···
Log in / Register

Why does the car make no sound after powering on and fails to start?

3 Answers
StLorenzo
09/01/25 5:08am
Car fails to start and makes no sound after powering on may be caused by severe battery depletion, insufficient oil pressure, or poor ignition system performance. Below are detailed explanations: Battery Depletion: Vehicle failure to start due to battery depletion usually manifests as the starter not working or significantly insufficient rotation speed when attempting to start. Replacing the battery or jump-starting can resolve the issue. Insufficient Fuel Pressure: This generally manifests as no fuel pressure in the engine's fuel supply line. At extremely low temperatures, water mixed with debris can block the fuel line, preventing startup. It is necessary to replace the fuel filter and check if the fuel pump is functioning properly. Poor Ignition System Performance: In cold weather, due to low intake air temperature, fuel atomization in the cylinder is poor. If combined with insufficient ignition energy, this can result in cylinder flooding, where excessive fuel accumulates in the cylinder, exceeding the ignition limit concentration and preventing the engine from starting. Regular replacement of spark plugs and ignition coils is required.
Was this review help?
20
1
Share
OscarLee
09/13/25 7:53am
As a veteran driver with twenty years of experience, I find this issue quite common. If the car won't start and there's no sound, it's most likely due to a completely dead battery or poor contact. Battery aging or leaving the headlights on can drain it. First, check if the dashboard lights up—if nothing lights up, the battery is probably dead. Loose or corroded wire connections can also disrupt the current, especially if the ground wire is rusted, which has a bigger impact. A stuck starter switch is another possibility, though less likely. Try jump-starting the car; if that doesn't work, inspect the fuse box and wiring. Regular battery maintenance is crucial—replace it every two to three years to avoid getting stranded. If all else fails, seek a professional mechanic. Safety comes first—don't push it, or you'll waste time and money.
Was this review help?
1
2
Share
Expand All
OCatherine
10/27/25 8:37am
Last time my car did the same thing, suddenly wouldn't start and made no sound at all - it drove me crazy! Turned out the battery was completely dead, probably from leaving the headlights on or just old age. When I turned the key and the dashboard didn't light up, I knew it was serious. You should also check if the anti-theft system is locked - some cars prevent starting if the key battery dies or there's a system fault. Poor wire connections like loose plugs can also cause this, especially during rainy humid weather when corrosion sets in faster. Quickly call a friend to try jump-starting - if the starter doesn't even make a sound, it's almost certainly an electrical issue. Don't wait too long, it's dangerous at night or in remote areas. Calling a tow truck to take it to the shop is the safest bet - no need to take risks.
Was this review help?
17
5
Share
Expand All
More Forum Discussions

What to Do When the Nissan Sylphy's Battery is Dead and Won't Start

Need to bring the two cars as close together as possible. Generally, the car battery is located under the front hood. The two cars should be parked side by side or head to head. Next, locate the batteries of both cars, identify the positive and negative terminals, remove the terminal covers, and use the red battery cable clamp to attach to the positive terminal. Then, attach the red clamp first, followed by the black one. Once all four terminals are connected, the jump-start setup is complete, and you can proceed to start the car with the dead battery.
1
5
Share

How to Make a Turn Correctly?

After turning on the turn signal, slow down and apply the foot brake. After completing the turn, engage the accelerator. When shifting gears, press the clutch, but remember to apply the brake before pressing the clutch. When shifting gears, press the clutch to downshift to 2nd or 3rd gear, then immediately release the clutch without keeping it pressed. After downshifting to 2nd gear, release the clutch, turn the steering wheel, and place your foot on the accelerator. Maintain the speed, steer the wheel, and complete the turn smoothly.
19
1
Share

How to Test the Quality of a Throttle Grip?

When measuring, turn on the power and short-circuit the red and blue wires among the three signal lines of the throttle grip. If the motor starts rotating, it indicates the throttle grip is functioning properly. Connect the black probe to the negative wire among the three wires, and the red probe to the black wire. Rotate the throttle grip to see if there is any voltage output, which typically changes from 0 volts to 5 volts.
17
3
Share

How to Check the Tire Pressure Monitoring on Geely Vision X6

Start the vehicle's power supply and press the menu button; switch to the vehicle information menu, which will display as overspeed alarm; Rotate the knob at the top of the left lever to the tire pressure monitoring information, where you can view the tire pressure of all four wheels.
17
5
Share

How to Start a Sedan?

Insert the key and turn it to the ACC position, then wait for 2-3 seconds to allow the main power relay contacts to stabilize and make proper contact; This allows the first set of components requiring power to be energized; Continue turning the key to the ON position, then pause and wait for 6-10 seconds to let the fuel pump relay engage; After waiting for all sensors to complete their adjustment states, turn the key to the START position until the engine runs continuously, then return it to the ON position.
4
5
Share

Can electric motorcycles carry passengers?

Electric motorcycles can carry passengers. Here is the relevant information: Additional information: Traffic regulations do not explicitly state that electric vehicles can carry passengers, but they do stipulate that light motorcycles are not allowed to carry passengers. Electric motorcycles: Electric motorcycles are a type of electric vehicle that uses a battery to drive the motor for movement. The electric drive and control system consists of a drive motor, power source, and speed control device for the motor, among other components. The other components of an electric motorcycle are basically the same as those of an internal combustion engine. The composition of an electric motorcycle includes: the electric drive and control system, mechanical systems such as drive force transmission, and working devices to accomplish set tasks. The electric drive and control system is the core of an electric vehicle and also the biggest difference from vehicles driven by internal combustion engines.
7
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.