Why Do Ten-Year-Old Cars Consume More Fuel?

1 Answers
GiselleFitz
07/25/25 2:54am
Reasons why ten-year-old cars consume more fuel: 1. Frequent braking and acceleration: Apart from factors like car design and engine, the real culprit behind fuel wastage is the driver's habits. Frequent sudden braking and rapid acceleration are the biggest contributors to increased fuel consumption. 2. High speed in low gear: Never stick to a single gear for convenience and rely solely on the throttle to achieve high speed. One of the biggest driving misconceptions is driving at high speeds in low gears. 3. Insufficient tire pressure: The first thing to check when fuel consumption rises is the vehicle's tires. Ensure the tire pressure meets the standard and check for any wear. Low tire pressure and worn tires increase rolling resistance, leading to higher fuel consumption. 4. Prolonged idling: Many drivers keep the engine idling with the AC on while waiting, unaware that this significantly increases fuel consumption. Besides wasting fuel, prolonged idling can also cause carbon buildup. Therefore, it's recommended to turn off the engine if parked for an extended period. 5. Installing wider tires: Everyone loves aesthetics, and while dressing up themselves, some car owners also like to modify their cars. 6. Speeding: Speeding requires generous fuel input, which naturally leads to higher fuel consumption. More importantly, speeding poses serious safety risks, as it may prevent timely avoidance of hazards. Speeding is harmful in every way and must be strictly avoided.
Was this review help?
5
2
Share
More Forum Discussions

Can You Still Drive with Transmission Slippage?

Transmission slippage should not be ignored, and driving under such conditions is unsafe due to potential hazards. The causes of transmission slippage are as follows: 1. Severe wear of the clutch, brake, or one-way clutch, leading to slippage. 2. Addition or replacement with non-specified oil. Using different types of fluids can alter the friction coefficient of the transmission—increasing it may cause gear shift impacts, while decreasing it may result in slippage. Some inferior fluids can also cause aging, swelling, or failure of internal seals, leading to slippage. 3. Slippage caused by low main oil pressure. Low automatic transmission fluid level, clogged filter, severely worn oil pump, main oil circuit leakage, or malfunctioning main pressure regulator or pressure control solenoid valve can all lead to low main oil pressure, which in turn can cause slippage and burning of multiple actuating components.
18
3
Share

What is the Definition of a Joint Venture Car?

Joint venture cars refer to projects jointly established by Chinese and foreign investors, where the Chinese side provides the site, capital, and labor, while the foreign side provides technology and brand authorization. Relevant details are as follows: 1. Different brands offer different contributions. Some vehicles may be purely domestically produced, with all parts processed and manufactured domestically, while only the brand and technology are provided by foreign partners. 2. Some brands use imported parts assembled domestically, or some parts are produced domestically while key components are imported from abroad. Generally, joint venture cars have clear logos on the upper part of the trunk, indicating the abbreviations of the domestic and foreign automakers, such as FAW Toyota, FAW Volkswagen, GAC Toyota, and Dongfeng Honda. Domestic models and purely imported models do not have such logos.
19
1
Share

How to Repair a Faulty Automatic Transmission?

Here are the repair methods for automatic transmission failures: 1. Faulty electronic components in the transmission: Solution: Computer diagnosis and replacement of damaged electronic components. 2. Severe wear of mechanical components in the transmission: Solution: Repair the damaged mechanical components. 3. The engine or ABS sends incorrect signals, interfering with the transmission: Solution: Inspect the engine and ABS, and repair the damaged electrical components. 4. Oil leakage: Solution: If oil is seeping from the transmission housing or oil pan, it could be due to aging seals causing poor sealing or manufacturing defects leading to porosity in the housing. Replace the corresponding parts. Transmission usage precautions: 1. Water ingress in the transmission is very subtle and hard to detect. By the time the vehicle shows abnormal behavior, the transmission may already be severely damaged. If coolant is frequently low without external leaks or there are oil traces in the coolant, it could indicate water ingress in the transmission. This must be taken seriously and repaired promptly. 2. If you hear unusual noises from the transmission while driving, and the noise increases with engine speed or vehicle speed, stop immediately for inspection and repair to avoid further damage.
12
3
Share

How many years can the original car battery last?

