Why Can't the Brake Pedal Be Pressed and the Steering Wheel Won't Move?

1 Answers
Blake
07/25/25 8:32am
The inability to press the brake pedal and the steering wheel not moving can be caused by a faulty vacuum booster pump, excessive impurities in the master cylinder, or air leaks at the pipeline connections. Below are the explanations for these causes: Faulty Vacuum Booster Pump: If the vacuum booster pump is damaged, it will make the brake pedal extremely hard to press. Once the vacuum booster pump fails, it must be replaced immediately, as it will affect the normal operation of the braking system. The braking system is a critical component of a vehicle, directly impacting driving stability and safety. Excessive Impurities in the Master Cylinder: Too many impurities in the brake master cylinder, poor sealing, a failed vacuum booster pump, or contaminated brake fluid. Air Leaks at Pipeline Connections: Brake fluid mixing leading to vapor lock when heated, oil leaks in the master or slave cylinders, or air leaks in the air reservoir or pipeline connections.
Was this review help?
9
3
Share
More Forum Discussions

What are the length and width of the Chevrolet Trax body?

Chevrolet Trax has a body length of 4270mm, width of 1791mm, height of 1618mm, and a wheelbase of 2570mm. Below is the relevant introduction of the Trax: 1. Exterior: In terms of detail design, the new generation Trax incorporates three-dimensional relief elements. The U-shaped folds on the hood exude a sense of power, and it is also equipped with full LED headlights and a panoramic sunroof. The "Z"-shaped lines running across the body create an SUV stance, with smooth body lines and multi-angle variations in the details. 2. Powertrain: The all-new Trax comes standard with a 1.4T engine, paired with a 6MT/6AT transmission, and offers an optional four-wheel-drive system.
2
2
Share

What causes the squeaking sound when braking on snowy days?

Braking on snowy days causing a squeaking sound may be due to the following issues: 1. Rust on brake discs or pads: After prolonged parking or in humid or rainy weather, slight rust or dirt may form on the brake discs or pads. Applying butter or specialized lubricant at the connection between the brake pads and calipers can help. 2. Newly replaced brake pads: New brake pads and discs require a break-in period, and unusual noises when braking are normal during this phase. 3. Excessive wear on brake discs or pads: Both brake discs and pads are high-wear components. Each time you brake, friction between these parts causes wear, and excessive wear can lead to unusual noises. 4. Incorrect installation direction or mismatched model of brake pads: When installing brake pads, it is essential to have the work done at a professional auto repair shop.
18
3
Share

How to Deal with Yellowing Car Headlight Covers?

Solutions for yellowing headlight covers: 1. Clean with soapy water: Directly wipe with soapy water for effective cleaning, but avoid using laundry detergent water as it is corrosive. After cleaning, apply polishing wax to enhance cleanliness. 2. Polishing: Use sandpaper dipped in water to gently sand off the aged layer of the headlight cover, then apply a layer of polishing compound, and finally spray a layer of clear oil for protection. However, not every area may be sanded clean, and there are certain limitations. 3. Directly replace the cover: If the yellowing is severe, go to an auto repair shop to replace the cover. Methods to maintain headlights: 1. Parking location: When parking, try to park in a place not directly exposed to sunlight, preferably in a shaded area. 2. Frequent cleaning: Regularly clean the headlights and wipe them often, but use a soft cloth and alkaline water.
6
4
Share

Which gear should be used for automatic transmission when going down a long slope?

When going down a long slope with an automatic transmission, you should shift to the low-speed L gear, or switch to manual mode to downshift manually or use the sport S gear. The reasons why it is not recommended to use the D gear when going down a long slope are as follows: 1. When going downhill, the vehicle has acceleration, and the D gear will make the vehicle speed faster: When going downhill, if the component force along the slope direction is greater than the resistance, longitudinal acceleration will be generated. At this time, if the D gear is engaged, the vehicle speed will increase more rapidly. 2. Frequent braking is required to control the speed: When the vehicle speed is high, frequent braking is often required to reduce the speed. 3. Frequent braking can easily lead to brake failure: Frequent braking will cause the brakes to overheat, and when the brake pads reach excessively high temperatures, their braking ability will decrease, leading to ineffective braking. Therefore, when going down a long slope, shifting to a lower gear can reduce our safety risks.
10
1
Share

How to adjust the air conditioning mode in Haval H6?

Here are the steps to adjust the air conditioning in Haval H6: 1. Enter the driver's cabin to locate the vehicle's air conditioning control panel; 2. The left knob controls the air volume; 3. The left knob also controls seat ventilation; 4. The two buttons on the sides are for front windshield defogging and rear windshield heating respectively; 5. The central LCD screen allows setting the temperature; 6. The middle area controls the air flow direction; 7. The button at the bottom right adjusts between internal and external air circulation. Additional information: 1. The Haval H6 is a compact SUV with dimensions of 4600mm in length, 1860mm in width, 1720mm in height, a wheelbase of 2680mm, and a curb weight of 1625kg. 2. The Haval H6 is equipped with a 1.5T inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 169PS, maximum torque of 285Nm, and maximum power of 124kW.
20
5
Share

What are the dimensions of the Land Rover Range Rover Evoque L?

The body dimensions of the Land Rover Range Rover Evoque L are as follows: length: 4531mm, width: 1904mm, height: 1650mm, wheelbase: 2841mm. Details about the Land Rover Range Rover Evoque L are as follows: Powertrain: Equipped with a 2.0T engine and a 48V motor forming a mild hybrid system, paired with a 9-speed automatic transmission, and all models come with a four-wheel-drive system. Exterior: The new car features a very stylish and dynamic design, including blackened grille, decorative air intakes on both sides of the front bumper, large-sized wheels, and a distinctive rear bumper design. The Land Rover Range Rover Evoque model is packed with rich features, including an L2-level driving assistance system, panoramic sunroof, leather multi-function steering wheel, full LCD instrument panel, trip computer display, touchscreen LCD display, app remote control function, dual-zone automatic climate control for the front seats, and an onboard air purifier, among others.
4
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.