···
Log in / Register

Why can't the BYD S6 detect the key with one-button start?

5 Answers
DelConnor
07/29/2025, 06:47 AM

The reasons why the BYD S6 cannot detect the key with one-button start are as follows: 1. Poor key placement: For example, in the trunk, on the floor inside the car, in the cup holder, in the glove compartment, in the door panel storage box, near the rear parcel shelf, or under the front windshield. If this issue occurs, try placing the key in a visible location within the passenger compartment first. 2. Low key battery: The remote key typically uses a standard button cell battery with a rated operating voltage of around 3.3V, and under normal conditions, its lifespan can reach up to 2 years. 3. Use of a key case: This may weaken or block the signal. 4. Signal interference: Placing the key near devices such as mobile phones, laptops, or power adapters. Since these radio devices emit wireless signals that can interfere with the smart key, keep the key away from such devices when in use. 5. Faulty key chip: This may result in poor or no signal transmission. 6. Malfunction of the in-car oscillator or related components: This prevents the formation of an effective electronic oscillation zone, leading to failure in scanning and recognizing the key. 7. Issues with the antenna in the rear window glass: If the signal cannot be received, check whether the antenna signal amplifier is functioning properly or if window tinting is blocking the signal. 8. Deviation in the vehicle's signal code rate: This requires reloading the matching code between the key and the car.

Was this review help?
5
4
Share
McRhett
08/13/2025, 11:58 AM

I've been driving the BYD S6 for several years and have encountered the issue of the one-button start not detecting the key a few times. The most common reason is usually a dead key fob battery. If you keep the key in your pocket or bag pressed against your phone, the signal can get interfered with. Sometimes, high-voltage power lines or large electrical appliances nearby can also cause strong electromagnetic interference. Additionally, a faulty chip inside the key or a loose vehicle antenna could be the culprit. I suggest first trying to hold the key close to the start button to see if the system recognizes it. If that doesn’t work, replace the CR2032 battery—you can easily open the key’s back cover to do it yourself. If the issue persists, the vehicle’s software might need a reset by disconnecting the battery for a while or taking it to a 4S店 for an antenna check. Avoid staying too long in areas with heavy interference, and pay extra attention to signal issues when parking. Regular maintenance of the key can save you a lot of trouble.

Was this review help?
5
4
Share
Expand All
DiAdam
10/07/2025, 03:05 AM

As someone who frequently tinkers with cars, I'm quite familiar with keyless start systems. Failure to detect the key is often attributed to low key battery or external signal interference. For example, in shopping mall parking lots with numerous electronic devices around, signals can get blocked. Aged key batteries or malfunctioning vehicle receiver modules are also common culprits. Additionally, the BYD S6's anti-theft system might misjudge and cause communication interruptions. During testing, using a spare key to start the car can help determine if the issue lies with the key itself; without a spare, try the re-pairing process—wait a few minutes after turning off the car before retrying. Common interference sources include phones, smartwatches, and even power banks—avoid carrying them while driving. Simply replace the battery with a new CR2032 model, which is cheap to buy online. If the problem persists after troubleshooting, have the circuitry inspected without delay.

Was this review help?
10
2
Share
Expand All
AugustAnn
11/20/2025, 03:28 AM

As a BYD S6 owner, I can tell you that key detection failures are mostly due to a drained battery. Simply replacing the small CR2032 coin cell usually solves the issue. Alternatively, poor signal in parking areas, such as near metal structures or microwave interference, might be the culprit—try moving to a different spot. If the key itself is damaged internally, you'll need a replacement, which isn't expensive. Occasionally, the system might freeze; restarting the car's battery for ten seconds can help reconnect. In short, try these simple fixes first. If they don't work, head to the 4S shop for repairs—don't waste too much time on it.

Was this review help?
20
1
Share
Expand All
DelZachary
01/10/2026, 10:17 PM

Having driven the BYD S6 for many years, the issue of the key not being found with one-button start is commonly caused by a depleted key battery or strong interference environments. For instance, when the key is placed too close to a phone in a bag, the signal can become disrupted. It's advisable to regularly check the key's battery level and replace it with a new one annually as a preventive measure. In high-interference areas like underground parking lots in shopping malls, driving out promptly can restore functionality. If the key chip malfunctions, use the mechanical method to open the door and start the car, or wait for the vehicle system to go into sleep mode before retrying. Long-term neglect may affect the anti-theft function, so ensuring the key is in good condition before departure can save trouble. Safe driving relies on meticulous maintenance.

Was this review help?
15
5
Share
Expand All
More Forum Discussions

What is the fuel tank capacity of the Volkswagen Polo 1.4?

