Why is only one speaker working in the Qoros 3 audio system?

2 Answers
JudahFitz
07/24/25 12:02am
Qoros 3 audio system only has one speaker working due to incorrect channel settings, a broken power circuit of the speaker, or possibly a damaged speaker. Specific details are as follows: Incorrect channel settings: If only one speaker is working, it may be because the audio channel is set to a specific speaker. Broken power circuit of the speaker: The issue might be with the speaker's power circuit. You can check the circuit to see if it's functioning properly. If it's broken, simply reconnect the circuit. Damaged speaker: A damaged speaker can also cause only one speaker to work, in which case you need to replace it with a new one.
Was this review help?
19
1
Share
JessicaAnn
08/10/25 7:52pm
It's quite common to encounter the issue where only one speaker is working. The most frequent cause is an audio setting problem. In the car's multimedia system sound settings, the left-right balance slider might be shifted to one side, resulting in sound coming from only one speaker. If the settings are correct, then the speaker unit might be burnt out, especially the door speakers, as daily door openings/closings and temperature changes can easily damage the voice coil. First, play high-volume music to identify the problematic speaker, then gently tap it to see if contact is restored. Wiring is another major issue—the speaker wire harness connectors inside the door often bend due to frequent door movements, leading to loose or oxidized connections over time. Try unplugging and reconnecting the door panel connectors to remove dust. A blown fuse can also cause one channel to go silent; check the car’s fuse box for the corresponding audio fuse (labeled with numbers and a position diagram) and replace it with a spare. Uneven sound isn’t just annoying for music—it can also affect navigation and warning alert clarity, increasing driving risks. I recommend not delaying and visiting a professional repair shop soon for a full check of fuses and amplifiers to avoid secondary failures. Make it a habit to check connector tightness every couple of months.
Was this review help?
20
2
Share
Expand All
More Forum Discussions

What are the reasons for the reading light not working?

If the interior reading light is not working, observe whether it gradually dimmed or suddenly went out. Generally, the issue could be with the switch, circuit, or the bulb itself. When the bulb doesn't light up, it's often due to a blown fuse or a faulty battery, so check the wiring of the interior light. More information about car LED headlights is as follows: 1. Introduction: Car headlights, also known as front headlights, are lighting fixtures used to illuminate the road ahead during nighttime driving. They are symmetrically installed on both sides of the front end of the vehicle. 2. Working Principle: LED is an electroluminescent device that uses a solid-state semiconductor chip as the light-emitting material. It emits light directly through photon emission caused by carrier recombination. LED headlights are lighting devices manufactured using LEDs as the light source.
16
5
Share

How to Determine if There is a Problem with the Transmission

Methods to determine if there is a problem with the transmission are as follows: 1. Transmission Jerking Fault Symptoms: During driving, the impact, vibration, and jerking sensation produced when the transmission shifts gears are relatively strong, or there is a feeling of hesitation or jerking during rapid acceleration. Fault Cause: Due to excessively high automatic transmission fluid temperature, stubborn dirt and impurities appear inside the transmission, forming blockages in the valve body, causing the solenoid valve to move poorly and fail to sequentially adjust the oil pressure, leading to transmission jerking. 2. Transmission Noise Fault Symptoms: When the car is idling, driving, or under high-load driving conditions, abnormal noises or even loud noises are heard from the transmission, and there are irregular, dull sounds during gear shifts. Fault Cause: Under prolonged high-temperature conditions, the anti-wear and lubrication performance of the transmission fluid declines, causing wear or severe wear on components such as bearings and gears inside the transmission, or damage to the gear sides. 3. Transmission Slipping Fault Symptoms: While driving, when the accelerator is pressed, the engine can be heard revving (similar to the feeling of pressing the accelerator when the gear is in P or N), but the car does not show a noticeable increase in speed and has poor acceleration; another situation is that the car drives normally on flat roads but lacks power when going uphill, and the engine speed is very high. Fault Cause: The hydraulic fluid level is too high, producing a large number of bubbles when violently stirred by the planetary gear set during operation; the friction plates of the clutch or brake, or the brake band, are excessively worn or burnt.
1
4
Share

What does remote throttle mean?

