Why don't the hazard lights flash when remotely unlocking the car doors?

1 Answers
McChristopher
07/30/25 5:45am
Why don't the hazard lights flash when remotely unlocking the car doors? The reasons may be the following: 1. Remote key battery dead: If the remote key is out of power, it certainly can't lock the doors. Just use the mechanical key to lock them. This is something people usually don't pay attention to, and it's easy to handle later by opening it up and replacing the battery. 2. Remote lock malfunction: The inability to lock the doors with the remote key could also be due to a malfunctioning remote lock or factors like the aging of the car's remote transmitter antenna. This is also easy to detect, and then you can use the mechanical key to lock the doors. 3. Magnetic interference: Some areas may have strong magnetic signal interference, and since the remote key itself uses low-intensity radio waves, it cannot function properly under magnetic interference, naturally making it impossible to lock the doors.
Was this review help?
13
0
Share
More Forum Discussions

How to Replace the Air Conditioning Filter in a LaCrosse?

Steps to replace the air conditioning filter in a LaCrosse are as follows: 1. Pry open the glove box from the side. 2. Unscrew the 3 screws on the upper part and the 2 screws on the lower part of the glove box using a 7mm socket. 3. Pull out the glove box, release several clips, first pull towards the passenger seat direction until the clips loosen or detach, then open the glove box lid, forcefully pull the other side outward to remove the glove box. 4. After securing the wires and air conditioning pipe clips, remove the entire glove box. 5. Once the glove box is removed, the air conditioning filter will be visible. Open the clips on the outer side of the air conditioning filter, then gently pry both sides of the air conditioning filter outward with a small screwdriver to remove it. Pay attention to the markings on the front of the air conditioning filter; the side with text should face outward, and the arrow should point downward. Insert the new air conditioning filter in the same orientation. 6. The installation steps are the reverse of the removal steps; simply reinstall the air conditioning filter in the reverse order.
16
5
Share

How to turn off the auto start-stop on Mazda CX4?

Press and hold the i-stop button to turn off the auto start-stop. The introduction of Mazda CX4's auto start-stop is as follows: 1. There is an i-stop auto start-stop button on the center console. Press and hold the i-stop button until the dashboard display turns yellow, indicating the auto start-stop system is turned off; 2. The auto start-stop system on Mazda CX4 is enabled by default. When the vehicle is powered on, the auto start-stop system will activate; 3. During driving, when the vehicle comes to a temporary stop, the engine will pause. Since the auto start-stop system is active, although the engine stops, the lubricating oil inside continues to circulate, maintaining lubrication within the engine. When the driver releases the brake pedal, the engine will start again.
19
2
Share

How to Turn on the Heating in Volkswagen Lavida?

Lavida's air conditioning heating is activated by rotating the knob. The method to turn on the heating in Lavida is as follows: 1. Start the Volkswagen Lavida and wait for 5-10 minutes until the water temperature rises to normal operating temperature; 2. Adjust the air circulation mode to internal circulation; 3. Switch the air conditioning to heating mode - rotating the knob to the blue bar indicates cold air, while rotating to the red bar indicates warm air; 4. Adjust the air conditioning to the appropriate gear and set the air outlet direction. Options include defrosting the windshield, blowing towards passengers, directing air to passengers' feet, or a combination of windshield and passenger airflow - select according to your needs.
14
0
Share

How Many Cylinders Does the Chevrolet Orlando Have?

Chevrolet Orlando is equipped with a three-cylinder engine. The specific details are as follows: 1. The Chevrolet Orlando is powered by a 1.3T turbocharged engine, with a maximum power output of 120kW and a maximum torque of 230N·m. It is paired with a 6-speed automatic transmission; 2. This engine incorporates advanced technologies such as an efficient combustion system, electronically controlled turbocharging, and single-cylinder dual injection. These technologies not only improve the engine's fuel economy but also enhance its power output, reducing overall vehicle operating costs.
19
2
Share

How to Deal with Foul Odor in Lancer Air Conditioning?

Regularly clean and replace the air conditioning filter. Other methods are as follows: 1. Buy two lemons and place them in the car. For faster results, slice the lemons and place a few slices at the air vents, then turn on the cold air. Soon, the air inside the car will become fresh and fragrant. 2. Used honeycomb coal: Place honeycomb coal in the car, but make sure it has been burned before, as it is particularly effective. It’s best to use intact honeycomb coal, following the principle of adsorption. 3. The odor in a new car is often a sign of air pollution inside the vehicle, possibly releasing harmful substances like formaldehyde and benzene. When the car is not in use, place a small bucket of water with some vinegar inside the car. Repeat this several times, and the odor will gradually disappear. The reason is: water can adsorb formaldehyde, while vinegar helps stabilize it. 4. Onions: Slice a few onions, place them in a basin of water, stir, and then leave them in a newly renovated room to remove odors. This method can be slightly adapted for use in cars. Cut a whole onion into four pieces and place them in the car. 5. Use the air conditioning less frequently and often open the car windows to allow for better ventilation, ensuring fresh air circulation inside the car.
20
0
Share

How many kilometers should the timing belt of Golf VII be replaced?

Golf 7 cars should have their timing belts replaced every five years or every 100,000 kilometers. The Volkswagen Golf 7 has two engines that use timing belts for transmission, which are the 1.2T and 1.4T EA211 engines. More details about the timing belt are as follows: 1. The internal components of the engine timing belt consist of six parts: the timing belt, timing belt tensioner, guide pulley, intake camshaft pulley, exhaust camshaft pulley, and crankshaft pulley; 2. Timing belt transmission produces less noise than chain transmission engines, operates more smoothly, and the maintenance cost of timing belts is much lower than that of chain transmission engines.
2
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.