···
Log in / Register

Why does the Buick Excelle not respond when stepping on the accelerator?

4 Answers
Rosalie
07/29/25 8:12pm

It should be a problem with the transmission. Electronic throttle accelerator: The electronic throttle accelerator makes the throttle response more sensitive and provides faster acceleration. Since power is directly proportional to fuel consumption, it will relatively consume a bit more fuel. No load on the car: No load on the car. The electronic throttle accelerator does not modify the car's circuit or fuel system, so it will not impose any load on the car. It can be said to cause zero damage to the car. Regular use of the accelerator can also reduce engine carbon deposits. Modern accelerators are quite intelligent, allowing you to adjust the speed as desired—faster or slower—without any issues regardless of the road conditions.

Was this review help?
15
1
Share
McEsther
08/14/25 4:33pm

With years of experience in car repair, I've seen the issue of no response when stepping on the accelerator in the Buick Excelle all too often. The most common cause is the aging or water ingress of the throttle pedal position sensor, leading to signal failure. If the signal doesn't reach the computer, acceleration is lost. Carbon buildup in the throttle body is another major culprit—frequent stop-and-go in city driving easily accumulates grime, blocking airflow; regular cleaning can resolve this. Fuel system issues are also common, such as a damaged fuel pump or clogged fuel filter, preventing gasoline from reaching the engine. A faulty brake light switch might trigger safety restrictions, mistakenly interpreting it as you stepping on the brake. Safety first: if this happens, immediately pull over, turn on hazard lights, and stop for inspection. It's recommended to clean the throttle body every six months for maintenance—it's a small cost but effective prevention.

Was this review help?
8
5
Share
Expand All
VanPhoebe
10/16/25 3:08am

Having driven a Buick Excelle for over a decade, I've personally experienced throttle issues multiple times. The electronic control system is crucial—when the pedal sensor or throttle position sensor fails and interrupts the signal, the ECU can't receive commands. Insufficient fuel supply is also common, with fuel pump failures or clogged filters causing delayed fuel delivery. Occasionally, a power reset can temporarily resolve sporadic engine computer faults. For safety, if the throttle fails, gradually pull over to the roadside rather than pushing through. I remember the last time this happened, adding fuel system cleaner helped, and now it's mostly stable. For prevention, inspecting the fuel system during every service is the best investment to catch initial issues.

Was this review help?
19
3
Share
Expand All
AddysonFitz
11/29/25 3:56am

When the throttle suddenly becomes unresponsive, my primary concern is safety risks. Immediately release the accelerator, gently apply the brakes, pull over to the side of the road, and turn on the hazard lights. Common causes for the Buick Excelle include sensor failure or fuel line interruption, while carbon buildup in the throttle body can lead to loss of power. Avoid forcing the vehicle to continue driving to prevent accidents. After the malfunction, contact a professional repair shop. Addressing minor details can prevent major issues.

Was this review help?
17
3
Share
Expand All
More Forum Discussions

What is the Best Material for Spark Plugs?

Spark plugs made of platinum and iridium are considered the best materials. Components of a Spark Plug: A spark plug mainly consists of a terminal nut, insulator, terminal stud, center electrode, side electrode, and shell. Types of Spark Plugs: The main types of spark plugs include: standard spark plugs, projected insulator spark plugs, electrode-type spark plugs, seat-type spark plugs, pole-type spark plugs, and surface-gap spark plugs. Working Principle of Spark Plugs: Under high voltage, the air between the center electrode and side electrode of the spark plug rapidly ionizes, forming positively charged ions and negatively charged free electrons. When the voltage between the electrodes reaches a certain level, the number of ions and electrons in the gas increases like an avalanche, causing the air to lose its insulating properties and forming a discharge channel in the gap, resulting in a "breakdown" phenomenon. At this point, the gas becomes a luminous body, known as a "spark." Along with thermal expansion, a "crackling" sound is also produced. The temperature of this electric spark can reach as high as 2000-3000°C, which is sufficient to ignite the air-fuel mixture in the engine's combustion chamber.
15
5
Share

At what mileage should fuel additives start to be used?

