Why can't the Audi car's steering turn when there is a failure?

What engine is used in the Jianghuai K5?

Jianghuai K5 has two types of engines: one is HFC4DA1-1C, and the other is 4B2-95C43. Here are the relevant details: The two engines of Jianghuai K5 are: (1) HFC4DA1-1C engine: Maximum power is 68/3600, and maximum torque is 220/1800-2200. (2) 4B2-95C43 engine: Maximum power is 70/3200, and maximum torque is 240/2000. Below is additional information: The Jianghuai K5 engine is a 2.8L turbocharged diesel engine. The vehicle dimensions are 5135×1750×1710, and it is a 4-door, 5-seat pickup truck. It complies with the China IV emission standard.

9

5

Share

Should Chevrolet Cavalier Use 92 or 95 Octane Gasoline?

Chevrolet Cavalier uses 92 octane premium unleaded gasoline. Using other fuels may cause knocking noise, poor-quality fuel, etc., which can lead to reduced engine operating efficiency and affect driving performance. This condition may disappear immediately after the engine warms up. The difference between 92 and 95 octane gasoline: Different compositions: 92 octane gasoline consists of 0.92 isooctane and 0.08 n-heptane, while 95 octane consists of 0.95 isooctane and 0.05 n-heptane. The reason why 95 octane gasoline is slightly more expensive is due to its higher proportion of isooctane; Different power: 95 octane gasoline with higher octane rating is suitable for engines with higher compression ratios. Methods to save fuel: Smooth and steady driving: Compared to braking and accelerating, driving at a constant speed is more fuel-efficient. The economical speed for general cars is between 60-80km/h; Appropriately reduce the use of in-car electrical equipment, such as high-power devices like air conditioning and seat heating; Appropriately increase tire pressure. The pressure can be increased by 0.2bar according to the load, but generally should not exceed the specified pressure when fully loaded.

14

3

Share

What transmission does the Jetta VS5 use?

The Jetta VS5 is equipped with a 6AT transmission with the model code AQ250, which is a product from Aisin. The Aisin AQ250 transmission is a 6-speed automatic transmission commonly used in some models of domestic brands and certain foreign brands, such as Volkswagen compact cars, small cars, Changan, Besturn, Dongfeng, and others. Overall, the Aisin AQ250 transmission is a highly reliable AT transmission. Compared to the AQ160, the AQ250 has an increased maximum torque capacity of up to 310 Nm. AT transmissions are also known as torque converter transmissions because they are connected to the engine via a torque converter. The torque converter consists of three main components: the pump, turbine, and stator. During operation, the torque converter is filled with transmission fluid. Inside the AT transmission, there are planetary gears that enable gear shifting and torque conversion. AT transmissions offer smooth shifting due to their soft connection with the engine, which helps absorb vibrations and shocks. There are two other common types of automatic transmissions: dual-clutch transmissions (DCT) and continuously variable transmissions (CVT). Dual-clutch transmissions are derived from manual transmissions and share a similar structure, but they feature an additional clutch and gear-shifting control mechanism. One clutch in a DCT controls the odd-numbered gears, while the other controls the even-numbered gears. CVT transmissions have a simpler internal structure, consisting of only two pulleys and a steel belt.

17

4

Share

What Causes Jerking When Releasing the Accelerator?

The reasons for jerking when releasing the accelerator include the following: 1. Transmission abnormality: First, check the transmission fluid to see if it is lacking or has deteriorated. 2. Power supply system: Issues with spark plugs or ignition coils, where the high-voltage electricity during acceleration is insufficient, leading to intermittent poor engine performance. 3. Fuel supply system: Carbon buildup or slight clogging in the fuel injectors can cause uneven fuel injection among the four injectors, leading to irregular fuel supply and a jerking sensation. Jerking, impact, or gear hunting in the transmission is not due to internal valve body damage but rather stubborn dirt and impurities inside, especially when these accumulate in the valve body, forming blockages that prevent effective regulation of oil pressure, resulting in jerking, impact, or slippage.

18

4

Share

What is Transmission Oil?

Transmission oil is gear oil for the transmission. The following is an introduction to transmission oil: 1. Transmission oil is a lubricant used to keep the gear system clean, providing lubrication to extend the lifespan of the transmission components. It offers effective lubrication even in low-temperature conditions and reduces oil loss under harsh operating conditions. 2. Most transmission oils can be used in automatic transmissions available on the market. In fact, each automatic transmission design has different technical requirements. Even the same model of transmission configured in different vehicle models may vary in torque, weight, speed, and structure. Therefore, the original manufacturer specifies a dedicated transmission oil, and different transmission oils are one of the factors affecting gear-shifting quality.

16

5

Share

What does the 6-year exemption for new vehicles mean?

The 6-year exemption for new vehicles means that within the first six years, the vehicle does not need to undergo an on-site inspection. This policy applies only to private passenger cars with 5 seats or fewer. Although the on-site inspection is waived during these six years, the owner must still visit the vehicle management office every two years to obtain the annual inspection sticker. The owner must bring their ID card, vehicle registration certificate, and valid compulsory traffic insurance policy to apply for a new annual inspection sticker. Starting from the seventh year, the vehicle must undergo an annual on-site inspection, and the owner must obtain the annual inspection sticker each year. The frequency of inspections for different vehicle types is as follows: 1. Non-commercial small passenger vehicles: Inspections are required every two years for the first six years, then annually from the seventh to the fifteenth year, and every six months after 15 years. 2. Non-commercial medium and large passenger vehicles and trucks: Inspections are required annually for the first 10 years, then every six months starting from the 11th year. 3. Commercial passenger vehicles: Inspections are required annually for the first five years, then every six months starting from the sixth year.

7

0

Share

Why can't the Audi car's steering turn when there is a failure?

What engine is used in the Jianghuai K5?

Should Chevrolet Cavalier Use 92 or 95 Octane Gasoline?

What transmission does the Jetta VS5 use?

What Causes Jerking When Releasing the Accelerator?

What is Transmission Oil?

What does the 6-year exemption for new vehicles mean?

What is the speed rating of 95v tires?

How to Deal with the DPF Warning Light?

What Causes the Steering Wheel to Suddenly Become Hard to Turn and Heavy?

What are the differences between three-cylinder and four-cylinder cars?