Why Can't the Car Bluetooth Be Turned On?

1 Answers
LaJudah
07/30/25 12:24am
If you encounter a situation where the car Bluetooth cannot be turned on, you can try restarting the car's infotainment system (i.e., turn off the ignition, lock the vehicle, then unlock and power it on again). If the problem persists after restarting, you should visit a 4S shop for diagnosis. Below is an introduction to car Bluetooth: 1. Function: Automatically identifies mobile phones, allowing connection with the phone without cables or phone holders; the driver can control the phone without touching it, even keeping both hands on the steering wheel, using voice commands to answer or make calls, reducing the possibility of traffic accidents. 2. Precautions: Do not use it under strong light for extended periods.
Was this review help?
10
4
Share
More Forum Discussions

What are the reasons for the Honda Avancier's one-button start not working?

Below are the related reasons why the Avancier may not start: 1. Circuit or electronic failure: The first possible cause is a circuit or electronic failure. The occurrence of such a failure is usually very sudden and without any warning. Circuit failures include: blown fuses, open high-voltage coils, open low-voltage circuits, detached central ignition wires, leaking distributor heads, and damaged spark plugs. Electronic failures mainly refer to the central computer control board losing functionality. 2. Fuel system failure: Next is a fuel system failure. Engine stalling caused by fuel system issues often comes with symptoms such as weak engine performance and a spongy accelerator pedal. Possible fuel system failure points include: malfunctioning fuel pumps, blocked fuel lines, clogged fuel filters, failed carburetors, damaged injectors, etc. Sometimes, the fuel tank may be empty without the owner realizing it. Adding a few liters of gasoline can resolve all issues. 3. Mechanical failure: Lastly, it could also be a mechanical failure. Common mechanical failures include: broken timing belts (or chains), cylinder leaks with no pressure, etc. Another scenario is when the starter motor does not work or barely works. In such cases, the first thing to check is the battery or accumulator.
19
5
Share

Does Starting in Second Gear Really Damage the Car?

Starting in second gear can indeed damage the car. Although starting in second gear allows for a quicker take-off by reducing the process of releasing the throttle and shifting gears once, and enables deeper throttle application after starting to quickly shift to higher gears, it causes severe wear on the clutch and increases fuel consumption. Over time, insufficient power can lead to increased carbon deposits and abnormal engine operation. Severe wear on the clutch plate: Second gear does not provide the maximum torque, yet starting requires significant torque to avoid stalling. To prevent stalling, it is necessary to increase the throttle and raise the engine speed while the clutch is partially engaged. In this semi-engaged state, the clutch plate experiences the most severe wear, and with increased throttle, abnormal wear occurs, significantly reducing the lifespan of the clutch plate. Increased fuel consumption: Continuously increasing the throttle while the clutch is partially engaged results in much of the fuel simply causing the engine to idle without contributing to forward motion. While the additional fuel consumption may not be noticeable in one or two instances, prolonged starting in second gear will lead to a noticeable increase in fuel consumption per 100 kilometers. Higher risk of stalling and carbon deposits: If the throttle is not sufficiently increased during take-off, it can result in insufficient power, even causing the engine to stall. Stalling adds another ignition process, and even if the engine does not stall, struggling to start due to insufficient power can lead to incomplete combustion, resulting in carbon deposits. In severe cases, this can cause engine knocking, abnormal noises, and abnormal wear on the pistons and cylinders. Therefore, it is recommended to use first gear for normal starts, as it provides the maximum torque, making it the most suitable for smooth take-offs. This not only saves fuel but also prevents damage to the car.
16
4
Share

How Long is the BYD Battery Warranty?

BYD's new energy battery pack warranty is 8 years or 150,000 kilometers. The vehicle warranty is 6 years or 150,000 kilometers. Additionally, the battery cells come with a lifetime warranty service, which is generally higher than other electric vehicle brands in the same class. The battery packs of new energy vehicles have a limited lifespan. BYD's new energy vehicles use self-produced lithium iron phosphate (LFP) batteries and ternary lithium batteries. The specific advantages and disadvantages are as follows: Ternary Lithium Battery Advantages: Ternary lithium-ion batteries have high energy density, long cycle life, and are not afraid of low temperatures. Disadvantages: Insufficient stability at high temperatures. Application: Pure electric vehicles with high range requirements. It is the mainstream direction and suitable for northern climates, as the battery remains more stable in low temperatures. Lithium Iron Phosphate (LFP) Battery Advantages: Lithium iron phosphate batteries have excellent thermal stability, are safe, cost-effective, and have a long lifespan. Disadvantages: Low energy density and poor performance in low temperatures. Application: The internal chemical composition of these batteries only begins to decompose at temperatures between 500-600°C. They do not catch fire or explode under puncture, short circuit, or high-temperature conditions and have a long service life. However, the vehicle range is generally limited, and charging efficiency is low when temperatures drop below -5°C, making them unsuitable for winter charging needs in northern regions. In the battery sector, BYD has 100% independent research, development, design, and production capabilities. Currently, BYD's battery products cover consumer 3C batteries, power batteries (LFP and ternary batteries), solar batteries, and energy storage batteries, forming a complete battery industry chain. BYD is also the world's largest LFP battery manufacturer in terms of production capacity.
3
3
Share

What Octane Gasoline Should the Honda Avancier Use?

