Why is the Bora's fuel consumption high?

2 Answers
TeaganLynn
09/08/25 2:12am
Bora's high fuel consumption can be attributed to the following specific reasons: Tire factors: If the tire pressure is insufficient, fuel consumption will increase. If the tire pressure is normal, then check the degree of tire wear. When tires are severely worn, they often show signs of slipping, which also increases fuel consumption. Excessive engine carbon deposits: If there is a significant amount of carbon buildup in the engine over a short period, it can also lead to higher fuel consumption. This situation is likely caused by the use of substandard fuel. The solution is to add a certain amount of cleaner when refueling. If the effect is not noticeable, it indicates a large amount of carbon deposits in the engine. In this case, it is best to take the car to a 4S shop or repair shop, where technicians can clean the carbon deposits inside the engine. Oxygen sensor damage: As an internal control unit of the car, the oxygen sensor primarily monitors the fuel-air ratio in the engine. Once it is damaged, it will cause an imbalance in the engine's fuel-air ratio, inevitably leading to abnormally high fuel consumption.
Was this review help?
14
0
Share
AaronRose
09/19/25 7:55am
I've been driving my Volkswagen Bora for several years, and I've noticed that sudden increases in fuel consumption are often caused by driving habits—frequent rapid acceleration or hard braking burns fuel quickly. Maintaining a steady speed of 80 km/h on the highway is the most fuel-efficient, while frequent stop-and-go traffic in the city can push the average fuel consumption up to 10L/100km. Carrying heavy loads or adding a roof rack increases wind resistance and also consumes more fuel. I usually monitor the instant fuel consumption display and plan routes to avoid peak hours. High fuel consumption not only costs more money but also increases exhaust emissions, harming the environment. Switching to an eco-driving mode makes the Bora both economical and eco-friendly. Changing these habits can save enough fuel money for several short trips. Additionally, checking tire pressure is important—underinflated tires can increase fuel consumption by 5-10%, so regular inflation is a small but effective trick.
Was this review help?
2
1
Share
Expand All
More Forum Discussions

Can You Drive with One Cylinder Broken in the Engine?

You cannot drive with a broken cylinder in the engine. Engine Misfire: Engine misfire refers to a situation where the engine fails to generate sufficient power due to a malfunction, resulting in a lack of power, with one or more cylinders not working properly. An engine misfire can shorten the lubrication oil's service life, easily cause sudden stalling, increase fuel consumption, emit black smoke, and reduce power. When a misfire occurs, one or more cylinders fail to operate normally. Common symptoms include abnormal engine operation or insufficient power, uneven engine performance and rhythmic shaking at high, medium, and low speeds, and the muffler emitting black smoke and backfiring. Causes of Misfire: Driving with one less cylinder is not advisable. The primary causes of engine misfire stem from issues in the ignition system and fuel injection system, which can lead to reduced vehicle power. During idling, the power may fluctuate unpredictably. Effects of Engine Misfire: An engine misfire can result in insufficient power, making the engine prone to stalling during operation. It may also lead to increased fuel consumption. In idle conditions, the engine may exhibit severe vibration.
3
1
Share

How many kilowatt-hours of electricity are needed to charge a small electric vehicle?

A small electric vehicle with a 48V-20AH battery typically requires about 1.08 kilowatt-hours of electricity for a full charge after complete discharge. Related knowledge: The amount of electricity charged into an electric vehicle battery is generally 1.05 times the battery's discharge capacity. The electricity consumption is calculated based on the charging voltage, which equals the charging voltage multiplied by the battery's rated capacity and then by 1.05. The calculation process is as follows: The required charging amount equals 20 multiplied by 1.05, which is 21AH. The electricity consumption equals 21 multiplied by 51.6 (average charging voltage), resulting in 1083.6WH. Since 1 kilowatt-hour equals 1000WH, a full charge requires approximately 1.08 kilowatt-hours. The charging time is between 8 to 10 hours, meaning the electricity consumption per hour of charging is between 0.1 to 0.14 kilowatt-hours. Electric vehicles do not require frequent charging: Electric vehicles do not need to be charged frequently, as frequent charging can easily lead to the battery entering the failure period. However, it is still necessary to charge them regularly, but there is no need to charge them every time after riding.
10
1
Share

Can a Motorcycle License Renewal Be Handled by an Agent?

