Why Do People Buy Ford Despite Its High Fuel Consumption?

What are the techniques for coordinating the clutch and accelerator in Driving Test Subject 3?

Driving Test Subject 3 clutch and accelerator coordination techniques are as follows: when shifting from a high gear to a low gear, perform the following actions swiftly—first, press the clutch pedal while simultaneously releasing the accelerator pedal, move the gear lever to the neutral position, quickly lift the clutch pedal while rapidly pressing the accelerator pedal once and then immediately releasing it (this 'empty throttle' action is to increase the engine speed to drive the transmission input gear speed), then swiftly press the clutch pedal again and shift the gear lever to the lower gear position. Poor coordination between the clutch and accelerator when starting the car can cause the engine to stall or the car to jerk during takeoff. The engine power is transmitted to the wheels via the clutch, with only a 1cm travel distance reflected on the clutch pedal. Therefore, after pressing the clutch pedal and engaging the gear, when lifting the clutch pedal to the point where the clutch friction plates begin to make contact, pause briefly at this position while simultaneously pressing the accelerator. Wait until the clutch plates are fully engaged before completely releasing the clutch pedal. This technique is called 'two fast, one slow'—the initial and final stages of lifting the pedal should be slightly faster, while the middle stage should be slower. During normal driving, do not rest your foot on the clutch pedal. Avoid using the clutch in a semi-engaged state while driving. If semi-engagement is necessary under special circumstances, minimize the duration to prevent burning out the clutch friction plates. The speed of releasing the clutch should not be too fast—generally slowest in first gear and slightly faster in other forward gears. When starting in first gear, the clutch pedal must be fully depressed. For subsequent upshifts, the clutch pedal only needs to be pressed enough to disengage the clutch friction plates before shifting, without requiring full depression.

19

3

Share

What is the purpose of the car HDMI interface?

HDMI and USB can be interconnected, allowing navigation from your phone to be projected onto the screen. Here is an introduction to the uses of the car HDMI interface: 1. Connection method: The method is very simple. Just plug in the corresponding interfaces, and both the phone and the car screen will prompt that they are connecting. No additional drivers need to be downloaded. Wait a few seconds, and the phone screen will be mirrored onto the car screen. If there is no response, you may need to restart your phone. 2. Advantages: Using an MHL cable for connection is simple and convenient, supports high-definition, does not require a smart TV or internet, and most importantly, it won’t experience screen tearing or instability.

15

0

Share

What are the steps to take after a car accident?

After a minor accident, the first thing to do is to turn on the vehicle's hazard warning lights and set up a hazard warning sign behind the car to prevent rear-end collisions. After setting up the warning sign, the next step is to preliminarily determine the responsibility of both parties involved in the accident. If an agreement cannot be reached, it is necessary to call the police and wait for the traffic police to determine liability. For photos, you need one panoramic photo that shows the location of the accident and several close-up photos of the parts of the vehicles that came into contact. After taking photos, check the other party's driver's license and vehicle documents, which include the license plate, annual inspection, vehicle registration certificate, and compulsory traffic insurance. After completing the above steps, both parties can call their respective insurance companies to report the accident, including the time it occurred.

2

4

Share

How Should One Go About Purchasing a Car?

If buying a car with a loan, the general process is as follows: After paying a deposit, sign the purchase agreement, then proceed with the loan application. Once the loan is approved, the dealership will notify you to pay the down payment and inspect the car. After 3-5 days, when the bank disburses the loan to the dealership, they will help you with the license plate registration, after which you can take delivery of the car. If you're only purchasing the bare car (without additional services), you can inspect the car after payment and drive it away immediately. You will need to handle the insurance and purchase tax yourself, as well as register the license plate. If you're paying the full amount upfront, the dealership can assist with the license plate registration process, and you can take delivery once that's completed. First, select one or several car models within your budget, then check online if these models are participating in the current auto show (not all car brands and models participate). After choosing a model, visit the auto show and locate the display booth for your preferred model. Conduct a comprehensive comparison and evaluation before finalizing your choice. Consider which features are most important to you (this requires some experience with car rentals), then compare the owner prices for similar configurations across different models. Assess the rationality of the configuration choices. This approach is far more scientific than selecting a car based solely on the starting price. Some base models may be simpler but include all essential features, while others clearly require mid-to-high trims to be worthwhile. Don't fall for the myth that wheelbase alone determines interior space and vehicle class. Wheelbase is meaningful when comparing different body types, such as hatchbacks vs. sedans or sedans vs. SUVs, and it also affects seating arrangement. Personally, I prioritize overall length, followed by width and height. For sedans, interior space is primarily allocated to mechanical components like the powertrain, passenger space, and trunk space. The wheelbase position doesn’t vary much. The same goes for engine types, transmission systems, suspension setups, and four-wheel-drive configurations.

