulated water on rainy days is generally safe as long as the water depth does not exceed the air intake. To successfully navigate through waterlogged sections, the following points must be noted: 1. Do not recklessly drive through water: When a car is driving through water, the buoyancy of the water and the impact of the current reduce the adhesion of the wheels, making the vehicle less stable and prone to skidding or sliding. If the water is deep, electrical equipment is susceptible to short circuits, and the engine is at risk of water ingress. Therefore, it is essential to carefully assess the depth, flow rate, and condition of the road beneath the water before attempting to drive through. 2. Understand your vehicle's safe wading depth: The water depth must never exceed the height of the engine's air intake, and you should also consider whether the height of the waves could surpass the air intake position (for most small cars, the engine air intake is located on the side of the air filter, above the front bumper, or above the intake grille). Additionally, consider whether water could enter the cabin. If the water depth exceeds the lower edge of the door, water can seep in through poorly sealed areas. Once water enters the cabin, the floor materials, which are highly absorbent, will require removal for drying or baking to dry out completely. Moreover, the electrical components beneath the floor are also prone to damage.
6
1
Share

What is the CSM automotive module in General Motors vehicles?

General Motors' CSM automotive module is a bus measurement module and data logger. The brands under General Motors include: Buick, Chevrolet, Cadillac, GMC, Wuling, Baojun, and Holden, among others. Taking the 2021 Buick Excelle as an example, its body dimensions are: 4609mm in length, 1798mm in width, and 1464mm in height, with a wheelbase of 2640mm. The 2021 Buick Excelle is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 113PS, a maximum power of 83kW, and a maximum torque of 141Nm, paired with a 6-speed automatic transmission.
13
2
Share

What is the fuel tank capacity of the old Lavida?

2016 old Lavida has only 1 model, with a fuel tank capacity of 55 liters. The vehicle is equipped with a 1.4T turbocharged engine, and all models use a 7-speed dry dual-clutch transmission (DCT). Among the same class of vehicles, the 2022 Civic has a fuel tank capacity of 47 liters, the 2021 Xingrui has a fuel tank capacity of 50 liters, and the 2021 Corolla has a fuel tank capacity of 50 liters. During the actual refueling process, the amount of fuel may exceed the marked capacity. This is because the fuel tank capacity marked by the car manufacturer is from the bottom of the tank to the safety limit, and there is still some space from the safety limit to the tank opening. This space is to ensure that the fuel in the tank can expand when the temperature rises without overflowing the tank's safety space. If the fuel is filled to the tank opening during refueling, the actual refueling amount will be larger than the marked fuel tank capacity. If the owner wants to know the remaining fuel in the tank, they can observe the fuel gauge on the right side of the dashboard, which is marked with E and F. When the pointer is close to E, it means the fuel is almost empty, and when it is close to F, it means the fuel is sufficient.
17
4
Share

How to Adjust the Insufficient Brightness of Tayron's Headlights?

Tayron's headlight brightness can be adjusted by following these steps: 1. Start the power and turn on the central control display; 2. Click on settings to enter the settings options; 3. Select the lighting settings to adjust. Taking the 2020 Tayron 2WD Comfort Smart Edition as an example, its body dimensions are: 4589mm in length, 1860mm in width, and 1660mm in height, with a wheelbase of 2731mm. The 2020 Tayron 2WD Comfort Smart Edition is equipped with a 1.4L turbocharged engine, delivering a maximum horsepower of 150PS, a maximum power of 110kW, and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
2
5
Share

What is the background of XPeng Motors?

XPeng Motors is an emerging brand, founded in 2014 and headquartered in Guangzhou. It is an internet electric vehicle brand under Guangzhou Xiaopeng Motors Technology Co., Ltd. XPeng Motors system introduction: XPeng Motors' pure electric drive system is centered around the motor, battery, and electronic control. The initial version of XPeng Motors' motor achieves a power density of 10kw/L, which is more than double the domestic average level. XPeng Motors battery aspects: XPeng Motors' battery pack has undergone four iterations of development, with an energy density approaching 150Wh/kg. Unlike most domestic electric vehicle battery packs that use natural cooling or air cooling, XPeng Motors has designed a liquid-cooled battery pack. After exposure tests, it can output over 200kW while keeping the temperature rise within 10 degrees, effectively solving the issue of battery temperature rise. This pure electric drive system has undergone bench tests, dynamometer tests, and proving ground road tests, accumulating over 5,000 kilometers of testing mileage.
20
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.