Remote throttle, as the name suggests, is a throttle used in a relatively distant location (outside the driver's cab), providing a method to control the engine other than the driver's accelerator pedal. Relevant information about idling is as follows: 1. Introduction: Idling is an operating condition of a car, referring to the engine running in neutral gear. The engine speed during idling is called the idling speed. The idling speed can be adjusted by changing the throttle size, etc. Idling means the engine "exerts force without doing work." 2. Driving idling: When the car is in gear, without stepping on the accelerator pedal or releasing the accelerator pedal while driving, maintaining the minimum opening of the throttle, the engine speed is the same as the parking idling speed. This state is called driving idling.
9
0
Share

What is the difference between original tires and non-original tires?

Original refers to the product accessories produced by the original manufacturer, while the secondary manufacturer mainly produces other accessories. The after-sales service guarantee of the original manufacturer is better than that of non-original manufacturers, and the quality is guaranteed. Non-original refers to all accessories produced by other manufacturers, and the quality may have problems, especially inferior accessories. The following points should be noted when purchasing and using tires: 1. When purchasing tires, always check the production date: If the production date is from a long time ago, do not purchase them. Tires are rubber products, and even if they are not used, aging will occur. 2. During daily use, it is necessary to frequently check the tire pressure and whether there is any damage on the tire surface: The sidewall of the tire is relatively fragile, and if it is scratched or punctured, it cannot be repaired. It is recommended that car owners replace their tires every four years, even if the mileage driven within four years is relatively low.
3
5
Share

Why was the Ford EcoSport discontinued?

Ford EcoSport has not been discontinued. Related introduction: Design: To further highlight the sporty style, the newly added 1.5L AT Platinum Sport Edition is equipped with exclusive fashion sport package. The whole vehicle features blackened treatment on multiple parts including headlights, sport grille, window waistline, front and rear bumpers, roof rails, etc., paired with 17-inch sport-style alloy wheels with smoked treatment. Power: The Ford EcoSport offers three powertrain options: 2.0L Duratec direct injection engine, EcoBoost 1.0L turbocharged direct injection engine, and 1.5L Ti-VCT engine, mated with SelectShift™ 6-speed automatic transmission for more precise and smooth power delivery.
2
1
Share

Is the Lynk & Co 03+ AWD?

The Lynk & Co 03 is a four-wheel-drive vehicle. Here is an introduction to the Lynk & Co 03: 1. The Lynk & Co 03+ is equipped with a 2.0-liter turbocharged engine, with the engine code B4204T23. This engine delivers a maximum power of 187 kW and a maximum torque of 350 Nm, with the maximum power achieved at 5,500 rpm and the maximum torque available between 1,800 to 4,800 rpm. 2. This engine features direct fuel injection technology and uses an aluminum alloy cylinder head and block. It is paired with an 8-speed automatic transmission. The front suspension of the car uses a MacPherson independent suspension, while the rear suspension employs a multi-link independent suspension. 3. This is a performance car launched by a domestic brand. The vehicle is equipped with an on-demand all-wheel-drive system. Cars with this system are primarily front-wheel drive under normal conditions, with the rear wheels only receiving power when the front wheels slip. The on-demand AWD system is commonly found in vehicles with front transverse-mounted engines. 4. Lynk & Co is a premium luxury brand under Geely, and all Lynk & Co vehicles are built on the CMA architecture jointly developed by Geely and Volvo. Since its launch, the Lynk & Co brand has garnered significant attention from consumers, with many choosing to purchase Lynk & Co vehicles. The Lynk & Co 03 has also participated in the WTCR competition and achieved notable results.
3
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.