Fuel additives should start to be used at 20,000 kilometers. Mileage for using fuel additives: Fuel additives are unnecessary for new vehicles with less than 20,000 kilometers. For vehicles exceeding 20,000 kilometers, they should be added as needed, typically one small bottle per tank of fuel. Long-term use of fuel additives can be harmful to the engine. Excessive use can increase carbon deposits in the combustion chamber, and prolonged overuse may even lead to engine knocking, detonation, and worsened vehicle emissions. Precautions for using fuel additives: New vehicles are not recommended to add fuel additives because they haven't been driven much, and their operating conditions are usually good, with no serious carbon deposits, so additives are unnecessary. Frequent use of fuel additives is not advisable, as it can lead to oil sludge and gum formation, increasing carbon deposits in the combustion chamber. They should be added based on the vehicle's usage. For severe carbon deposits, manual cleaning is still required; fuel additives are not a miracle solution. For vehicles with severe carbon deposits, manual treatment is necessary, as fuel additives cannot completely remove them. For older vehicles, the oil filter should be cleaned or replaced before adding fuel additives. Use fuel additives cautiously and add them reasonably according to the vehicle's condition.
20
5
Share

What are the maintenance items for the Mercedes-Benz E230C?

Mercedes-Benz E230C maintenance items include engine oil level check, engine coolant level check, brake fluid level check, and clutch master cylinder fluid level check. Introduction to car maintenance: Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. Scope of car maintenance: Modern car maintenance mainly includes the engine system (engine), transmission system, air conditioning system, cooling system, fuel system, power steering system, and other maintenance scopes.
16
5
Share

What does it mean when the electric car charger shows a yellow light?

Electric vehicle charging showing a yellow light may be due to the battery being fully charged and not requiring further charging. It could also indicate damage to the electric vehicle's battery or the charger itself. Below is additional information: Specific reasons: When the electric vehicle charger is first plugged in, it shows a red light (indicating charging is in progress), then switches to a yellow light (indicating a false full charge). Continuing to charge for one to two hours will result in a true full charge. If this is the case, there is no need to worry as it is a normal part of the charging process; the electric vehicle is only falsely indicating a full charge. Precautions: Avoid storing the battery in a depleted state. A depleted state refers to when the battery is not charged promptly after use. In this state, sulfation is likely to occur, with lead sulfate crystals adhering to the plates, blocking ion channels, leading to insufficient charging and reduced battery capacity. The longer the battery remains idle in a depleted state, the more severe the damage. When the battery is not in use, it should be charged once a month to extend its lifespan. Regular inspection: Regular checks are essential. If the electric bicycle's range suddenly drops by more than ten kilometers in a short period during use, it is highly likely that at least one battery in the pack has issues such as broken cells, softened plates, or shedding of active material from the plates, causing a short circuit. In such cases, promptly visit a professional battery repair facility for inspection, repair, or replacement.
18
0
Share

Why does the AC light turn on automatically when the heater is on?

The reasons why the AC light turns on automatically when the heater is on are as follows: 1. It is caused by turning on the windshield defogger switch. 2. It is due to the design by the manufacturer's engineers. Simply press the AC button to turn it off, which will not affect the use of the car heater. Precautions for using the car heater: 1. Turning on the heater will increase fuel consumption. The car heater and air conditioner operate on completely different principles. When turning on the heater, do not press the A/C button, as it is the compressor start button. Simply adjust the air volume to blow out warm air. 2. Do not turn on the heater immediately after starting the engine. It is recommended to drive for a while until the water temperature gauge reaches the middle position or the blue indicator light goes off before using the heater. It is also advisable to first turn on the external circulation to expel the cold air inside the car, then switch to internal circulation after a few minutes to enjoy the warm air. 3. When fog forms inside the car, you can adjust the heater's airflow direction to blow toward the windshield. The warm air will quickly dry the moisture on the glass, and as the glass temperature rises, the fog will no longer condense. 4. Turn off the heater before shutting down the engine, as prolonged use can damage the engine and shorten its lifespan. 5. During winter, the car interior is often in a sealed state. It is recommended to replace the air filter in advance to prevent respiratory diseases.
15
5
Share

Does the Teana have an automatic window roll-up function after locking the car?

Teana has an automatic window roll-up function after locking the car. You need to click the OK button on the left side of the multifunction steering wheel to manually complete the one-touch window roll-up and down function setting. Advantages of automatic window roll-up after locking the car: It can effectively protect the safety of the motor vehicle. Timely window roll-up can avoid property loss and also prevent water from entering the vehicle. Disadvantages of automatic window roll-up after locking the car: First is the installation of the automatic window roller. Some window rollers involve high-risk operations such as wire cutting. The working principle of the automatic window roller is that after locking the car, it automatically supplies power to each window motor to roll up and close the window. Since each time the car is locked means the window motor will be powered, this cycle will definitely cause damage to the vehicle.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.