Why Are Manual Transmission Cars Used for Driving License Training?

1 Answers
VanRiley
07/30/25 3:36am
Reasons why manual transmission cars are used for driving license training: The C1 license is the most common type, and learning to drive a manual transmission vehicle also enables one to operate automatic transmission cars. Additionally, manual transmission vehicles are more cost-effective, and there is a deeper reason—safety. The following points introduce manual transmission: 1. Manual transmission primarily relies on the driver to operate the clutch pedal for gear changes. Driving a manual transmission car allows the driver to better experience the thrill of climbing hills, accelerating, and the joy of controlling the vehicle. 2. Due to the more complex operation, it demands higher driving skills from the driver. Drivers proficient in manual transmission can significantly reduce the likelihood of accidents through subconscious good handling when responding to emergencies and unexpected situations.
Was this review help?
16
4
Share
More Forum Discussions

Why can't the trunk of the Volkswagen Scirocco open?

If the trunk of the Volkswagen Scirocco cannot open, it may be due to a dead remote key battery or poor signal. Solutions: Replace the battery or use the key to open the trunk. Some models have a central trunk unlock button—pressing it will pop the trunk open. The function of the car trunk: A fully equipped toolkit, including a spare tire, jack, headlight tools, warning triangle, first aid kit, etc., is usually standard in most vehicles. A luggage storage net is also provided to secure small, fragile items during driving, preventing them from shifting or getting damaged. With the storage net, these concerns and unnecessary losses are eliminated.
6
5
Share

What is the maintenance mileage for the Tayron GTE?

The maintenance mileage for the Tayron GTE is 5,000 kilometers. Car Maintenance: Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. Scope of Car Maintenance: Modern car maintenance mainly includes the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, and other maintenance areas. Purpose of Car Maintenance: The purpose of car maintenance is to keep the vehicle clean, maintain normal technical conditions, eliminate potential hazards, prevent faults, slow down the deterioration process, and extend the service life.
5
5
Share

What Causes the Needle on Volkswagen Dashboard to Shake?

Volkswagen dashboard needle shaking is due to poor contact in the dashboard control circuit, a faulty dashboard circuit board, dirty electronic throttle and intake system, or battery drain. Dirty electronic throttle and intake system: If the idle speed shakes and the dashboard needle jumps erratically when starting the car, and the throttle pedal responds sluggishly when accelerating, it indicates a dirty electronic throttle and intake system. Battery drain: If power-consuming devices such as lights or the radio were left on when the car was last turned off, causing battery drain, it can also lead to erratic jumping of the dashboard needle. Solution: Turn on the hazard lights, press and hold the dashboard reset button, turn on the ignition, and adjust FIX to set the next maintenance mileage and days to zero.
18
3
Share

Is it okay to accidentally fill up with 95 gasoline once?

It is okay to accidentally fill up with 95 gasoline once. Occasionally using the wrong gasoline grade only requires switching back to the correct grade after use. However, long-term use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower grades, accidentally using higher-grade gasoline will not cause damage, but the increase in octane number will alter the fuel's ignition point, leading to delayed combustion in the engine. This means both the engine's power output and thermal efficiency will decrease, resulting in poorer performance in practice. For vehicles recommended to use higher grades, using lower-grade gasoline can cause engine knocking. Because the octane number is too low, the reduced ignition point of the gasoline may cause premature ignition during the compression stroke. If detonation occurs before the spark plug fires during the compression stroke, resistance will arise during the upward stroke. This resistance makes the engine run very unstable. If the knocking is imperceptible, it only increases noise without significant damage to the engine. However, noticeable knocking indicates severe engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring. In addition to checking the appropriate gasoline grade in the car's manual, you can also find it on the fuel tank cap, which is usually labeled. Typically, the gasoline grade can also be determined based on the engine's compression ratio. Cars with a compression ratio between 8.6-9.9 should use 92 gasoline, those between 10.0-11.5 should use 95 gasoline, and those with higher compression ratios should use 98 gasoline. However, with the use of new technologies, the gasoline grade cannot be solely determined by the compression ratio. High compression ratio engines can also be tuned to use lower-grade gasoline. Besides the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline grade, the higher the octane number and the better the anti-knock performance. 92 gasoline contains 92% isooctane and 8% n-heptane, while 95 gasoline contains 95% isooctane and 5% n-heptane.
13
1
Share

What is the BMW the4?

BMW the4 is BMW's first all-electric four-door coupe. Introduction: Wheels: 19-inch aerodynamic aluminum alloy wheels, double-spoke style 860M, two-tone. Seats are upholstered in Vernasca leather, black with blue decorative stitching, and dark gray aluminum diamond interior trim. Driving Performance: Optimized through various aspects such as the efficient powertrain concept, intelligent lightweight construction, aerodynamic design, and high-efficiency high-voltage battery, the innovative BMW i4 eDrive40 offers a pure electric range of up to 625 km (CLTC). Additionally, the innovative BMW i4 features adaptive brake energy regeneration, further enhancing both range and driving comfort. The innovative BMW i4 M50 delivers a maximum output power of 400 kW (544 hp), a top speed of 218 km/h, and accelerates from 0 to 100 km/h in just 3.9 seconds, with instantaneous electric power ready at your command.
20
1
Share

Why does the Mercedes-Benz A200L make noise when braking?

Mercedes-Benz A200L makes noise when braking due to the running-in of new cars, normal activation of the ABS system, and metal hard spots on the brake pads. Running-in of new cars: New cars or newly replaced brake discs and pads will have a running-in period, during which some abnormal noises are inevitable. These noises usually disappear after running a few hundred kilometers. Normal activation of the ABS system: During emergency braking, the brake pedal will make a continuous "thud thud thud" sound, and sometimes there will be a bouncing sensation. This indicates that the ABS system is activated, which is a normal sound. At this time, you can press the brake pedal firmly to the bottom, but this only applies to vehicles equipped with an ABS system. Metal hard spots on the brake pads: There may be some small metal particles inside the brake pads, which will produce a sharp and harsh sound when lightly braking. This problem can be solved by stepping on the brake pedal hard several times, removing the brake pads for re-grinding, or replacing them with better-quality brake pads.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.