The Honda Avancier should use 92-octane gasoline, as this is the recommended fuel grade specified in the vehicle's official user manual. In addition to checking the appropriate gasoline grade in the user manual, you can also find this information on the fuel tank cap, where it is usually indicated. Typically, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92-octane gasoline, while those with a ratio between 10.0-11.5 should use 95-octane gasoline. If the compression ratio is even higher, 98-octane gasoline is recommended. However, with the use of new technologies, the compression ratio alone cannot determine the appropriate gasoline grade, as high-compression engines can also be tuned to use lower-octane fuel. Other factors, such as ignition timing, turbocharging technology, and Atkinson cycle technology, also play a role. Generally, the higher the gasoline octane rating, the higher the octane number and the better the anti-knock performance. 92-octane gasoline contains 92% isooctane and 8% n-heptane, while 95-octane gasoline contains 95% isooctane and 5% n-heptane. If the Honda Avancier occasionally uses the wrong gasoline grade, simply switch back to the correct grade after the current tank is used up. However, prolonged use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower-octane gasoline, using a higher-octane grade will not cause damage, but the increased octane number can alter the fuel's ignition point, leading to delayed combustion in the engine. This reduces the engine's power output and thermal efficiency, resulting in poorer performance. For vehicles recommended to use higher-octane gasoline, using a lower-octane grade can cause engine knocking. The significantly lower octane number reduces the fuel's ignition point, causing premature ignition during the compression stroke. If the fuel ignites before the spark plug fires, resistance occurs during the upward stroke. This resistance makes the engine run very unevenly. Mild knocking may only increase noise without obvious engine damage, but severe knocking indicates serious engine issues, affecting not only driving stability but also causing abnormal wear on the pistons and cylinders, potentially leading to cylinder scoring.
2
4
Share

Can You Turn Right at an Intersection Without a Right-Turn Arrow?

There are three scenarios where vehicles can turn right at a red light, as detailed below: Circular Traffic Light: If the circular traffic light at an intersection turns red, vehicles in the right-turn lane can proceed to turn right. However, you must ensure not to interfere with other vehicles, as well as pedestrians and vehicles on the roads behind and to your right. Arrow-Shaped Right-Turn Signal: If you encounter an arrow-shaped right-turn signal at an intersection, you cannot turn right when the red arrow is lit. Turning right in this situation will be considered running a red light. Circular Red Light with Additional Signage: At some intersections with complex traffic conditions, you may find additional signs above the traffic light indicating whether right turns are allowed during a red light. If the sign says "Right Turn on Red," then you may proceed. If it says "No Right Turn on Red," you must wait for the green light to turn right. Legal Regulations: According to the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China," motor vehicle and non-motor vehicle traffic signals are defined as follows: When the green light is on, vehicles are permitted to proceed, but turning vehicles must not obstruct the passage of straight-moving vehicles or pedestrians. When the yellow light is on, vehicles that have already crossed the stop line may continue to proceed. When the red light is on, vehicles are prohibited from proceeding. At intersections without non-motor vehicle or pedestrian crossing signals, non-motor vehicles and pedestrians should follow the motor vehicle traffic signals. When the red light is on, right-turning vehicles may proceed if they do not obstruct the passage of other vehicles or pedestrians. According to the "Road Traffic Safety Law," the regulations regarding traffic signals are as follows: Article 25, Paragraph 2 states that traffic signals include traffic lights, traffic signs, traffic markings, and the directions of traffic police. Article 26 states that traffic lights consist of red, green, and yellow lights. A red light indicates prohibition, a green light indicates permission, and a yellow light serves as a warning. Article 38 states that vehicles and pedestrians must follow traffic signals. When directed by traffic police on-site, they must follow the police's directions. On roads without traffic signals, they should proceed under the principles of safety and smooth traffic flow. Article 62 states that pedestrians should use crosswalks or pedestrian facilities when crossing intersections or roads. At signalized crosswalks, they must follow the traffic signals. At unsignalized intersections or road sections without pedestrian facilities, they should cross only after confirming it is safe. Article 89 states that pedestrians, passengers, and non-motor vehicle drivers who violate road traffic safety laws and regulations regarding road passage will be given a warning or fined between 5 and 50 yuan. Non-motor vehicle drivers who refuse to pay fines may have their vehicles impounded. Driving a motor vehicle in violation of traffic signals will result in a 6-point penalty. Right-Turn Precautions: Observe Straight-Moving Vehicles on the Left: When turning right, you must check both the right and left sides for oncoming traffic. Watch for Oncoming Left-Turning Vehicles: In addition to straight-moving vehicles, be aware of any vehicles turning left from the opposite direction. When turning right, yield to vehicles on your left, whether they are turning left or going straight. Look Out for Pedestrians: When turning right, be mindful of pedestrians on crosswalks, not only at the intersection but also at the corner where additional crosswalks may be present.
12
0
Share

Should Suzuki UU125 use 92 or 95 gasoline?

According to the official introduction of Jinan Suzuki motorcycles, the Suzuki UU125 can use 92-octane gasoline. The engine of the Suzuki UU125 is a 125ml single-cylinder four-stroke engine with a compression ratio of 10.3:1, so 92-octane gasoline is sufficient. Of course, the Suzuki UU125 can also use 95-octane gasoline. Although 95-octane gasoline is slightly more expensive, it can help the engine perform better and extend its service life.
17
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.