Why is Mercedes-Benz's glass purple?

How to Install and Remove a Car Battery?

Steps for removing a car battery: 1. Turn off the vehicle engine and remove the key. 2. Disconnect the negative terminal cable from the battery. Reason: The negative terminal is disconnected first mainly because it serves as the ground connection. Once removed, you can proceed without any issues. However, if the positive terminal is disconnected first, there is a risk that improper handling may cause the wrench to come into contact with metal parts of the car body, resulting in sparks. This essentially creates a direct connection between the positive and negative terminals, leading to a sudden surge of extremely high current. In severe cases, this can blow the largest power fuse in the car body, with the most common consequence being the burning out of the car navigation system. 3. Disconnect the positive terminal cable from the battery. 4. Remove the battery protective cover, unscrew the battery's mounting bolts, and take out the battery for replacement. Steps for installing a car battery: Simply reverse the steps for battery removal.

4

5

Share

What Causes Abnormalities in the Reversing Radar?

Reasons for abnormalities in the reversing radar: 1. The reversing radar probe itself is faulty. 2. There is a fault in the connecting wiring of the reversing radar. 3. The vehicle's reversing radar system is malfunctioning. 4. The reversing radar probe is too dirty or has attachments. Note: The above issues need to be checked in order to properly repair the fault. Here is an introduction to the reversing radar: 1. The reversing radar on motor vehicles is a reverse collision avoidance radar, also known as a parking assistance device, mainly composed of ultrasonic sensors, a controller, and a display. 2. When the vehicle is preparing to reverse, it can provide the driver with information about surrounding obstacles, allowing the driver to fully understand the obstacles and helping to eliminate blind spots around the vehicle, thus preventing accidents caused by reversing.

7

4

Share

How to Turn on the Fog Lights on the Buick Excelle?

The front fog light switch is located on the light control lever on the left side of the steering wheel, specifically on the inner rotary ring. The rear fog light switch is positioned on the center console panel. The vehicle's user manual provides detailed instructions. Note that the rear fog lights can only be activated when the front fog lights are turned on; they cannot be operated independently. Here's a step-by-step guide to turning on the fog lights on the Buick Excelle: 1. To activate the fog lights, first turn on the vehicle's lights, i.e., the position lights. Locate the fog light symbol on the light control lever and push it forward; 2. Then, rotate the control ring to align the rear fog light symbol with the activation point. At this point, the rear fog light indicator will appear on the instrument panel; 3. The front fog lights can be turned on individually, whereas the rear fog lights can only be activated in conjunction with the front fog lights and cannot be operated alone.

10

4

Share

Where is the position of the door anti-collision strip?

The door anti-collision strip is installed at the corners of the door and the front/rear bumpers. The main purpose of installing door anti-collision strips is to prevent scratches on the door. It not only provides a certain level of protection but also enhances the body lines and dynamic appearance, serving a decorative function. Due to the small size of the anti-collision strip, its protective effect is very limited when a side collision occurs. Installing anti-collision strips does not fall under the category of car modification and will not affect the vehicle's normal annual inspection. Anti-collision strips typically use 3M adhesive or silicone glue, but these adhesives have certain drawbacks. If the adhesive layer is too thick, it may result in weak adhesion. Over time, the anti-collision strip may age, loosen, crack, or fall off. In such cases, it should be replaced promptly.

16

1

Share

How to adjust the time on Volkswagen Passat?

Method to adjust the time on Volkswagen Passat: The left button on the dashboard adjusts the hour, while the right button adjusts the minute. First, press the left button and wait until the time on the trip computer flashes, then press the right SET button. Pressing SET once adjusts the time by one increment, while holding down the SET button makes the time digits change rapidly. Adjust the time by coordinating the use of both buttons. The Volkswagen Passat is a mid-size sedan designed by Volkswagen AG of Germany, classified as a B-segment car in the Volkswagen lineup. The dimensions of the Volkswagen Passat are 4870mm in length, 1834mm in width, 1472mm in height, with a wheelbase of 2803mm.

19

4

Share

What is the body weight of the Magotan?

The body weight of the Magotan ranges from 1470 to 1550 kilograms. The Magotan is a B-segment sedan under the Volkswagen brand, with dimensions of 4866mm in length, 1832mm in width, and 1464mm in height, and a wheelbase of 2812mm. The Magotan is equipped with a 1.8TSI engine, which is Volkswagen's new-generation engine that perfectly combines turbocharging technology with gasoline direct injection technology. Starting from the headlights, the Magotan features two sharp character lines that form a waistline, complementing the body lines to create a dual-waistline design. Combined with the prominent wheel arch lines and the chrome anti-scratch strips moved downward to the bottom, the side profile of the car appears more visually stable.

15

0

Share

Why is Mercedes-Benz's glass purple?

How to Install and Remove a Car Battery?

What Causes Abnormalities in the Reversing Radar?

How to Turn on the Fog Lights on the Buick Excelle?

Where is the position of the door anti-collision strip?

How to adjust the time on Volkswagen Passat?

What is the body weight of the Magotan?

What is Parking Assist?

What Causes the Abnormal Noise Inside the Car When Driving on Bumpy Roads?

How to Remove the Front Seat Headrest of Volkswagen Tharu?

Should You Engage the P Gear or Pull the Handbrake First When Parking?