Why Does the Car Keep Stalling?

3 Answers
LaHailey
07/28/25 9:15am
The main reason for frequent car stalling is the use of low-quality fuel, which leads to carbon buildup in the engine and causes stalling. Here are ways to prevent frequent car stalling: 1. Refuel at reputable and qualified large gas stations. 2. Follow the engine's compression ratio or the requirements in the car's manual when refueling, which is more scientific, economical, and maximizes engine efficiency. 3. Perform regular maintenance and frequently check if the fuel and electrical systems are functioning properly. 4. Higher-octane fuel burns slower, resulting in lower combustion knock, and requires a higher engine compression ratio. Conversely, lower-octane fuel burns faster, produces higher combustion knock, and requires a lower engine compression ratio.
Was this review help?
15
5
Share
DelArianna
08/11/25 3:37pm
My car keeps stalling while driving, which is really annoying. The most common reasons are aging spark plugs or too much carbon buildup. Spark plugs typically need to be replaced every 40,000 kilometers; otherwise, poor ignition can cause the car to stall suddenly. Another possibility is a faulty fuel pump that stops supplying fuel, especially noticeable when going uphill or accelerating. A stuck idle control valve can also cause this, making the engine speed unstable. I once stalled at a red light, which was extremely embarrassing and nearly caused a rear-end collision. So now, during regular maintenance at the shop, I always remind the mechanic to check these areas. Additionally, a clogged air filter or insufficient battery voltage can also lead to stalling, so it's important to clean or replace them promptly to avoid turning small issues into bigger, costlier problems. Finally, using low-quality gasoline can cause fuel line blockages and more issues, so always fill up at reputable gas stations to keep the engine running smoothly.
Was this review help?
18
5
Share
Expand All
DeGiselle
09/28/25 3:45am
Frequent stalling is quite dangerous, especially in busy areas. I've found that when a car stalls suddenly, the first thing to do is to steady the steering wheel, turn on the hazard lights, and gradually slow down to pull over. Common causes include loose battery terminals or alternator failure, which can interrupt power supply and cause stalling. Another possibility is a faulty crankshaft position sensor, which fails to monitor engine speed—this happens particularly often during sharp turns or sudden braking. Once the engine stalls, both power steering and brake assist are lost, increasing the risk of accidents. That's why I always check the battery condition before driving to avoid issues during long trips. Regular maintenance is crucial, such as checking the alternator's output voltage every two years—it should normally be around 13.8V. Additionally, driving on bumpy roads can easily trigger stalling due to poor electrical connections, so a thorough inspection before departure is essential to prioritize safety.
Was this review help?
14
5
Share
Expand All
More Forum Discussions

Where is the radiator located on the Chery Tiggo 3?

The radiator of the Chery Tiggo 3 is located in the engine compartment. When you open the engine hood, there is a round cap near the body side, which is for adding water, and the connected part is the radiator. The car radiator, also known as the heat exchanger, is a key component in the car's cooling system. Its function is to dissipate heat. The coolant absorbs heat in the water jacket, flows to the radiator to release the heat, and then returns to the water jacket to circulate, achieving temperature regulation. The radiator is an integral part of the car engine. In terms of body dimensions, the Chery Tiggo 3 measures 4420mm in length, 1760mm in width, and 1670mm in height, with a wheelbase of 2510mm.
15
0
Share

How to use the navigation system in Leopaard CS10?

The usage method of Leopaard CS10 navigation system: 1. Open the navigation on the multimedia interface of the central control screen; 2. The GPS will automatically search for the owner's location, and then input the name of the destination. The Leopaard CS10 is a compact SUV under Leopaard Motors, with body dimensions of 4663mm in length, 1875mm in width, and 1700mm in height, and a wheelbase of 2700mm. The Leopaard CS10 is equipped with a 1.5T turbocharged engine, paired with a 5-speed manual transmission, continuously variable transmission, and 6-speed dual-clutch transmission, with maximum horsepower of 150 and 177.
4
1
Share

What Causes the Noise When the Car Just Starts Moving?

This is likely the sound generated by the friction between the brake pads and brake discs, which is a normal occurrence. Detailed explanations are as follows: 1. The braking system of a car consists of the master cylinder, vacuum booster, brake caliper, brake pads, and brake discs. When the brake pedal is pressed, the brake pads clamp onto the brake discs, converting kinetic energy into heat to slow down the vehicle. 2. After pressing the brake pedal, the vacuum booster provides assistance, helping the driver to press the pedal more easily. Upon opening the engine hood, a black metal disc can be seen below the windshield on the driver's side—this is the vacuum booster. 3. In front of the vacuum booster is the master cylinder, which has a reservoir for holding brake fluid. The brake caliper, which contains pistons, serves as the brake slave cylinder.
11
5
Share

How to Decelerate a Manual Transmission Car?

The engine is the power system of a car, transmitting power to the transmission through the clutch, which then delivers the power to the drive wheels to move the car. The correct methods for decelerating and braking a manual transmission car are as follows: 1. When the speed is relatively low, generally within 30km/h, first press the brake, then press the clutch. This prevents the engine from stalling when braking at low speeds. At low speeds, since the wheels are not turning fast enough and the engine primarily provides power, the clutch is needed to separate the engine from the transmission when braking. This allows the engine to keep running even when the wheels stop turning. 2. When the speed is relatively high, i.e., above 30km/h, first press the brake to reduce the speed (to 20-30km/h), then simultaneously press the clutch to bring the car to a stop.
8
0
Share

How Long Can Motor Oil Last After Opening the Cap?

Motor oil can last for about half a year after opening the cap. Beyond this period, the oil may deteriorate, leading to a decline in lubrication performance. Motor oil, engine oil, or engine lubricant is a substance enhanced with additives in base oil, primarily containing anti-wear additives, detergents, dispersants, and multi-grade oil viscosity index improvers. Motor oil is used for lubricating internal combustion engines, with its main functions being to reduce friction and wear on moving parts and to remove sludge and varnish from the engine. Methods for preserving motor oil: 1. After maintenance, the remaining oil should be sealed with the cap as soon as possible, preferably sealed with wax; 2. Motor oil is prone to deterioration under light and high temperatures, so the leftover oil should be stored in a cool and dry place to prevent accelerated deterioration; 3. It is recommended to use up the remaining oil within half a year.
7
3
Share

Is the Ferrari F12 rear-wheel drive?

The Ferrari F12 is rear-wheel drive, which is a front-engine, rear-wheel-drive supercar. The Ferrari F12 is equipped with a 6.3-liter V12 naturally aspirated engine, which has a maximum power of 545kW and a maximum torque of 690Nm. The Ferrari 12-cylinder sports car accelerates from 0 to 100km/h in just 3.1 seconds, 0 to 200km/h in 8.5 seconds, and 0 to 300km/h in 21 seconds. The car adopts an aluminum alloy body frame made of various composite materials and utilizes laser welding technology. The car's body dimensions are 4618mm in length, 1942mm in width, and 1273mm in height.
6
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.