Why does the car air conditioner not cool on the driver's side but works normally on the passenger side?

What to Do When the Dash Cam Won't Turn On?

Power supply circuit failure. The power circuit on the dash cam's motherboard is broken, causing normal power supply to fail. Since dash cams usually operate in high-temperature environments, consider whether the components on the circuit board have become loose due to soldering issues. Remove the SD card or TF card, press the power button to confirm if it can turn on. If it still doesn't turn on, look through the side of the device to find the "RESET" hole, gently press it with a soft tool, then press the power button to see if the device starts. If the dash cam starts normally, the issue is with the card. Please format your card. After formatting, reinsert the card. If the problem persists, it is recommended to replace the memory card. Battery power supply or damage. If the dash cam can turn on using an external power source, such as the cigarette lighter socket or a phone charger, then it can be determined that the built-in battery is damaged or the voltage is too low to turn on. Solution: Use an external power source to supply power to the dash cam or replace the built-in battery.

12

4

Share

What Causes Obvious Gear Shift Jerking?

Reasons for obvious gear shift jerking: 1. Mismatch between engine speed and current vehicle speed: There is a speed difference between the engine speed and the clutch plate speed. 2. Malfunction of components such as spark plugs and ignition coils inside the engine: This can cause the car to experience weak acceleration or even severe shaking and jerking while driving. Below are methods to avoid gear shift jerking: 1. Adjust the shift RPM: One of the shifting methods learned in driving school is to first increase the RPM to 2000 before shifting. According to our earlier analysis, some car models may experience jerking when the engine reaches this RPM because the output torque is relatively too high for the power needed by the moving car. Therefore, it is necessary to moderately reduce the engine RPM when shifting, for example, shifting at 1500 RPM. For large-displacement engines or engines with good low-RPM torque, shifting can even be done at a low RPM of 1000-1200 without jerking, and it has little impact on acceleration. So, drivers who frequently experience gear shift jerking can try adjusting (lowering) the engine RPM when shifting to find a point where the shift is smooth and does not affect continued acceleration. 2. Adjust the shifting sequence: The standard shifting sequence is progressive, i.e., 1-2-3-4-5. In some cases, skipping gears can also avoid jerking, such as shifting directly from 2nd gear at 2000 RPM to 4th gear or from 3rd gear directly to 5th gear. This is based on the principle that the output torque of the front section of the power chain roughly matches the torque demand of the rear section, and it is often used more during acceleration on highways or flat roads. 3. Shorten the shifting time: If the traditional two-step shifting method (first press the clutch to disengage the gear, then press the clutch again to engage the gear) is used, the longer shifting time can cause the engine RPM to drop too much, resulting in jerking. Using the one-step method (pressing the clutch to disengage and engage the gear continuously) can shorten the entire shifting time, and the smaller drop in engine RPM can avoid jerking.

18

5

Share

Why is the car display screen not lighting up?

There are many reasons why a car display screen may not light up. It could be an issue with the vehicle's power supply system, incompatibility between third-party software and the system, or damage to the display screen itself. These issues need to be checked one by one. When this happens, it's best to take the car to an auto repair shop or a 4S store for inspection, where diagnostic computers can be used to troubleshoot electrical equipment and replace the display screen if necessary. If the issue is related to power supply, it might be due to severe battery depletion or unstable battery voltage causing malfunctions in the vehicle's electrical equipment. A multimeter can be used to check the battery voltage. During use, car display screens may experience aging, with many lines showing signs of wear. This can also lead to a black screen, and it is recommended to replace the wiring promptly. If there is no image but sound is still coming from the car display, it might be due to a loose power plug in the navigation display. In such cases, it's advisable to check the wiring harness interface. The car display screen is very prone to damage, so care should be taken not to overuse it.

15

1

Share

What is the history of the Mercedes-Benz brand?

