Why does the left rear taillight of the Mercedes-Benz GLA stay on after turning off the engine?

How to Determine Running a Red Light When Turning Left?

Running a red light is determined by capturing three photos via electronic cameras: A photo showing the vehicle crossing the intersection stop line, including the red traffic light and license plate number. A photo showing the vehicle completely passing the stop line, including the red traffic light and license plate number. A photo showing the vehicle continuing to move, with a comparison to check if the vehicle's position has changed, including the red traffic light and license plate number. Capturing these three photos confirms that the vehicle ran a red light. The act of running a red light is clearly defined in the "Road Traffic Safety Law". Article 26 states that traffic signals consist of red, green, and yellow lights. A red light indicates prohibition of passage, a green light permits passage, and a yellow light serves as a warning. A red light is a traffic signal prohibiting passage; driving through an intersection during a red light constitutes the traffic violation of running a red light. To avoid running a red light, consider the following points: First look at the arrow light, then the circular light: Currently, there are two types of indicator lights: arrow traffic lights and circular traffic lights. When arrow lights are present, first observe the arrow light and then the circular light to avoid running a red light. Note: When encountering a circular red light, right turns are permitted. However, if the right-turn arrow is red, right turns are prohibited, and violating this will be penalized as running a red light. Brake in time: When the red light turns on, ensure the front of the vehicle does not cross the stop line. If the front wheels accidentally cross, and the rear wheels follow, the electronic camera will capture it, resulting in a penalty for running a red light. If the front wheels have just crossed the stop line when the light turns red, do not proceed through the intersection; wait for the green light. Check the green light countdown before proceeding: When the green light flashes, if there is a countdown, use it to make a judgment. If there is no countdown, and the vehicle is close to the intersection with sufficient speed, proceed to avoid running a red light due to untimely braking. If the speed is slow and the vehicle is far from the intersection, brake immediately to stop and avoid running a red light. Article 38 of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China" states regarding motor vehicle and non-motor vehicle signal lights: When the green light is on, vehicles are permitted to proceed, but turning vehicles must not hinder the passage of straight-moving vehicles and pedestrians. When the yellow light is on, vehicles that have already crossed the stop line may continue to proceed. When the red light is on, vehicles are prohibited from proceeding. At intersections without non-motor vehicle or pedestrian crossing signals, non-motor vehicles and pedestrians should follow the motor vehicle signal lights. When the red light is on, right-turning vehicles may proceed if they do not hinder the passage of other vehicles and pedestrians. Running a red light is not considered illegal under the following circumstances: Yielding to special vehicles: Yielding to ambulances, fire trucks, and other special vehicles. If captured by surveillance cameras while yielding, manual review will not record the act as running a red light. Even if recorded, you can apply for reconsideration at the traffic police department. Extreme weather: When visibility is so low that even electronic police cannot clearly see the traffic lights. Blurred evidence photos may result in accidental red-light running, for which traffic police will not impose penalties. Emergency situations: Transporting a critically ill patient to the hospital may involve running multiple red lights, quickly exhausting the 12-point penalty limit. After delivering the patient, provide proof from the hospital or the rescued individual to the traffic police for verification. If confirmed, the violation records can be cleared. If possible, calling an ambulance is advisable to avoid accidents from running red lights. Traffic police direction: During peak hours, traffic police may temporarily direct traffic at key intersections. Drivers should follow the gestures of the traffic police.

13

3

Share

What to Do When Water Drips from the Exhaust Pipe After Parking?

Water dripping from the exhaust pipe after parking is a normal phenomenon indicating complete combustion of gasoline. To some extent, it reflects that the car engine is in good working condition and the gasoline is burning efficiently. However, excessive water dripping is not ideal, as too much water can damage the oxygen sensor in the catalytic converter and reduce the vehicle's power performance. If abnormal water dripping occurs from the exhaust pipe, inspection and repair are necessary. Below are some considerations regarding abnormal water dripping from the exhaust pipe: 1. Check if the coolant tank is leaking. It is possible that the engine's coolant tank is leaking, allowing coolant to enter the combustion chamber and causing water to drip from the exhaust pipe. 2. Check if the coolant tank frequently runs low. 3. Inspect whether the engine's cylinder head gasket is properly sealed.

