Why Can't I Find the Maintenance Records for My Ford?

How to Adjust Low Beam Headlights That Illuminate Too Close?

The key points for adjusting low beam headlights are as follows: 1. Adjust facing a wall: Position the car perpendicular to a wall, approximately 10 meters away. 2. Use high beams for adjustment: Generally, if the high beams are properly adjusted, the low beams will also be correct. It's advisable not to adjust using low beams alone as it's harder to determine if the high beams are properly aligned. 3. Adjust one at a time: Cover the light not being adjusted with a cloth and adjust them one by one. Below are precautions for adjusting low beam headlights: 1. Adjusting height: If the headlights haven't been replaced, usually only height adjustment is needed, as the left-right alignment is typically accurate. 2. Adjusting headlights: Note that the left headlight (from the driver's perspective) should be slightly lower than the right one to avoid dazzling oncoming vehicles, which could compromise safety. 3. Nighttime adjustment: It's best to adjust at night, but avoid doing so on roads due to safety concerns and poor visibility of the adjustment effects. Opt for a residential area or a courtyard instead. Prepare a flashlight as it's hard to see clearly at night.

4

2

Share

What is the difference between 2 valves and 4 valves per cylinder?

2 valves refer to an engine with one intake and one exhaust valve, totaling 2 valves, while 4 valves refer to an engine with two intake and two exhaust valves, totaling 4 valves. 2-valve engines are mostly used in small-displacement, low-speed engines, whereas 4-valve engines are commonly found in large-displacement, high-speed engines. These differences lie in the valve train mechanisms of the engines, but the principles remain the same. Here is some additional information: 1. Valves: Valves refer to the intake and exhaust valves of a cylinder. The intake valve is directly connected to the intake manifold and serves as the entry point for the engine to draw in the air-fuel mixture (or fresh air). The exhaust valve is connected to the exhaust manifold and serves as the exit for the engine to expel combustion waste gases. 2. Function: Valves are specifically responsible for introducing air into the engine and expelling the post-combustion exhaust gases. Structurally, they are divided into intake and exhaust valves. The intake valve's role is to draw air into the engine to mix with fuel for combustion, while the exhaust valve's role is to expel the post-combustion waste gases and dissipate heat.

13

4

Share

How to Align with the Ground Arrows in Subject 2?

Steering wheel alignment with the arrow is a crucial reference point for the uphill section in Subject 2. If the arrow is directly in the middle of your body, it indicates that the steering wheel is aligned with the arrow. Below are techniques for aligning with the central guide arrow on the slope: 1. Align the side line: Position the left wiper's rivet to coincide with the right ground edge line, ensuring the right side of the vehicle is approximately 30 cm from the road edge. Alternatively, align the right one-third of the car hood with the road edge line, maintaining the same 30 cm distance. Continuously adjust the steering wheel to meet one of these conditions while driving. 4. Approach the stop line: As you near the stop line, observe when the lower edge of the left rearview mirror aligns with the second thick yellow solid line, then simultaneously press the clutch and brake to stop the vehicle and engage the handbrake. 5. Start upon voice command: Within 30 seconds of hearing the start command, complete the starting procedure. Gradually release the clutch until noticeable vehicle vibration is felt, then stabilize the clutch, quickly release the handbrake, and slowly release the brake to allow the vehicle to move forward steadily.

3

1

Share

What Does It Mean When the Key Light on the Car Is On?

When the key warning light illuminates, it indicates an issue with the car's anti-theft system or the vehicle key. The most common cause is a depleted battery in the smart key. In this case, replacing the key battery will resolve the issue once successful. Below is more information about car indicator lights: 1. Seat Belt Indicator: This light shows whether the seat belt is locked. When illuminated, it means the seat belt is not properly fastened. Some models may also emit a warning sound. The light turns off automatically once the seat belt is secured. 2. Door Indicator: This displays the status of all vehicle doors. If any door is not closed or not properly shut, the corresponding door indicator will light up to alert the driver. The indicator turns off when the door is closed properly. 3. Oil Pressure Indicator: This indicates the oil pressure status within the engine. The light turns on when the ignition is switched on and the vehicle undergoes self-check, then turns off after the engine starts. If the light remains on, it means the engine oil pressure is below the required standard and requires maintenance. 4. Fuel Level Indicator: This shows the amount of fuel in the vehicle. During self-check when the ignition is turned on, the fuel light briefly illuminates before turning off. If the light stays on after starting the engine, it indicates low fuel level in the vehicle.

3

1

Share

Can You Continue Driving with Overheated Wheel Hubs?

If you haven't used the brakes frequently during driving, the wheel hubs generally won't overheat. If overheating occurs, it's necessary to inspect the wheel hub bearings and the braking system. If you encounter overheated brakes, never pour water on them; allow them to cool naturally. Otherwise, the brakes may deform, affecting braking performance, and the tires may crack. Causes of overheated wheel hubs: 1. Frequent braking: Repeatedly applying the brakes while driving can cause the brake discs to heat up, leading to brake pad damage and potential brake failure. Additionally, overheated brake discs can raise the temperature of the wheel hubs. 2. Worn wheel hub bearings: Overly tight assembly or abnormal wear of the wheel hub bearings can cause the wheel hubs to overheat, and in severe cases, the bearings may burn out. 3. Lack of lubrication in bearings: If the temperature is too high, the grease inside the bearings may melt and leak, affecting braking performance and causing the wheel hubs to overheat. 4. Abnormal brake caliper retraction: If the brake caliper fails to retract properly, the brake pads may lock, keeping them in constant friction with the brake discs, resulting in brake drag. In such cases, the temperature of the brake drums and wheel hubs will also rise.

6

0

Share

What is the speed of 50 mph?

50 mph is approximately equal to 80 kilometers per hour. 'Mph' is not the same as 'kilometers'; 1 mph equals 1.609 kilometers. In foreign countries, vehicle speed is measured in mph, which stands for miles per hour, distinguishing it from the kilometers per hour (kph) used domestically. 'Mph' and 'kilometers' are completely different units. Many people mistakenly equate 'mph' with 'kilometers per hour.' 'Mph' refers to miles, based on unit conversion. The difference between mph and yards: The units are different; mph is measured in miles per hour, while yards are measured in kilometers per hour. The speed expressions also differ. For example: 80 yards refers to a driving speed of 80 kilometers per hour, equivalent to 80 ÷ 1.6093 = 49.7 mph. One yard is approximately equal to 0.9144 meters. On the other hand, 80 mph refers to a driving speed of 80 miles per hour. One mile equals 1609 meters, which is equivalent to 1.609 kilometers. Therefore, 80 mph is approximately equal to 128.75 kilometers per hour.

15

3

Share

Why Can't I Find the Maintenance Records for My Ford?

How to Adjust Low Beam Headlights That Illuminate Too Close?

What is the difference between 2 valves and 4 valves per cylinder?

How to Align with the Ground Arrows in Subject 2?

What Does It Mean When the Key Light on the Car Is On?

Can You Continue Driving with Overheated Wheel Hubs?

What is the speed of 50 mph?

What kind of oil should be used for squeaky car doors?

What is the 0-100 km/h acceleration time for the hybrid version of the Accord?

How Long Does It Take to Receive Vehicle Scrappage Compensation?

Can You Be Fined for Parking on the Roadside with Hazard Lights On?