Why Install Wider Rear Wheels?

Is the owner's ID card required for motorcycle annual inspection?

Motorcycle annual inspection does not require the owner's ID card, but it is recommended to bring it for insurance purposes. Introduction to vehicle annual inspection: Vehicle annual inspection refers to a mandatory test for all vehicles that have obtained official license plates and registration certificates, equivalent to an annual physical examination of the vehicle according to the "Technical Conditions for Motor Vehicle Operation Safety". The role of vehicle annual inspection: Vehicle annual inspection can promptly eliminate potential safety hazards, urge the strengthening of vehicle maintenance, and reduce the occurrence of traffic accidents. There are relevant regulations in documents such as the "Regulations for the Implementation of the Road Traffic Safety Law" regarding vehicle annual inspection. Some preparatory work is required before the inspection (such as knowing relevant information, online appointment, procedures, vehicle precautions, etc.) to ensure smooth passage. There are initial and regular annual inspections, as well as some related policies.

19

0

Share

What Causes the Jerking When Shifting to First Gear in a Manual Transmission Car?

Here are the reasons for jerking when shifting to first gear in a manual transmission car: Clutch Issues: First, it could be due to rust on the transmission shaft, preventing the clutch driven plate from moving properly and returning poorly, which makes it difficult for the gear to engage normally. Alternatively, a clutch malfunction may result in insufficient clutch separation, leading to incomplete disengagement and difficulty in shifting. In such cases, it is recommended to visit a repair shop to adjust the clutch separation travel. Transmission Issues: First, it might be because the transmission oil needs replacement. Like engine oil, transmission oil is also gear oil. To some extent, gear oil in the transmission requires regular replacement. If not replaced in time, its lubrication effectiveness will significantly decrease, increasing the resistance when shifting and making the gears feel stiff. Or, in colder temperatures, the viscosity of the gear oil in the transmission may not reach the optimal state, naturally resulting in poor lubrication and causing a jerking sensation when shifting gears.

14

2

Share

Is it necessary to fasten seat belts in the rear seats?

Rear seat passengers need to fasten their seat belts. If rear passengers do not wear seat belts, they can become projectiles inside the vehicle during a collision, flying around uncontrollably. Not just the rear seat belts, but all seat belts serve the purpose of securing passengers in their proper positions. This is not only about protecting oneself but also about being responsible for the lives of others. Introduction to seat belts: Seat belts are safety devices used in equipment, such as aircraft or during high-altitude work and performances, to ensure safety. The main materials used are polyester, polypropylene, and nylon. Seat belts are not just about the webbing; besides the webbing, seat belts are assembled from other components. The importance of seat belts: Seat belts have become a primary consideration for drivers and passengers and are one of the most important safety features in vehicles. Traditional components ensuring safe driving, such as rearview mirrors, side mirrors, seat belts, airbags, and ABS, are well-known to drivers and passengers and are commonly used in imported luxury cars.

5

Share

Should I shift to first gear in advance when making a right turn on an uphill section?

When making a right turn on an uphill section, it is essential to slow down and shift to first gear. Shifting to first gear is primarily for safety and also prepares for accelerating again after the turn. When starting the car on an uphill section: As long as the handbrake is firmly engaged, slowly release the clutch to the engagement point, then immediately hold the clutch steady and release the handbrake. This will prevent the car from rolling backward. When driving on a steep slope: You must select an appropriate gear based on the slope conditions to ensure the engine maintains sufficient power. Downshift quickly and avoid forcing the gear to prevent stalling. If you miss the shifting opportunity, you can skip gears to downshift. If you encounter difficulty shifting or the engine stalls, immediately use both the service brake and parking brake to stop the vehicle, then restart. When approaching the top of the slope: Be cautious of oncoming vehicles or pedestrians when nearing the top of the slope, as this area can create a blind spot for normal visibility and increase the risk of traffic accidents.

10

4

Share

What are the differences between National IV and National VI vehicles?

Here are the differences between National IV and National VI vehicles: Different restrictions: The sulfur content limit for National IV is 50ppm; The sulfur content limit for National VI is 5ppm. Different fuel principles: During the National IV phase, diesel and gasoline vehicles had different emission standards; National VI adopts a fuel-neutral principle, meaning the same emission limits apply regardless of fuel type. Different emission standards: Compared to National III, National IV reduced nitrogen oxide emissions by 30% for light-duty vehicles and 50% for heavy-duty vehicles; Compared to National V, National VI reduces particulate emissions by 40%, and for heavy-duty diesel vehicles, nitrogen oxides and particulates will be 60% lower than National V standards.

18

5

Share

What does the green inspection sticker mean?

Annual inspection green sticker indicates the vehicle meets environmental protection standards, yellow indicates partial restrictions, and no sticker is issued for non-compliant vehicles. Liability for accidents involving uninspected vehicles: For any traffic accidents caused by vehicles that fail to undergo annual inspection on time, the involved party shall bear full or primary responsibility, and insurance companies will not assume any liability. This is because the insurance policy specifies excluded claims, which include vehicles with expired inspection. Uninspected vehicles will be mandatorily scrapped: According to the 'Compulsory Scrapping Standards for Motor Vehicles', any motor vehicle that fails to obtain a valid inspection certificate for three consecutive inspection cycles after the expiration of its inspection validity period shall be compulsorily scrapped.

2

0

Share

Why Install Wider Rear Wheels?

Is the owner's ID card required for motorcycle annual inspection?

What Causes the Jerking When Shifting to First Gear in a Manual Transmission Car?

Is it necessary to fasten seat belts in the rear seats?

Should I shift to first gear in advance when making a right turn on an uphill section?

What are the differences between National IV and National VI vehicles?

What does the green inspection sticker mean?

Do I need to take the subject one test for a delayed license renewal?

How Long is a Car Seat Belt?

What is the minimum age for a motorcycle license?

How soon can I schedule the Subject 4 test after passing Subject 3 in Harbin?