Why can't the USB drive be opened in the Lynk & Co 01?
3 Answers
The issue of the USB drive not opening in the Lynk & Co 01 might be due to an incorrect USB drive format or the wrong placement of songs. It could also be a problem with the USB drive itself. It is recommended to reformat the USB drive to FAT32, download music in MP3 format, or try a new, smaller-capacity USB drive. If the problem persists, it is advisable to visit a 4S shop to check the USB interface. The dimensions of the Lynk & Co 01 are 4549 mm in length, 1860 mm in width, and 1689 mm in height, with a wheelbase of 2734 mm. The front suspension type is MacPherson independent suspension, and the rear suspension type is multi-link independent suspension, with a unibody structure.
When encountering issues with the Lynk & Co 01's USB drive not opening, here's some experience I've gathered after driving this car for several years. The USB drive itself might be improperly formatted—the Lynk system typically only supports USB drives in FAT32 format, and drives exceeding 64GB capacity may not be readable. Try switching to a USB drive with 32GB or less. If the USB drive is damaged or contains too many files, problems can also arise. First, try formatting it on a computer or testing with a backup drive. The USB ports don’t supply power when the vehicle is off, so ensure the engine is running. If the system software is unresponsive, restart the vehicle or disconnect the negative battery terminal for one minute before reconnecting. If dust inside the car is blocking the port, clean it gently with a soft brush—avoid using high-pressure air cans to prevent damaging the interface. This issue isn’t hard to fix, but it can disrupt music and navigation. For daily use, opt for reliable USB drive brands and minimize frequent plugging/unplugging to reduce wear.
I've looked into the issue of USB drives not being readable in the Lynk & Co 01. Start with the simplest steps. First, confirm that the USB drive works properly on other devices. If it does, then you can rule out a faulty USB drive. The USB port might have poor contact—if you don't hear a click when inserting the drive, it might not be plugged in tightly. Try a few more times or switch to the other port. If dust in the port affects the connection, gently clean it with a cotton swab dipped in alcohol and wait for it to dry before trying again. Sometimes, the vehicle's system software might have a bug—hold down the infotainment system's power button for 10 seconds to restart it. The Lynk & Co system prefers small-capacity USB drives, so check the drive's partition format; if it's not FAT32, try a different drive. If the problem persists, the vehicle's firmware might be outdated—visit a 4S shop to connect to a computer for an upgrade. Troubleshooting step by step saves time and effort, and avoid disassembling the device yourself.