15

1

Share

How to Reset the Q5I Tire Pressure Warning Light?

Audi Q5L's tire pressure warning light indicates that the tire pressure needs calibration. The light will automatically turn off after calibration is completed. Below is the manual method to reset the Q5I tire pressure warning light: 1. Press the one-touch start button on the center console to start the vehicle's engine; otherwise, the tire pressure cannot be cleared. 2. Press the button located on the left side of the steering wheel to enter the tire pressure settings interface. 3. Use the menu selection button to choose the corresponding option on the center console display. 4. Press and hold the custom button on the right side of the steering wheel until you hear a beep, then release. 5. Check the vehicle's dashboard to see if the warning light has been reset.

11

4

Share

Should Freon be added to the car air conditioning system from the low-pressure or high-pressure side?

Freon can be added from either the low-pressure or high-pressure side. More information about adding Freon to car air conditioning systems is as follows: 1. There are two methods for adding Freon to car air conditioning systems. High-pressure side filling: Suitable for filling after leak detection and vacuuming, the compressor must not be turned on, the engine must be stopped, and the refrigerant tank must be inverted; Low-pressure side filling: Gas is added, characterized by slow filling speed, usually suitable for supplementing refrigerant. 2. After filling is completed, close the low-pressure manual valve on the manifold pressure gauge and the injection valve on the refrigerant tank, stop the engine, and quickly remove the manifold pressure gauge from the compressor to avoid excessive refrigerant leakage.

9

4

Share

How to Add Windshield Washer Fluid to a Geely Emgrand?

Geely Emgrand windshield washer fluid adding steps are as follows: 1. Open the driver's door of the Geely Emgrand and pull the safety latch of the engine hood; 2. Then press the hidden switch under the engine hood, slowly lift the hood upwards, and secure it with the support rod; 3. Locate the windshield washer fluid filler port (usually on the left side), open the small blue cap, and finally pour in the prepared windshield washer fluid. The functions of windshield washer fluid are as follows: 1. Cleaning performance: Surfactants typically have wetting, penetrating, and solubilizing functions, serving to clean and remove dirt. 2. Antifreeze performance: The presence of alcohol and ethylene glycol can significantly lower the freezing point of the liquid, providing antifreeze protection. 3. Anti-fog performance: Forms a monomolecular protective layer on the glass surface, ensuring clear and transparent windshield visibility. 4. Anti-static performance: After cleaning with washer fluid, substances adsorbed on the glass surface can eliminate surface charges, providing anti-static properties. 5. Lubrication performance: The ethylene glycol content in washer fluid has high viscosity, providing lubrication to reduce friction between wipers and glass, preventing scratches.

18

3

Share

What are the driving wheels and the passive wheels respectively?

Introduction to driving wheels and passive wheels is as follows: 1. The driving wheel is the wheel that converts the energy of the car engine into kinetic energy, enabling the car to move backward or forward. 2. The passive wheel has no power and only plays a supporting role. The rotation of the passive wheel is driven by other driving wheels. The following is the connection between the driving wheels and passive wheels of a car: (1) The driving wheel of a car is connected to the drive axle and provides the power for the car to move forward. (2) The power of the car engine is transmitted through the gearbox to the drive axle and then to the driving wheels, so the function of the drive axle is not only to support the weight of the car but also to provide power for driving. (3) When the car moves forward, the driving wheels are the two front wheels, and the two rear wheels are the passive wheels, which only play a supporting role and do not provide power.

9

0

Share

Why does the left rear taillight of the Mercedes-Benz GLA stay on after turning off the engine?

How to Determine Running a Red Light When Turning Left?

What to Do When Water Drips from the Exhaust Pipe After Parking?

How to Reset the Q5I Tire Pressure Warning Light?

Should Freon be added to the car air conditioning system from the low-pressure or high-pressure side?

How to Add Windshield Washer Fluid to a Geely Emgrand?

What are the driving wheels and the passive wheels respectively?

How to Adjust the Equalizer of Car Audio?

What does China 4 OBD mean?

How to Check the Manufacturing Date of Car Tires?

Can a clogged car carbon canister be cleaned?