Motorcycle license renewal can be handled by an agent. After the motorcycle license expires, simply bring the license, ID card, and two white-background ID photos to the local vehicle management office where the license was issued to apply for renewal. The renewal process is relatively simple: register at the relevant window, undergo an on-site medical examination, pay the fee, then submit the registration form, medical examination form, and photos at the renewal window before queuing to receive the new license. Motorcycle Inspection: Motorcycles must be inspected every 2 years within the first 4 years; after 4 years, they must be inspected annually. Additionally, motorcycle licenses do not require annual review. Since May 1, 2004, annual license reviews have been abolished, with renewal required every 6 years (check the expiration date on the license for the renewal deadline). License Renewal: Currently, license renewal cannot be processed online. According to regulations, the driver must apply for renewal at the vehicle management office where the license was issued or another authorized office within 90 days before the expiration date. License Validity Period: Motorcycle licenses are reviewed upon renewal when the validity period expires. Motorcycle licenses are valid for 6 years, 10 years, or indefinitely. If the validity period is 6 years, review is required every 6 years; if it is 10 years, review is required every 10 years; if it is indefinite, no review is needed.
15
5
Share

Why Won't the Car Start After Installing a New Battery?

If a car with a newly replaced battery won't start, it could be due to a discharge fault in the vehicle's electrical circuit or poor battery charging. If the charging is normal but the new battery runs out of power within a few days, there might be a self-discharge issue in the circuit, which requires checking with a multimeter. If the battery regains power after driving for a while, the charging system is likely fine, and the issue might be a damaged rectifier. Battery: The battery, also known as an accumulator, plays a crucial role in starting the car. If the battery is low on charge or completely dead, the car won't start. Therefore, battery maintenance should not be overlooked during routine car care. The primary functions of the battery are to store and discharge electricity, providing sufficient power for starting the car. If the battery malfunctions, the car may fail to start in cold conditions, and the electricity generated by the alternator during driving won't be stored, potentially leading to symptoms like stalling. Precautions: For optimal performance, the battery should ideally be fully charged. Avoid using the car's electrical systems before starting the engine, as this drains the battery, which may not have fully recharged after starting. If the car consistently operates in a high-power consumption state during driving, not only will the alternator's output be insufficient, but the battery's charge will also be depleted. This can result in insufficient battery power when the car is turned off, especially if the battery itself has issues like reduced capacity or leakage.
10
0
Share

Where is the fuel pump fuse located in the Jinbei Haise?

The fuel pump fuse of the Jinbei Haise is located in the front compartment fuse box. Below is relevant information about automotive fuses: 1. Classification: Automotive fuses can be divided into blade-type fuses, glass tube fuses, and bolt-type fuses. Blade-type fuses are categorized by size into large, medium, and small. Glass tube fuses are categorized by size into 5*20mm and 6*30mm. Bolt-type fuses are categorized by size into small and large. 2. Meaning: Automotive fuses are small and inconspicuous components, but they are the most critical parts in a car's electrical circuit. If any electrical equipment fails to operate during vehicle use, it may be due to a blown fuse, which should be replaced promptly.
7
4
Share

Why Won't the Changan Eado Start?

Here are the reasons and solutions for a Changan Eado car failing to start: 1. Insufficient car battery power or low fuel level: Insufficient car battery power or low fuel level is the easiest item to check and the most likely cause of the car not starting. The fuel level is easy to determine. Turn the ignition key to the 'on' position (for push-button start models, press the start button twice without pressing the brake), then turn on the headlights. If the lights noticeably dim or don't turn on at all, and the horn sounds significantly weaker than usual or doesn't sound, it can be determined that the battery power is insufficient. In either of these situations, depending on your circumstances, you can seek help from nearby car owners for emergency measures such as jump-starting, borrowing fuel, or towing. 2. Steering wheel lock preventing startup: The steering wheel lock preventing startup is a common anti-theft feature in many small cars. After removing the key, if the steering wheel is not straightened or is turned, the self-locking function of the steering wheel will activate, causing the steering lock pin to engage with the steering column, making the steering wheel immovable and the car unable to start. The solution is simple: jiggle the steering wheel while turning the key. Otherwise, even if you break the key, it won't turn. 3. Incorrect gear position: Check the car's gear position. Generally, the correct gear positions for starting an automatic transmission car are 'P' or 'N'. If the owner carelessly leaves the gear in 'R' or another position, the result will not only be the car failing to start but also posing a safety hazard.
11
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.