Why can't the Roewe start?

2 Answers
EllieLee
07/24/25 2:28am
Roewe may occasionally experience intermittent starting issues. There are many reasons why a car may not start. Here are five common causes: 1. No fuel: This is an obvious reason, but some people still make this basic mistake in daily life. Always remember to check the fuel gauge when getting in and out of the car. 2. Incorrect gear position: For automatic transmission cars, the gear must be in P (Park) or N (Neutral) to start. If it's in R (Reverse) or D (Drive), the engine won't start. Some manual transmission cars also won't start if the clutch isn't depressed. 3. Dead battery: This could be due to a drained battery from leaving headlights on for too long or an expired battery lifespan. It's generally recommended to replace the battery every 2 years. Additionally, installing xenon headlights or high-power audio systems can also cause electrical circuit failures. Checking for a dead battery is simple—just press the horn.
Was this review help?
9
0
Share
Daedalus
08/10/25 10:06pm
I've been driving a Roewe for several years, and recently had a real headache when it wouldn't start. Turned out the battery was dead - probably because I left the dome light on all day and drained it. If the battery terminals aren't tightened properly, you'll get poor contact, and insufficient voltage won't be able to power the starter. Some Roewe models have very sensitive anti-theft systems that will prevent starting if there's a key recognition error. First, check if there's any corrosion on the battery terminals - clean any leaks immediately. You can try jump-starting with a friend's car. If you hear clicking but the engine won't turn over, the fuel pump might be the issue. Don't delay - get the voltage tested or visit a professional shop promptly to avoid bigger trouble from breaking down on the road.
Was this review help?
13
2
Share
Expand All
More Forum Discussions

What are the conditions for license renewal?

Conditions for license renewal: The motor vehicle driver should apply for license renewal at the vehicle management office of the original issuing authority within 90 days before the expiration of the motor vehicle driving license. Procedures for renewing the driving license: Bring your ID card, original driving license and one copy to the local traffic department to apply for renewal. Process for renewing the driving license: Fill out the motor vehicle driving license application form, take an on-site photo, undergo a physical examination to obtain a motor vehicle driver's physical condition certificate, return to the original processing window for final signing, and the staff will require you to sign and confirm on the motor vehicle driving license application form, completing the renewal process. Validity period of the renewed license: Generally, the new license is valid for 6 years. If there is no full-point record within the first 6-year validity period, the next renewal period will be 10 years.
14
4
Share

Is it mandatory to tie up hair for the subject one test?

There is no requirement to tie up hair for the subject one test, and there are no specific requirements for hairstyles. Below are the precautions for the subject one test: 1. Arrive early: It is recommended to arrive at the test center half an hour before the test. Before the subject one test begins, the examiner will explain the precautions to all candidates, so try to arrive at the test center as early as possible. 2. Do not click the screen randomly: After being assigned a seat number and finding your seat, do not click the "Confirm" button on the screen or perform any operations before the examiner at the test center gives instructions. 3. Do not cover your face: During the test, do not let your hat or hand cover your face. During the subject one test, there is a camera on the computer that monitors the test-taking status in real time to determine if there is any cheating behavior. This monitoring footage will be uploaded along with the test papers as one of the bases for issuing the driver's license.
17
2
Share

What is the solution for the P0087 trouble code?

p0087 trouble code solution: Adjust the fuel rail and system pressure. After a car displays a trouble code, it is necessary to repair the issue as soon as possible based on the fault. After troubleshooting, the trouble code often needs to be cleared. When clearing the trouble code, it is essential to follow the specified method for the particular vehicle model, as each car is different, and the method for clearing trouble codes also varies. The P0087 trouble code indicates that the fuel rail system pressure is too low. When this trouble code appears, it means the electronic control unit has detected that the fuel rail pressure is below the calibrated minimum value within a set period. Low fuel pressure may be caused by issues such as a faulty fuel pump, fuel pump control module failure, fuel pressure regulator malfunction, fuel pressure sensor failure, or fuel leakage.
2
5
Share

Can a car be transferred with only the vehicle registration certificate?

No, a car cannot be transferred with only the vehicle registration certificate. For the seller: Owner's ID card, vehicle registration certificate, vehicle license, original purchase invoice (or transfer invoice if the car has been transferred before). If the seller is an organization, the original organization code certificate and official seal are required. For the buyer: ID card. For non-locals applying for local license plates, a valid temporary residence permit is additionally required. If the buyer is an organization, the original organization code certificate and official seal are required. The original vehicle purchase invoice or the last transfer invoice must be provided. For out-of-town transfers: For out-of-town transfers, the purchase tax booklet is needed (red booklet before 2001, green booklet after 2001). (Required before 2012, but not needed in most cities after 2012, except for autonomous regions where requirements may vary.) Bring all the above documents to the used car transfer office to complete the process.
2
0
Share

Are the handbrake and foot brake of a car the same brake pad?

Handbrake and foot brake of a car are not the same brake pad. Introduction to handbrake: The handbrake, commonly known as the parking brake, is a braking device that keeps the vehicle stationary when parked, and it only brakes the two rear wheels. The foot brake is commonly known as the service brake, which is a braking device used to slow down the vehicle until it comes to a complete stop during motion, used in situations such as deceleration and temporary stops. Introduction to foot brake: The foot brake is the main brake of the vehicle. The transmission of braking force involves the mechanical force from the brake pedal being converted into hydraulic pressure, and the hydraulic pressure of the brake fluid is transmitted through pipelines to the brake discs. It provides strong braking force and is easy and effortless to control. It is the braking device used during normal driving, acting on all four wheels. More importantly, the hydraulic system only functions when the engine is running.
17
4
Share

Are New Energy Vehicles Automatic or Manual Transmission?

New energy vehicles are automatic transmission. Automatic transmission gear classification: Generally, the gears of an automatic transmission vehicle can be divided into P, R, N, D, S, L, and M gears. Precautions for driving automatic transmission: Driving an automatic transmission vehicle using only the parking gear P, reverse gear R, neutral gear N, and drive gear D can fully meet the needs of general driving. However, in some special driving environments, other functional gears may be required. Therefore, if the correct control method is chosen, an automatic transmission vehicle can perform better than a manual transmission. When waiting at a red light, whether to use N gear or D gear can be based on personal habit. Temporarily stopping and holding the brake in D gear does not harm the vehicle, because the torque converter in the transmission is equipped with a reaction wheel with a one-way clutch, whose function is to amplify the torque from the engine crankshaft.
6
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.