1

4

Share

Why Does the Car Sometimes Fail to Start?

There could be either human-related reasons or vehicle usage issues that cause a car to fail to start. Below are the possible reasons for a car not starting: 1. Human-related reasons: (1) Dead battery: This could be due to leaving headlights on for an extended period, resulting in a drained battery, or the battery's lifespan has expired. It is generally recommended to replace the battery every 2 years. Additionally, installing xenon headlights, high-power audio systems, or DVD players can also cause electrical circuit failures in the vehicle. Checking for a dead battery is simple—just press the horn to find out. (2) Incorrect gear position: For automatic transmission cars, the gear must be in P (Park) or N (Neutral) to start the engine. If it is in R (Reverse) or D (Drive), the car will not start. Some manual transmission cars may also fail to start if the clutch is not depressed. 2. Vehicle usage reasons: Improper fuel, lack of antifreeze, or excessive carbon buildup: Apart from human operational errors, other complex issues could include starter motor failure, fuel pump supply problems, injector issues, or sensor malfunctions. In such cases, professional assistance is required.

16

5

Share

How Many Years Should a New Car Go for Inspection?

For private passenger vehicles (excluding those with 7 seats or fewer) within 6 years of use, they are exempt from on-site inspection line testing. This means that new cars still need to undergo an initial test every two years, but are exempt from two on-site line tests in the second and fourth years. As long as you submit the annual vehicle and vessel tax payment certificate and compulsory traffic insurance certificate each year, and after handling any traffic accidents and traffic safety violations, you can directly receive the inspection compliance label. It is important to note that if your vehicle is involved in a traffic accident causing casualties during this period, you still need to undergo inspection as per the original regulations (i.e., on-site line testing). Additionally, private passenger vehicles aged 6 to 15 years must be inspected once a year, and those over 15 years must be inspected every six months. On the basis of exempting non-commercial small passenger vehicles with 6 seats or fewer from inspection within 6 years, the exemption scope is further expanded to include non-commercial small passenger vehicles with 7-9 seats (excluding vans) within 6 years. The exemption scope for the first six years is expanded, allowing 7-9 seat vehicles to be exempt from on-site inspection within six years. For non-commercial small passenger vehicles (excluding vans) aged between 6 and 10 years, the inspection cycle is relaxed from once a year to once every two years, meaning private cars only need on-site inspection twice in 10 years, specifically in the 6th and 8th years. If the new car inspection is for private car procedures, no on-site inspection is required in the first six years. Every two years, you can go to the registration service station under the local vehicle management office to collect the annual inspection label. In the new car inspection regulations, six items have been removed: dynamic inspection, speedometer error detection, interior noise detection, electronic parking brake detection, headlight deviation detection, and suspension detection. Two new inspection items have been added: tire tread depth detection and vehicle wheelbase detection. New cars must undergo verification every two years within the first six years. The driving license indicates the verification validity period (the effective date here refers to the end of the month), and verification can be done up to 90 days in advance.

1

4

Share

Why Do People Buy Ford Despite Its High Fuel Consumption?

What are the techniques for coordinating the clutch and accelerator in Driving Test Subject 3?

What is the purpose of the car HDMI interface?

What are the steps to take after a car accident?

How Should One Go About Purchasing a Car?

Why Does the Car Sometimes Fail to Start?

How Many Years Should a New Car Go for Inspection?

Has the Sail been discontinued?

What are the precautions for replacing start-stop batteries?

Can You Make a U-Turn at an Intersection with Time-Restricted No Left Turn?

What does MIC mean on a car?