The fuel tank capacity of the Polo-2016 1.4L Automatic Trendline model is 45L. It is equipped with a 1.4L naturally aspirated engine and a 6-speed automatic transmission (AT). The drivetrain is front-engine, front-wheel drive. The front suspension type is MacPherson strut independent suspension, while the rear suspension type is torsion beam non-independent suspension. In the same vehicle class, the Vios FS-2022 1.5L CVT Fengchi CARE Edition has a fuel tank capacity of 42L. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity specified by automakers is measured from the bottom of the tank to the safety limit level. There is additional space from the safety limit to the tank opening, which is designed to allow fuel expansion when temperatures rise without causing overflow. If fuel is filled up to the tank opening during refueling, the actual refueling amount may exceed the calibrated tank capacity. To check remaining fuel levels, drivers can observe the fuel gauge on the right side of the instrument panel, marked with E (Empty) and F (Full). When the needle approaches E, it indicates low fuel, while nearing F means sufficient fuel.
1
0
Share

Where to Rent a Sports Car?

Sports cars can be rented at car rental agencies. Here is some relevant information about sports cars: 1. Introduction: The English name for sports cars is Sports-Car or Sporty-Car. They belong to a type of automobile characterized by low chassis, streamlined design, and outstanding power, with their primary feature being the relentless pursuit of speed limits. 2. Vehicle Classification: The following categories do not encompass all sports cars, as there are still gaps. Some coupes or even four-door coupes are also referred to as sports cars, though they are not included in this entry. Some sports cars possess at least two attributes, especially high-performance vehicles with sedan-like appearances and excellent acceleration capabilities.
18
2
Share

How to Identify the Manufacturer of a Tire?

Automobile tires are engraved with brand logos, allowing identification of the manufacturer. Below is relevant information about tires: 1. Tire Introduction: Tires are the only components of a car that come into contact with the ground. Some car owners only replace the tires on the drive wheels when changing tires. For example, some front-wheel-drive car owners only replace the two front tires, while some rear-wheel-drive car owners only replace the two rear tires. In fact, this practice is acceptable. 2. Tire Aging: Tires are made of rubber and will age over time. It is recommended that car owners replace their tires every four years, even if the mileage is low within those four years. Since tires can also age when left unused for extended periods, it's important to check the production date when purchasing new tires.
17
5
Share

Is there Kunlun Expedition Antifreeze?

There is Kunlun Expedition Antifreeze, and here is a detailed introduction about it: 1. Basic Introduction: The full name of antifreeze should be antifreeze coolant, meaning it is a coolant with antifreeze function. Antifreeze is a type of coolant containing special additives, mainly used in liquid-cooled engine cooling systems. It has excellent performance in preventing freezing in winter, boiling in summer, and preventing scale and corrosion throughout the year. 2. Function: Antifreeze can prevent the coolant from freezing and expanding, which could crack the radiator and damage the engine cylinder block or head during cold winter parking. Antifreeze not only does not cause corrosion to the engine cooling system but also has anti-corrosion and rust removal functions.
5
3
Share

How Long Does It Take to Fully Charge a Car by Idling?

When a car is completely out of power, idling to charge it at 1500 RPM for 20 minutes can allow the starter to start the engine once. Charging at 1500 RPM for half an hour can charge the battery up to 80%, while charging at 1500 RPM for over 60 minutes can generally fully charge the battery. Below are detailed explanations: 1. Detail One: The exact time required depends on the remaining charge of the battery, as well as the battery's performance and ambient temperature. Over time, the battery will begin to age, slowing down the charging speed and gradually becoming unable to hold a full charge. 2. Detail Two: In low temperatures, the charging time will be longer. Avoid leaving the car parked for too long, as this can lead to battery discharge.
7
0
Share

What is the plugging sequence for electric vehicle charging?

Electric vehicle charging sequence is: first plug in the battery connector, then plug in the power supply connector. Then observe the charging status - a steady red light with fan humming sound indicates normal operation. When unplugging, first remove the power supply connector, then disconnect the battery connector. Below are the advantages of new energy vehicles: 1. Fuel conservation: New energy vehicles typically use natural gas, petroleum gas, hydrogen, or electricity as power sources, conserving fuel energy. 2. Reduced emissions: New energy vehicles produce no exhaust emissions, effectively protecting the environment. Electric vehicles generate no tailpipe emissions or pollution. Hydrogen-powered vehicles emit only water vapor, causing no environmental pollution. As they essentially achieve zero emissions, they are also exempt from traffic restriction policies. 3. High efficiency: New energy vehicles generally adopt new technologies and structures, making them more efficient.
20
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.