The service life of the original car battery is 3 to 4 years, while the service life of ordinary car batteries is generally 2-3 years. The service life of the battery is related to the vehicle's configuration and electrical equipment. For example, configurations such as navigation, multi-screen information display, remote control anti-theft, etc., with numerous vehicle functions, continue to consume power even when the vehicle is turned off, leading to prolonged battery discharge and reducing the battery's service life. The battery is most afraid of low temperatures. In low-temperature environments, the battery's capacity is much lower than at normal temperatures. Therefore, timely inspection and maintenance are essential. In daily life, pay attention to the following: 1. Avoid parking the car in an open parking lot for long periods. If parked for an extended time, remove the battery to prevent freezing damage. 2. In winter, the car engine is harder to start. Each start attempt should not exceed 5 seconds, with an interval of no less than 15 seconds between attempts. If the car fails to start after multiple attempts, check other aspects such as the circuit, ignition coil, or fuel system to avoid continuous unsuccessful starts that may cause the battery to over-discharge and burn out. 3. The car battery should be charged regularly. A battery left unused will slowly self-discharge until it is scrapped. Therefore, start the car periodically to charge the battery. 4. Clean the battery terminals regularly and apply special grease to protect the wiring harness. 5. Avoid using car electrical appliances after the engine is turned off. Using the battery alone when the engine is not generating power can cause damage.
12
3
Share

Can the Car Still Be Driven When the Engine Warning Light Is On?

The engine warning light comes in two colors: yellow and red. When the yellow warning light is on, you can continue driving. When the red warning light is on, you must stop driving immediately. When the yellow warning light is on, it serves as a warning, indicating that certain system parameters of the car may be outside the set range. The car can still be driven at this time, but some functions may be limited. When the red warning light is on, it means the fault is severe. The car must be stopped immediately, the engine turned off, and driving must not continue. The issue causing the fault should be checked. There are seven main reasons why the engine warning light may come on: 1. Sensor malfunction: This includes sensors such as the coolant temperature sensor, crankshaft position sensor, air flow sensor, intake air temperature sensor, and oxygen sensor. If these sensors are damaged, have poor contact, or their signals are interrupted, the car's ECU cannot accurately obtain engine data, triggering the engine warning light. 2. Fuel or oil quality issues: If the fuel or engine oil does not meet the manufacturer's specifications, it may cause engine wear and trigger the warning light. 3. Poor fuel mixture combustion: Poor combustion can lead to engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the warning light will illuminate. Issues such as faulty spark plugs, ignition coils, fuel pumps, or clogged fuel lines can cause poor combustion. 4. Turbocharger problems: Issues with the intake boost pipes or turbocharger can also trigger the engine warning light. The most common issue is a damaged turbocharger, accompanied by symptoms like oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. 5. Intake problems: If the car's intake system is compromised, it may lead to clogged engine pipes, and in severe cases, trigger the warning light. A dirty or uncleaned air filter can cause intake issues. 6. Exhaust problems: Exhaust system faults can also trigger the warning light. Common causes include faulty rear oxygen sensors, catalytic converters, exhaust camshafts, or bearings. The catalytic converter is the most frequent culprit. Using leaded gasoline, lead- or silicon-based oil additives, physical damage to the catalytic converter, or fuel system issues can all lead to catalytic converter failure. 7. Anti-theft system malfunction: If the car's electronic anti-theft system fails or the anti-theft controller does not match the engine ECU, the anti-theft system may prevent the engine from operating normally, triggering the warning light. If the engine warning light comes on, follow these steps: 1. First, check if the engine is running normally. Look for signs of shaking, smoke, etc. If present, avoid restarting the engine. Note: If the red light is on, do not restart the engine under any circumstances. 2. If the engine can start, turn it off and wait 5-10 minutes. Without pressing the brake, press the start button once or turn the key halfway to the 'ON' position (without pressing the clutch). The car will enter self-diagnosis mode. Wait 5-10 seconds and observe if the warning light turns off. 3. If the warning light remains on, visit a service center as soon as possible. Technicians can use a diagnostic tool to read the fault code, identify the issue, and perform targeted repairs.
20
5
Share

What are the test items for Shanghai Driver's License Subject 2?

Shanghai Subject 2 test items include: 1. Reverse parking; 2. Right-angle turn; 3. Parallel parking; 4. Tunnel driving; 5. Stop and pick up the card; 6. Curve driving; 7. Narrow road U-turn; 8. Emergency stop; 9. Hill start and stop. The following situations will result in a failing grade: 1. Not using the seat belt as required; 2. Blocking or turning off the in-car audio and video monitoring equipment; 3. Not following the examiner's instructions; 4. Incorrect use of lights, wipers, or other vehicle controls; 5. Vehicle rolling back more than 30cm when starting; 6. Both hands leaving the steering wheel while driving; 7. Gear and speed mismatch for a long time, causing the engine speed to be too high or too low; 8. Looking down at the gear or failing to engage the gear twice in a row while driving; 9. Coasting in neutral while driving; 10. Not taking safety measures such as slowing down or honking in potentially dangerous situations; 11. Inability to maintain a safe distance and speed while driving.
19
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.