The brand history of Mercedes-Benz is as follows: 1. The origin of Mercedes-Benz Automobile Company: On January 29, 1886, Karl Benz, the founder of Benz & Cie., invented his first gasoline-powered three-wheeler and applied for a patent, marking the birth of the automobile. In the same year, Gottlieb Daimler also test-drove his first four-wheel gasoline car. Later, in recognition of their contributions, they were honored as the "Fathers of the Automobile," and January 29 was designated as the World Automobile Birth Day. In 1894, Benz & Cie. produced the world's first gasoline-powered bus, and in 1896, Daimler-Motoren-Gesellschaft (DMG) produced the world's first gasoline-powered truck. After World War I, during the economic depression, Ford's versatile passenger and cargo vehicles became popular in the market. To reduce mutual competition and cope with the market crisis, Benz & Cie. and DMG announced a merger, forming "Daimler-Benz Automobile Company," which is now known as Mercedes-Benz. 2. The origin of the name "Mercedes-Benz": Mercedes was the name of the beautiful daughter of a DMG dealer named Emil Jellinek. This dealer had a penchant for extreme speed. In 1899, she drove a custom-built high-end DMG car to victory in a car rally. The dealer believed that this success was not only due to DMG's car but also to his daughter, Mercedes Jellinek. He then suggested, as a condition for purchasing cars, that DMG name its cars after his daughter. DMG gladly accepted. After the name change, car sales increased significantly. Thus, after the merger of DMG and Benz & Cie., the name "Mercedes-Benz" was adopted. 3. The origin of the Mercedes-Benz logo: Early DMG cars used a three-pointed star as their emblem, inspired by a letter Daimler wrote to his wife. He believed that the star on his house's roof would bring him good luck, and the three-pointed star symbolized DMG's expansion into land, sea, and air. Later, to celebrate the mass production of its VELO model, DMG replaced the gear inside the circle with laurel branches. Benz initially used a logo with "BENZ" surrounded by wheat ears. After the merger, the logo featured a three-pointed star, wheat ears, and "Mercedes-Benz." Later, the wheat ears were replaced by a circle, and the English lettering was removed, evolving into the current logo we see today.

12

5

Share

What are the differences between Subject 1 and Subject 4?

The main differences between Subject 1 and Subject 4 include: number of test questions, question types, content distribution, and focus areas. The information is based on the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses". Number of test questions: The most obvious difference between Subject 1 and Subject 4 is the number of questions. Subject 1 has 100 questions, while Subject 4 only has 50 questions. In Subject 1, the test automatically submits when more than 10 questions are answered incorrectly, while in Subject 4, it submits when more than 6 questions are answered incorrectly. Question types: Subject 1 consists of 100 questions, each worth 1 point, with a total test time of 45 minutes. The question types are true/false and single-choice questions, with a full score of 100. Subject 4 consists of 50 questions, each worth 2 points, with a test time of 45 minutes. The questions are mainly presented in the form of case studies, images, and animations, with question types including true/false, single-choice, and multiple-choice questions, also with a full score of 100. Focus areas: Subject 1 mainly assesses basic knowledge of road driving, while Subject 4 focuses on safe and civilized driving knowledge. It can be understood this way: Subject 1 tests how to drive, while Subject 4 tests how to drive safely. Although the difference is just two words ("safe"), the focus is completely different. Content distribution: Subject 1 test content breakdown: driver's license and motor vehicle regulations account for 20%; road traffic conditions and regulations account for 25%; traffic safety violations and penalties account for 25%; traffic accident handling regulations account for 10%; basic motor vehicle knowledge accounts for 10%; local regulations account for 10%. Subject 4 test content breakdown: safe driving knowledge accounts for 20%; civilized driving knowledge accounts for 18%; comprehensive application of traffic signals in traffic scenarios accounts for 8%; safe driving knowledge under adverse weather and complex road conditions accounts for 16%; emergency avoidance knowledge accounts for 12%; typical accident case analysis accounts for 6%; traffic accident rescue and common hazardous chemical handling knowledge accounts for 10%; local test questions account for 10%. There is no limit to the number of attempts for Subject 1 and Subject 4 in the driving test. If the test is failed, it can be rescheduled. Each scheduled test has two attempts. If both attempts fail, the test must be retaken until it is passed. Both Subject 1 and Subject 4 are theoretical tests and are part of the motor vehicle driver's license assessment. The driving test consists of 3 subjects: Subject 1, Subject 2, and Subject 3. Subject 1 refers to the road traffic safety laws, regulations, and related knowledge test; Subject 2 refers to the field driving skills test; Subject 3 is divided into two parts, referring to the road driving skills and safe and civilized driving knowledge test. The safe and civilized driving knowledge test is conducted after Subject 3, so it is commonly referred to as Subject 4. However, in the official terminology (i.e., the Ministry of Public Security's Order No. 123), there is no such term as Subject 4.

18

5

Share

Is the maintenance of Focus expensive?

Whether the maintenance and repair of Focus is expensive or not depends on the car owner. In regular maintenance, choosing different engine oils will result in varying prices. Here is a partial introduction about car maintenance: 1. Car maintenance refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. 2. Car maintenance mainly includes the maintenance scope of the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc.

19

0

Share

Why does the car air conditioner not cool on the driver's side but works normally on the passenger side?

What to Do When the Dash Cam Won't Turn On?

What Causes Obvious Gear Shift Jerking?

Why is the car display screen not lighting up?

What is the history of the Mercedes-Benz brand?

What are the differences between Subject 1 and Subject 4?

Is the maintenance of Focus expensive?

How Long After a Full Car Paint Job Can You Wash the Car?

What Are the Advantages of Steel Car Wheel Hubs?

What are the differences between a two-box car and a three-box car?

What does ff mean on a car?