Why does Wuling Hongguang always make a ticking sound?

2 Answers
LeCora
07/24/25 6:25am
The reasons why Wuling Hongguang always makes a ticking sound are as follows: 1. Cold engine noise: When starting a cold engine, you often hear a "ticking" noise from the engine compartment, which disappears after the engine warms up. This is because the car has been parked for too long, and the engine oil has mostly flowed back into the oil pan. During a cold start, the oil cannot form an effective oil film or establish proper oil pressure, causing slight metal impacts in either the hydraulic lifters or mechanical rocker arms. 2. Hot engine noise: When a noise occurs in a hot engine, the owner needs to pay close attention. Hot engine noises are generally difficult to locate and require technical troubleshooting. If the engine does not lose power or produce white/black exhaust when the noise occurs, the problem is relatively minor, and internal cylinder issues can be ruled out. Typically, belt slippage or aging can also cause noises. When a metal knocking sound is heard, the owner should promptly take the car to a repair shop for inspection.
Was this review help?
11
3
Share
RowanMarie
08/11/25 2:12am
I've been driving the Wuling Hongguang for over a decade to haul goods. The most common cause of the rattling sound is either excessive valve clearance in the engine or a loose timing chain. Over time, the chain wears out and produces a rhythmic knocking noise when rotating. If not addressed promptly, the wear can worsen, affecting power output. Loose chassis bolts can also cause noise, especially in the rear axle area, which experiences significant vibration when carrying heavy loads, making it prone to loosening. I recommend not waiting—take it to a repair shop to check the chain and chassis. Installing a chain tensioner or tightening the bolts should suffice and won't cost much. Safety comes first. Ignoring engine issues can be dangerous, as you might get stranded on the road, causing delays and hazards. During regular maintenance, pay attention to unusual noises—early detection and repair save trouble in the long run.
Was this review help?
10
2
Share
Expand All
More Forum Discussions

Does Not Going to a 4S Shop for Maintenance Affect the Warranty?

New cars not being maintained at a 4S shop will not affect the warranty. The specific reasons are as follows: 1. According to the "Consumer Rights and Interests Protection Law of the People's Republic of China": Article 26 "Business operators shall not, through standard terms, notices, announcements, shop notices, etc., make provisions that exclude or restrict consumer rights, reduce or exempt business operators' responsibilities, or increase consumer responsibilities, which are unfair and unreasonable to consumers, nor shall they use standard terms and technical means to force transactions. Standard terms, notices, announcements, shop notices, etc., containing the aforementioned contents are invalid. 2. Article 11 of the "Guiding Opinions on Promoting the Transformation and Upgrading of the Automobile Maintenance Industry and Improving Service Quality" stipulates: Manufacturers shall not refuse to provide maintenance services on the grounds that the car has chosen non-authorized maintenance services during the "three guarantees" period, unless the 4S shop can prove that the fault was caused by improper maintenance or repair by the car owner elsewhere, otherwise, it shall bear the responsibility for repair in accordance with the law.
8
3
Share

Can a Three-Wheeled Motorcycle License Drive a Two-Wheeled Motorcycle?

A three-wheeled motorcycle license can indeed be used to operate a two-wheeled motorcycle. The three-wheeled motorcycle license is categorized as a Class D license, which includes the vehicle types covered by Class E and Class F licenses. Since a two-wheeled motorcycle falls under the Class E license, a Class D license holder is permitted to drive standard three-wheeled motorcycles, standard two-wheeled motorcycles, and light motorcycles. Standard Three-Wheeled Motorcycle (Class D): Three-wheeled motorcycles with an engine displacement exceeding 50ml or a maximum design speed exceeding 50km/h (Classes E and F). Standard Two-Wheeled Motorcycle (Class E): Two-wheeled motorcycles with an engine displacement exceeding 50ml or a maximum design speed exceeding 50km/h (Class F). Light Motorcycle (Class F): Motorcycles with an engine displacement of 50ml or less and a maximum design speed of 50km/h or less.
6
3
Share

Why is the wiper not working?

Wiper not working may be caused by: blown fuse, motor burned out. The specific reasons are as follows: Blown fuse: The wiper may not move because the fuse (to prevent circuit overload) is blown, causing the wiper to fail to work properly. In this case, you need to open the fuse box and check whether the corresponding fuse (refer to the manual on the cover) is blown. If it is, just replace it, but remember to turn off all the car's power before replacing it. Motor burned out: The probability of motor burnout is actually very low, but it may also be a quality control issue. As for how to judge, first turn the car's ignition switch to the power-on state, then try to open the front hood and turn on the wiper. If it is not broken, you can hear the sound of the motor turning, and the sound is quite obvious. If there is no sound and accompanied by a slight burnt smell, it is likely that the motor is damaged.
16
3
Share

What procedures are required for transferring vehicle registration from another location to local licensing?

Transferring vehicle registration from another location to local licensing requires the vehicle owner's ID card, relevant vehicle transfer procedures, and driving the vehicle to the local vehicle management office to complete the registration. After completing the procedures, you can re-select the vehicle license plate, process the vehicle's driving license, and pay the relevant taxes and fees. It is important to note the vehicle emission standards of the destination location, as only vehicles that meet the local emission standards are allowed to complete the vehicle registration procedures. First, inquire about the emission standards of the destination location, then confirm the emission standards of the vehicle to be transferred. If the emission standards are met, proceed with the relevant transfer procedures. After the vehicle transfer and re-registration, you need to re-select the vehicle license plate. Currently, the license plate selection is a '50 choose 1' system. As long as you select the license plate within the specified time, the vehicle's driving license can be produced, and then the vehicle license plate can be obtained through the driving license.
15
1
Share

Can a Financed Car Be Transferred?

It is not possible to transfer ownership of a car that is still under a mortgage. When applying for an auto loan, the ownership of the car has already been transferred to the lending institution. During the loan period, the borrower only has the right to use the car but not the right to dispose of it. Only after the entire loan, including both the principal and interest, is fully repaid will the ownership of the car be returned to the borrower. Therefore, a car under mortgage cannot be transferred or sold. Below are the relevant materials required for releasing the vehicle from mortgage: "Vehicle Registration Certificate"; original "Motor Vehicle Mortgage Registration/Pledge Record Application Form" with the lender's official seal; identification documents and copies of both the vehicle owner and the lender; the lender's power of attorney without an official seal. The process for releasing the mortgage after repaying the loan: After repaying the final installment of the auto loan, contact the lending bank within about ten working days to obtain a loan settlement certificate, and retrieve the "Vehicle Registration Certificate" and the purchase invoice that were mortgaged at the bank.
20
3
Share

What type of gasoline should a Mercedes-Benz C-Class use?

Mercedes-Benz C-Class uses 95-octane gasoline. 95-octane gasoline consists of 95% isooctane and 3% n-heptane. The Mercedes-Benz C-Class is a mid-size sedan under the Mercedes-Benz brand, equipped with three engines: a 1.5-liter turbocharged engine, a low-power version of the 2.0-liter turbocharged engine, and a high-power version of the 2.0-liter turbocharged engine. The 1.5-liter turbocharged engine delivers a maximum power of 156 horsepower and a maximum torque of 250 Nm; the low-power version of the 2.0-liter turbocharged engine produces a maximum power of 184 horsepower and a maximum torque of 280 Nm; the high-power version of the 2.0-liter turbocharged engine generates a maximum power of 258 horsepower and a maximum torque of 370 Nm. All three engines are paired with a 9-speed automatic transmission (9AT).
5
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.