Why does the car lock indicator light keep flashing?

1 Answers
DelLevi
07/24/25 12:38pm
The car lock indicator light keeps flashing, possibly due to a damaged hazard light switch or an internal malfunction. It is best to go to a repair shop for a computer diagnostic. Below are the relevant explanations: If the anti-theft device does not cause the original car's turn signals to flash when locking or unlocking the door, the possible reasons are as follows: Signal wire: The turn signal control signal wire of the installed anti-theft system is not properly connected. Fuse: The fuse in the turn signal control wire of the installed anti-theft system is burnt out. No signal: The installed anti-theft system has no output signal for controlling the turn signals. Regarding the indicator light not flashing, possible reasons include: Lock/unlock signal: The installed anti-theft system does not detect the original car motor's lock or unlock signal. Input fault: The ACC signal input in the installed anti-theft system is faulty. Anti-theft system: The installed anti-theft system has failed.
Was this review help?
9
0
Share
More Forum Discussions

How to Connect Bluetooth for Older Nissan Models?

Turn on the Bluetooth headset by pressing and holding the power button until the indicator light flashes alternately in red and blue, indicating it is in pairing mode. Enable the Bluetooth function on your phone and set it to 'Visible to All' to search for Bluetooth devices. Once found, select the device to pair and connect. Enter the pairing password: 0000 on your phone. Successful connection means the pairing is complete.
20
5
Share

How to solve the P1381 fault in old Buick Excelle?

The signal from the wheel speed sensor can be used to determine whether the vehicle is driving on rough roads. If so, you can drive on better roads. This is caused by a fault in the Anti-lock Braking System (ABS) and Traction Control System (TCS). It is recommended to go to a professional repair shop for maintenance.
5
5
Share

How to Use Cruise Control in Older Model Passat?

After accelerating to the desired speed, push the control lever downward to set the cruise speed. To accelerate, push the control lever upward or press the accelerator. After pressing the cruise control master switch, the cruise control icon will appear on the dashboard to indicate standby status. Lightly pressing the brake will cancel the cruise control status.
7
1
Share

How to adjust the wipers on an old Buick GL8?

Turn the key to ACC, turn on the wiper switch to the first intermittent position, which is the slowest setting. When the wipers pause after one sweep, turn off and remove the key. Check whether the gap between the small locking tab of the positioning adjuster and the vertical stop is between 4-8mm. Loosen the nuts on both wiper arms, pull out the left and right wiper arms, adjust the gap, and then tighten them.
6
1
Share

How to Remove the Right Rear Door Lock of an Older Lavida Model?

Before disassembly, first locate the fixing bolts and clips of the door panel and prepare the corresponding tools. Remove the fixing bolts and clips of the door panel one by one, then you can take off the door panel. Carefully remove the adhesive around the sealing film. Disconnect the plug of the central control motor of the door lock, use a wrench to remove the fixing bolts of the door lock in order, and then the door lock can be taken out.
12
0
Share

What are the steps to fold down the rear seats of an old Passat?

First, open the rear door of the vehicle and enter the back seat. Then, you will see two red latches on the rear seats, which are used to secure the position of the rear seats. Press both red latches simultaneously with both hands, then pull the rear seats downward. This will fold down the rear seats. After that, unbuckle the rear seatbelt latches to complete the process of folding down the seats.
19
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.