
The reasons why the air conditioner stops working after replacing the car battery are as follows: Damaged air conditioning compressor: It may be due to damage to the air conditioning compressor, throttle valve, or expansion valve. 'Low pressure high, high pressure low means the compressor needs replacement.' The probability of the air conditioning compressor being damaged is not high, but faults in the expansion valve and throttle valve can directly lead to poor air conditioning cooling. Lack of refrigerant: Since the sealing device of the air conditioner is not absolutely airtight, the refrigerant in the air conditioner generally escapes. Therefore, it is usually necessary to add refrigerant every 2~3 years for most vehicles. Some cars may even require annual refills. If the car's air conditioning shows poor cooling performance, and after refilling the refrigerant, it starts to perform poorly again after some time.

I've been driving for over twenty years, and it's quite common to encounter the issue of the air conditioning not working after replacing the battery. This is mainly because the power interruption during the battery replacement causes the air conditioning control computer to reset or forget its settings. First, you should check if the fuse is blown, especially the one in the box near the battery, as the wrench can easily cause a short circuit and burn the fuse during the replacement. A simple solution is to turn off the car key, remove the negative terminal of the battery, wait for ten minutes, and then reconnect it to perform a hard reset of the entire vehicle system. Often, the air conditioning will return to normal. If it still doesn't work, check if the battery terminals are loose or not tightened properly, affecting the power supply, or if the air conditioning relay is stuck. Don't ignore this issue—driving without air conditioning in the summer is uncomfortable and dangerous. It's recommended to take the car directly to a repair shop to check if there are any fault codes in the control unit. To prevent such minor issues in the future, always turn off all switches before replacing the battery. Developing good habits can save you money and hassle.

As a DIY enthusiast, I often tinker with my car at home. It's quite common for the AC to stop working after installing a new battery. The first thing that comes to mind is a blown fuse—metal tools scraping against wires during battery replacement can instantly burn it out. The engine compartment fuse box location is specified in the manual; just locate the AC fuse and replace it with a spare. Next, the AC system needs reinitialization—simply disconnect the negative battery terminal for five minutes and reconnect it. After the system resets, it usually works fine. If the battery isn't installed securely, like loose terminals causing unstable power supply, the AC may also fail. If DIY doesn't solve it, don't force it—keep basic tools to check voltage; normal readings should be above 12 volts, otherwise the battery might be faulty. The joy of car repair lies in hands-on practice, but since AC involves computer systems, it's wise to leave some room for professional repairs—don't skimp on small costs and risk bigger issues.

I just learned to drive not long ago, and after replacing the battery, the air conditioning stopped working, which really stressed me out. Experienced drivers told me that the air conditioning controller might have crashed after the power was cut off, so I should first check if the fuse is blown—the owner's manual has diagrams to locate it. To save money, I can try disconnecting the battery cables for a while and then reconnecting them to reset the system. If that doesn’t work, don’t force it—just drive to the 4S shop and spend a little money to have it checked. They have diagnostic computers to identify controller issues. After all, not having air conditioning affects driving comfort, so safety comes first—don’t delay until the problem worsens. It’s good to learn more daily car maintenance tips to prevent issues.


