Why is one side of the car air conditioner cooling while the other side is not?

How many kilowatt-hours does a WM Motor take to fully charge?

WM Motor takes 45.99 kilowatt-hours to fully charge. Charging duration for WM Motor: It can charge approximately 3.3 kilowatt-hours per hour. The time required to charge from 0 to full is 45.99÷3.3=13.9 hours, roughly 13 hours. It is recommended to charge during nighttime rest. How to release the handbrake when the WM Motor's battery is dead: If the battery is dead and the car cannot start, the electronic handbrake will also not function. In this case, first press the brake pedal to prevent the vehicle from moving, then call for assistance. If the handbrake was engaged before the power loss, the brakes will remain locked and not release, preventing the car from rolling. In this situation, find a way to recharge and restart the vehicle.

1

Share

Where is the key sensing area for MG GS?

The emergency key sensing area is located on the inner side of the dashboard or the outer side of the electronic steering lock column. Remote Key: The remote key utilizes the wireless remote control function of the central locking system. This system mainly consists of two parts: the transmitter and the receiver. Other Methods: Locate the key slot inside the car. Many keyless start vehicles also have a keyhole, but it is usually hidden. Typically, the hidden mechanical keyhole is behind the one-touch start button, requiring the plastic button to be pried open to reveal it. If there is no keyhole in the car, you can try the last resort: place the remote key against the one-touch start button and wait a moment. The vehicle will detect the key, allowing you to start the vehicle.

6

3

Share

What is the wading capability of the Model 3?

Tesla Model 3 has a maximum wading depth of approximately 138mm. The wading depth of the Tesla Model 3 is determined by the height of the vehicle's chassis, which is the ground clearance listed in the vehicle's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Tesla Model 3 is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it can cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before the vehicle enters the water, always turn off the auto start-stop function to prevent the engine from automatically restarting after stalling in water, which could cause severe damage due to water ingestion; Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Follow the path taken by other vehicles and drive at a low speed, avoiding sudden acceleration or deceleration; On roads prone to water accumulation, observe warning water level markers, trees, and other reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed; Know your vehicle's safe wading depth. If the water depth exceeds half of the tire height or the engine's air intake, do not proceed and choose an alternative route instead.

17

4

Share

Why is the display screen of Chery Fengyun 2 not lighting up?

The car's central control screen is not lighting up due to poor line contact. Reasons for the car's central control screen not lighting up: It is due to poor line contact, and it is necessary to promptly check whether there is a loose connection in the lines. If there is, it will naturally cause the central control screen to go black. In this case, simply reconnect the loose part properly. Of course, it could also be because the power signal line has aged, and you can try replacing it with a new one. Solutions for the screen not lighting up: If after checking the above methods, the central control screen still does not light up, it should be because the screen has been used for too long, causing the power supply module to malfunction. This not only results in lagging but can also lead to a black screen in severe cases. It could also be due to a design flaw in the circuit. However, issues like module abnormalities and design flaws are beyond the scope of self-repair and require inspection, repair, or direct replacement at a repair shop.

17

0

Share

Where is the transmission fluid level inspection hole on the Explorer?

The transmission drain port of the Explorer is located on the left side at the rear of the transmission. Hazards of not changing transmission fluid: 1. Can cause damage to the transmission's shift control mechanism; 2. May lead to abnormal wear of gears and clutch plates inside the transmission; 3. Affects normal operation of the transmission, potentially causing damage to the valve body. Transmission fluid is different from engine oil. While both serve lubrication purposes, they perform distinct functions and should not be confused. Differences: Engine oil is the lubricant for the engine system, possessing properties like oxidation resistance, wear resistance, and anti-corrosion. Transmission fluid primarily maintains cleanliness in the gear system and extends the service life of internal transmission components. Due to structural and operational environment differences between transmissions and engines, transmission fluid cannot be used as engine oil, nor can engine oil substitute for transmission fluid.

1

3

Share

How Many Kilometers Should a Volkswagen Sagitar's Transmission Fluid Be Changed?

The Volkswagen Sagitar's transmission is divided into a 7-speed dry dual-clutch transmission and a 5-speed manual transmission. The dry dual-clutch transmission is an automatic transmission. For automatic transmission fluid, it is generally recommended to change it every two years or approximately 40,000 kilometers. For manual transmission fluid, it is generally recommended to change it every three years or approximately 100,000 kilometers. Signs that indicate the need for a transmission fluid change include: body shaking, gear shifting jerks; the dashboard showing a transmission overheating warning; the car stalling; and unusual noises. The methods for changing transmission fluid are as follows: Unscrew the drain plug at the bottom of the transmission to drain the old fluid and then refill. Directly remove the transmission oil pan to drain the old fluid and refill: this method is more thorough than the previous one, as it removes impurities from the bottom of the oil pan. Use a circulation machine to change the automatic transmission fluid: dynamic fluid exchange with an intelligent circulation machine can filter and clean out sludge and impurities inside the automatic transmission.

17

3

Share

Why is one side of the car air conditioner cooling while the other side is not?

How many kilowatt-hours does a WM Motor take to fully charge?

Where is the key sensing area for MG GS?

What is the wading capability of the Model 3?

Why is the display screen of Chery Fengyun 2 not lighting up?

Where is the transmission fluid level inspection hole on the Explorer?

How Many Kilometers Should a Volkswagen Sagitar's Transmission Fluid Be Changed?

What is the Song Pro?

How often does the Mercedes-Benz E-Class require maintenance?

Can a Subaru Forester's ignition coil use aftermarket parts?

How to Reset the Brake Fluid Maintenance Reminder on the New BMW 740?