Why does the car shake when the air conditioner is turned on?

1 Answers
DeKatherine
07/23/25 11:19pm
The reasons why the car shakes when the air conditioner is turned on are: 1. The compressor pressure is too high; 2. The throttle needs to be cleaned; 3. Engine carbon deposits or aging; 4. Problems with the air conditioner. The solutions to the car shaking when the air conditioner is turned on are: 1. Check the high and low pressure of the air conditioner to see if the pressure is too high; 2. Clean the throttle; 3. Clean engine carbon deposits; 4. Check if the air conditioner's radiator is unobstructed. The car air conditioner consists of a compressor, condenser, expansion valve, and evaporator. The car air conditioner, short for car air conditioning device, is used to adjust and control the temperature, humidity, air cleanliness, and air flow inside the car compartment to an optimal state.
Was this review help?
3
3
Share
More Forum Discussions

How many cylinders does the Fengguang S560 engine have?

The Fengguang S560 is equipped with a four-cylinder engine, offering two engine options in total. One is a 1.5T turbocharged engine with a maximum power of 110kW and a maximum torque of 220Nm, paired with either a 6-speed manual or CVT transmission. The other is a 1.8L naturally aspirated engine with a maximum power of 102kW and a maximum torque of 187Nm, matched with either a 5-speed manual or CVT transmission. The Fengguang S560 measures 4560mm in length, 1815mm in width, and 1735mm in height, with a wheelbase of 2690mm. The vehicle features front-wheel drive, with a MacPherson strut front suspension and a five-link coil spring rear suspension.
13
2
Share

What is the 0-100 km/h acceleration time of the Audi A6L?

Among the four engine options of the Audi A6L (2.0T, 2.5, 2.8, and 3.0T), the 0-100 km/h acceleration time is 8.51 seconds. Definition of 0-100 km/h acceleration: It refers to the time it takes for a car to accelerate from 0 to 100 kilometers per hour. Purpose of 0-100 km/h acceleration: It is used to more intuitively reflect the difference in a car's power performance. The shorter the 0-100 km/h acceleration time, the stronger the power, and consequently, the more expensive the car will be. Generally, most cars have a 0-100 km/h acceleration time of around 10 seconds. Cars that can achieve a 0-100 km/h acceleration time within 5 seconds are usually luxury supercars.
20
1
Share

What is the reason for the failure of the car central locking system?

The failure of the car central locking system is mainly caused by malfunctions in the door lock actuator and the door lock controller. If this situation occurs, the car owner should promptly take the vehicle to a repair shop for inspection. The fault information can be quickly detected using a diagnostic tool. Below are some additional details: Central Control: When the driver locks the door next to them, all other doors are simultaneously locked. The driver can use the door lock switch to open all doors at once or open a specific door individually. Speed Control: When the vehicle reaches a certain speed, all doors automatically lock to prevent passengers from accidentally opening the doors by operating the door handles. Individual Control: In addition to the door next to the driver, other doors are equipped with separate spring lock switches, allowing independent control over the locking and unlocking of each door.
4
5
Share

What are the reasons for the engine warning light in the Buick Regal?

Buick Regal engine warning light may illuminate due to the following reasons: Substandard exhaust emissions: Issues such as poor fuel quality, failed catalytic converter, excessive carbon buildup in the intake manifold, clogged fuel injectors, faulty oxygen sensors, or occasional engine misfires can trigger the engine warning light. Among these, poor fuel quality is the most common cause. Poor engine system performance: The warning light may also illuminate due to malfunctions in components like the throttle pedal sensor, throttle position sensor, mass airflow sensor, crankshaft position sensor, or poor electrical connections. Transmission system issues in some vehicles: Certain transmission system problems, such as internal faults, slippage, or overheating, may also be indicated by the engine warning light.
6
3
Share

What are the reasons for normal engine shutdown?

Reasons for normal engine shutdown: The car key is in the OFF position of the ignition switch. Normal engine shutdown is achieved by short-circuiting the spark plugs, as the engine operates by spark plug ignition. Turning the key to shut off the engine essentially shorts the high-voltage electricity supplied to the spark plugs, causing the engine to stop. Working principle of engine shutdown: 1. After the ignition is turned off, the ECU shuts down and no longer controls spark plug ignition or fuel injector operation; 2. When the ignition switch is in the ON position, the ECU powers on and supplies electricity to various sensors required for engine operation to prepare them for work. The fuel pump then operates for several seconds to build up oil pressure for normal fuel injection; 3. When the key is turned to the OFF position, it cuts power to the starter motor. At this point, the starter stops running, and the crankshaft ceases to drive the pistons in reciprocating motion, thereby achieving engine shutdown.
13
4
Share

Will I Be Penalized for Driving in the Wrong Variable Lane?

Driving in the wrong variable lane will result in penalties. Changing lanes or turning incorrectly is considered driving outside the designated lane. Additional details are as follows: 1. Penalty: At intersections with marked lanes, vehicles must enter the lane corresponding to their intended direction of travel. Violations are subject to a fine of 100 RMB and a deduction of 2 points under Article 90 of the Traffic Safety Implementation Regulations. 2. Correct Route: When passing through signal-controlled intersections with marked lanes, vehicles must enter the lane corresponding to their intended direction of travel. For example, if a vehicle proceeding straight enters a left or right turn lane, electronic surveillance will immediately capture the violation. 3. Types of Violations: There are three main types of violations for not driving in the designated lane: first, proceeding straight from a left-turn lane; second, turning left from a straight lane; and third, making a right turn arbitrarily from either a left-turn or straight lane.
9
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.