Why does the Magotan display screen go black?

1 Answers
DelEmery
07/29/25 4:56pm
There are many reasons that may cause the Magotan display screen to go black, such as power supply, wiring, or dust contact issues. You can try restoring the factory settings first, or use a computer to troubleshoot. If the problem persists and the car is still under warranty, go for warranty service; if not under warranty, take it directly to a 4S shop for repair. Below are specific reasons: 1. Car power supply voltage issue: Check the stability of the car's power supply voltage to rule out voltage instability. 2. Car navigation cable: If the voltage is stable, then check the cables on the back of the device for any issues, and try replacing the connections to troubleshoot. If the connections are fine, inspect the display cable of the device. If there is a problem, replace it with a new one for testing. 3. If there is only no image but sound: This indicates that the power plug of the navigation display is loose. If there is no sound or image at all, the DVD player might be broken.
Was this review help?
20
1
Share
More Forum Discussions

How to Deal with Dampness and Musty Smell Inside the Car?

It is necessary to thoroughly clean and disinfect the vehicle's interior. Especially the air conditioning pipelines. After use, the air conditioning pipelines should be cleaned to avoid odors, and garbage should be promptly removed. Drive the vehicle to the brand's after-sales service department for targeted repairs. This can completely solve the problem and prevent it from affecting the vehicle.
8
2
Share

How to Align the Timing Chain of the 4RB2 Engine?

After removing the cylinder head, sequentially remove the fan belt, slide rail assembly, damping plate assembly, and crankshaft timing sprocket. Straighten the chain, measure at 3 to 4 selected positions, and replace the chain if necessary. The minimum value for the intake camshaft timing sprocket is 113.8mm. Inspect the slide rail assembly and damping plate assembly; replace them if the maximum wear exceeds 1mm.
8
2
Share

How to Operate the Lynk & Co 03 at Traffic Lights?

When waiting at a red light while driving, first maintain an appropriate distance from the vehicle in front to prevent the car from rolling backward if your foot suddenly releases the brake. Then shift the vehicle into neutral. Engage the handbrake, release both feet, or press the parking button to prevent the car from rolling.
3
3
Share

How to align the timing chain on a Mazda6 2.0 engine?

Remove the right half shaft. There is a timing inspection hole on the side of the engine block. Note that at this point it is slightly before reaching top dead center. There is a timing hole. Use an M6 bolt to screw it upwards onto the front timing rail cover. Install one upper bolt. The final step requires fixing both camshafts in place first.
11
3
Share

How to Remove the Lynk & Co Mechanical Key?

The key is a remote and mechanical two-in-one design, with the mechanical key hidden inside the remote key. First, locate the release button on the key and press it. Then, slide the key cover open slightly and flip it open. The lifespan of the car key battery depends on usage frequency, making it difficult to determine the exact replacement time.
6
3
Share

How to Disassemble a Malibu Car Key?

Press the side button near the bottom of the transmitter and pull out the key. Use a screwdriver to pry open the car key. There will be a small gap in the middle of the key. The front suspension type is MacPherson independent suspension, and the rear suspension type is multi-link.
4
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.