···
Log in / Register

Why is one side wider than the other when reversing into the parking space?

1 Answers
CamilleAnn
09/07/25 5:32am

Always hitting the line when reversing into the parking space, or ending up with one side wider than the other after parking, is actually closely related to vehicle speed and steering wheel control. Maintaining proper speed, controlling the clutch well, and gradually turning the steering wheel while observing through the rearview mirror can help. If you're confident about parking in one go, it's recommended to find the key point for turning the steering wheel. If not, it's better to turn the steering wheel earlier. Additional information: Basically, every Category 2 driving instructor teaches students to complete the operation successfully by observing reference points during instruction. However, since everyone's height and sitting posture are different, some reference points mentioned by the instructor may not be suitable for you.

Was this review help?
15
1
Share
More Forum Discussions

Which Vehicle Models Are Eligible for 6-Year Exemption from Inspection?

Vehicles eligible for exemption from inspection include non-commercial passenger cars and other small or mini passenger vehicles within 6 years, excluding vans and vehicles with 7 or more seats. Below is an introduction to the exemption: 1. Vehicle Inspection Exemption: This means the vehicle is exempt from on-site inspection, but verification of compulsory traffic insurance payment and traffic violation handling must still be conducted regularly at the vehicle management department. 2. Exemption Policy: Privately-owned small cars registered on or after September 1, 2010, are eligible for this exemption policy. Below is extended information about vehicles not eligible for exemption: 1. Exemption Scope: Vehicles with 7 or more seats are not eligible for exemption; vehicles involved in accidents are not eligible for the 6-year exemption. 2. Exemption Policy: New vehicles within the scope that have been involved in accidents causing casualties are not eligible for exemption. 3. Exemption Policy: Vehicles that remain unregistered for a long time are also not eligible for exemption, meaning vehicles that have not completed registration procedures within 4 years from the manufacturing date are not eligible. Taxis, training vehicles, and other commercial vehicles still require annual inspection as per original requirements.
11
2
Share

What does WDR on a dash cam mean?

WDR on a dash cam refers to Wide Dynamic Range mode. When the dash cam is in this mode, it can capture a wider viewing angle and also record darker areas. Additional information: 1. About WDR technology: WDR stands for Wide Dynamic Range. In this mode, the image can distinguish between the brightest and darkest light signal values, allowing clear visibility in both very bright and very dark environments. Generally, WDR technology is used in photography to enhance image quality and resolution. 2. Portable dash cams: Portable dash cams are divided into rearview mirror dash cams and data dash cams. These devices are known for their good concealment, easy installation, detachability, and simplicity of use. Most built-in DVD dash cams are vehicle-specific and can be classified as front-mounted or rear-mounted. Installing these types of dash cams is relatively more challenging.
4
3
Share

What Does Vehicle Safety Inspection Include?

Here is the relevant introduction to vehicle safety inspection content: 1. Exterior: The vehicle's exterior should be clean and free of scratches or damage. The interior should be tidy and well-organized. Doors, rearview mirrors, windshield wipers, and all parts and accessories should be intact, securely fastened, without any defects, and maintain normal technical performance. Required documents, tools, spare tires, and warning signs should all be complete. 2. Lights: All vehicle lights should function properly, be securely installed, and not loosen, get damaged, or lose functionality or change lighting direction due to vehicle vibration. Bulbs should be in good condition without burnout. Light switches should operate smoothly, dashboard indicator lights should function correctly, allowing clear visibility of all dashboard instruments without causing glare. 3. Instruments: Vehicle instruments such as the water temperature gauge, ammeter, fuel gauge, idle speed gauge, speedometer/odometer, and oil pressure gauge should function normally. 4. Engine: The engine should have good power performance, operate smoothly with stable idle speed, and maintain normal oil pressure. The engine should have good starting performance, and the ignition system, fuel system, lubrication system, and cooling system should all function well.
1
2
Share

Can motorcycle penalty points be deducted from a C1 license?

No. Motorcycles require an E-class license, while cars require a C1 license. When handling traffic violations, they cannot be used interchangeably or processed together. The correct license must be used. Motorcycle penalty point standards: 1. Failure to wear a safety helmet as required: When driving a motorcycle, if the driver or passenger fails to wear a safety helmet as required, 2 points will be deducted and a fine of 200 yuan will be imposed. 2. Running a red light: If a motor vehicle fails to comply with traffic signal regulations (running a red light), 3 points will be deducted and a fine of 200 yuan will be imposed. 3. Driving in the opposite direction: If a motor vehicle is driven in the opposite direction, 3 points will be deducted and a fine of 200 yuan will be imposed. 4. Violating prohibition signs: If a motor vehicle violates prohibition sign instructions, 3 points will be deducted and a fine of 200 yuan will be imposed.
13
5
Share

What does third-party liability insurance mean?

Third-party commercial liability insurance refers to the financial responsibility that the insured or their legally permitted drivers must bear for accidental incidents occurring during the use of the insured vehicle, which cause personal injury, death, or direct property damage to a third party. The insurance company is responsible for compensation. Additional details are as follows: 1. Third-party liability insurance: Since the introduction of compulsory traffic insurance, third-party liability insurance has become a non-mandatory insurance that can serve as a supplement to compulsory traffic insurance. In an insurance contract, the insurer is the first party, also known as the first party; the insured or the person causing the harm is the second party, also known as the second party; apart from the insurer and the insured, the victim who suffers personal injury or property loss due to an accident involving the insured vehicle is the third party, also known as the third party. 2. Third-party commercial liability insurance: Also known as third-party liability insurance, most local governments previously listed it as a compulsory insurance. Without purchasing this insurance, motor vehicles could not be registered or undergo annual inspections. After the introduction of compulsory motor vehicle traffic insurance (referred to as compulsory traffic insurance), third-party liability insurance has become a non-mandatory insurance. Because compulsory traffic insurance provides relatively low compensation for third-party property losses and medical expenses, purchasing third-party liability insurance can be considered as a supplement to compulsory traffic insurance.
5
2
Share

How to Add Brake Fluid to a Car?

To add brake fluid to a car: Open the car hood, locate the brake fluid reservoir, and open its cap to add the fluid. Brake fluid, also known as hydraulic brake fluid, is transmitted by the master cylinder to the wheel cylinders during braking. The wheel cylinders then press the brake pads against the brake discs under hydraulic pressure, bringing the car to a stop. The volume of brake fluid changes with temperature, and moisture can enter through the reservoir's vent, dissolving into the fluid and lowering its boiling point. When adding brake fluid, strictly use the type and specification specified by the manufacturer to avoid altering the fluid's performance and damaging the braking components.
14
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.