Why Doesn't Mercedes-Benz Have a Spare Tire

1 Answers
RiverFitz
07/29/25 4:43pm
Mercedes-Benz does not have a spare tire because it uses run-flat tires. Here is some information about Mercedes-Benz tires: 1. Features of run-flat tires: After a tire blowout, the car can still travel up to approximately 80 kilometers at a maximum speed of 80km/h, which is sufficient to reach the nearest repair shop for tire replacement. Therefore, Mercedes-Benz vehicles do not need to be equipped with a spare tire. 2. Functionality: Run-flat tires not only allow continued driving after losing pressure but also ensure safety. After a blowout, run-flat tires do not immediately collapse because their sidewalls are particularly thick, providing strong support to prevent the vehicle from rolling over. Additionally, vehicles with run-flat tires do not have a spare tire, allowing continued driving after a blowout without the need for immediate tire replacement, offering convenience and increasing trunk space.
Was this review help?
12
5
Share
More Forum Discussions

What are the symptoms of a faulty Sylphy water pump?

Sylphy water pump failure may exhibit the following 3 symptoms: 1. Idling issues: The water pump is connected to the belt, drawing cold water from the radiator to cool the engine. If the pump's rotation is problematic, it will directly affect engine speed; 2. Coolant leakage: Most water pump failures result in coolant leakage, caused by aging of the pump's sealing ring. Over-tightening of the engine serpentine belt can also lead to premature pump wear. Failure to replace antifreeze for extended periods may cause internal corrosion, ultimately damaging the pump. Operating beyond its service life without replacement can also cause failure; 3. Engine noise: When opening the hood and starting the engine, if a low grinding noise is heard, it may indicate damaged pump bearings. The automotive engine uses a centrifugal water pump, whose basic structure consists of the pump housing, connecting plate or pulley, pump shaft and bearings or integrated shaft bearings, pump impeller, and seal assembly. It is a major component of the vehicle.
10
5
Share

Where is the fuel tank cap switch for the BMW X1?

The fuel tank cap of the BMW X1 is located on the right side of the vehicle body, with the fuel tank positioned beneath the rear seat chassis. Below are the relevant details: 1. The method to open the fuel tank cap of the BMW X1 is relatively simple—press the fuel tank cap to open it. 2. The BMW X1 uses gasoline of grade ROZ95 or ROZ98 premium gasoline. 3. To achieve optimal fuel consumption, it is recommended to use gasoline that is sulfur-free or contains as little sulfur as possible. 4. The use of fuel labeled as containing metal on the fuel pump is not permitted. 5. Fuels with an ethanol content of up to 25%, such as E10 or E25, can be used. 6. The engine is equipped with an anti-knock control function, allowing the use of different grades of gasoline. 7. The vehicle manufacturer suggests mixing 100 milliliters of an appropriate gasoline additive during each refueling process.
19
0
Share

How to Deal with the EDC Warning Light in Iveco?

EDC warning light indicates a fault in the electronic fuel injection system. When this issue occurs, it is necessary to visit a 4S shop or a professional repair shop for handling. Below are specific details about EDC: 1. EDC stands for Electric Diesel Control, representing the electronic control system for diesel injection. An EDC fault refers to a problem with the high-pressure electronic injection and electronic control system, which can be understood as a type of engine malfunction. Specialized diagnostic equipment is required for inspection and analysis. Do not attempt to loosen or inspect it yourself, as high-pressure fuel line sprays can cause harm. Professional inspection at a repair shop is necessary. 2. An illuminated engine warning light does not pose significant harm to the engine but may increase fuel consumption. Typically, this indicates an issue with the high-voltage circuit of the engine, the fuel injector, or the oxygen sensor circuit. First, check if the high-voltage wires or spark plugs have been affected by car washing, rain, or have come loose.
14
0
Share

How to set the Toyota C-HR to make a sound when locking the car?

Here are the specific steps to set the car to make a sound when locking: 1. First, sit in the driver's seat, press the brake pedal, and keep the gear shift lever in the P position, then release the brake pedal. 2. Then press the one-touch start button twice. Note: There should be a certain interval between these two consecutive presses; if the interval is too short, the car system may not respond. 3. After closing all four doors, press and hold the lock button on the driver's side door for more than 10 seconds. At this point, the setting for the locking beep is completed. Below is the tutorial for replacing the key battery of the Toyota C-HR: 1. Remove the mechanical key. 2. Take off the key cover. Be careful during the removal process to avoid damaging the key. 3. Using a small flat-head screwdriver can make it easier to remove the old battery. 4. Insert the new battery with the positive side facing up. 5. After installing the battery, reassemble the key. 6. Test whether functions like the lock button work properly.
15
1
Share

How much difference in production dates between new car windows is considered normal?

New car windows with production dates differing by 2-3 months is considered normal. Below are specific methods to check if the windows have been replaced: 1. Manufacturer: The manufacturer code on the window can indicate which company produced the window. Generally, car manufacturers purchase windows in bulk and do not use too many brands or the same brand from different production locations. 2. Window production date: If there is a significant difference in the production dates of the windows on the same car, it may indicate that the car has been refurbished or the windows have been replaced later. 3. Window label: If a car window has been replaced, the label on the new window will be significantly different from the original factory label.
9
2
Share

What is the new name of the Prado?

The Prado has now been renamed as the Land Cruiser Prado, which is an SUV series under the Toyota brand. The Prado is divided into GX and VX, as well as GXR and VXR, and is an imported ORV. Other Prado models: Prado 4.0L GX (AT), Prado 4.0L GX Luxury Edition, Prado 4.0L GX Luxury DVD Edition, Prado 4.0L GX Sport DVD Edition, Prado 4.0L VX (AT), Prado 4.0L VX NAVI Edition. Prado model features: The Prado is the latest model in the Toyota Land Cruiser series, with excellent power performance and emissions meeting Euro III standards. The advanced engine provides strong output power and torque, paired with a highly sturdy frame and reinforced suspension system, making even the roughest journeys comfortable and smooth. Prado safety configurations: The domestic Prado does not include cruise control, hill start assist control, dynamic stability system, auto-leveling rear suspension, or the most useful A-TRC active traction control for off-road driving, but these are standard features in the imported version.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.