Why is the Anti-Slip Light Always On?
3 Answers
Reasons for the car's anti-slip light being on are as follows: 1. Slippery road conditions causing the ABS system to activate, which is normal for the anti-slip light to illuminate. 2. Malfunction in the ABS pump. 3. Software errors leading to signal transmission issues. 4. Faulty or loose sensor connectors. 5. Short circuits in wiring or related fuse blowouts. Methods to handle skidding are as follows: 1. When the vehicle skids, first steady the steering wheel, adjust the throttle as necessary, and quickly determine the nature of the skid, such as whether it's front-wheel or rear-wheel skidding; whether it's caused by poor road conditions or improper operation like braking or steering. 2. If the skid is due to poor road conditions, 'go with the flow' by steadying the steering wheel (with appropriate deceleration), allowing it to 'sway back and forth,' avoiding sudden steering wheel turns or using the foot brake. Simply persist until driving out of the poor road section, and the skid will disappear. 3. If the skid is caused by braking, immediately release the brake; but if braking is necessary for deceleration due to road conditions, and if the speed is not too high, based on experience, you can decisively press the clutch and cautiously try 'pumping the brake.' 4. If the vehicle skids while steering (turning), this is related to the driver's abrupt steering action and high speed. In such cases, the vehicle skid usually manifests as 'bilateral rear-wheel skid,' which is more dangerous and harder to handle.
A few days ago, the anti-skid light suddenly came on while I was driving and hasn't turned off since, indicating a possible fault in the vehicle's electronic stability system. Common causes include dirty or damaged wheel speed sensors, such as mud and water blocking signal transmission during rainy days, or issues with the control module preventing the system from functioning properly. Driving with this light on is dangerous because the car is prone to skidding and losing control during rain or sharp turns. When I encountered this, I immediately slowed down and pulled over to avoid aggressive maneuvers. It's recommended to regularly inspect these sensors during routine maintenance, clean the areas around the wheels with a cloth, and ensure the system is functioning properly before driving on snowy roads in winter to effectively prevent problems. Safety first—when the light is on, it's best to visit a professional repair shop as soon as possible to diagnose the fault codes with specialized equipment and not delay.
As a car enthusiast, seeing the anti-skid light on actually excites me to DIY some checks. It could be dust accumulation on the wheel speed sensor affecting readings - try removing it with a wrench and cleaning. Or inspect the ESP-related fuses in the fuse box for any blown ones, replacing them with new ones matching the current parameters. Loose wiring connections are also common - reseating and securing them might solve the issue. DIY brings great fun, saves money, and teaches skills, but if ineffective, don't push it - use professional scanners to read error codes like ABS module anomalies. When inspecting wheel wells, be careful not to damage components. Maintain steady speeds and avoid sharp turns in daily driving until fixed for peace of mind.
