Who is the manufacturer of Lynk & Co?

What is the fuel tank capacity of the 2017 Magotan?

The fuel tank capacity of the 2017 Magotan is 66L. This data is official. Owners who purchased the 2016 Magotan can also check this information in the vehicle's configuration sheet. The 2017 Magotan is equipped with three different displacement engines. The model with the 1.4T turbocharged engine uses 95-octane fuel, has an NEDC combined fuel consumption of 5.5L per 100km, and can travel up to 1200km on a full tank. The model with the 1.8T turbocharged engine also uses 95-octane fuel, has an NEDC combined fuel consumption of 6.4L per 100km, and can travel up to 1031km on a full tank. The model with the 2.0T turbocharged engine uses 95-octane fuel, has an NEDC combined fuel consumption of 6.7L per 100km, and can travel up to 985km on a full tank. During daily driving, it is necessary to always pay attention to the remaining fuel level in the tank. This is usually observed through the fuel gauge inside the car. If there are no other issues, the fuel level will be accurately reflected on the gauge. The fuel gauge typically has 5 to 6 segments, and it is advisable to refuel when there are 2 segments left to avoid running out of fuel midway. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity specified by the manufacturer is measured from the bottom of the tank to the safe limit, and there is additional space from the safe limit to the tank opening. This space ensures that the fuel can expand when the temperature rises without overflowing. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the calibrated capacity. In addition, the following factors can affect a car's fuel consumption: Vehicle weight: There is a direct correlation between vehicle weight and fuel consumption. A 10% reduction in weight can lead to a corresponding reduction in fuel consumption. Car design: A lower drag coefficient can significantly reduce fuel consumption, while a higher drag coefficient will increase fuel consumption. Low tire pressure: This increases friction and adhesion, leading to higher fuel consumption. Driving habits: Rapid acceleration and frequent braking can significantly increase fuel consumption. Wind direction: Driving with a tailwind reduces fuel consumption, while driving against a headwind increases the engine's workload and fuel consumption. Road conditions: Driving on flat roads consumes less fuel compared to driving on rough or steep roads. Use of additional electronic devices: Using extra devices like the air conditioning while driving can increase fuel consumption.

19

2

Share

How to Replace the Battery in a Baojun Remote Key?

Baojun remote key battery replacement method is: 1. Use a flathead screwdriver to pry open the upper cover plate of the key; 2. After prying it open, lift and remove the upper cover plate; 3. Use a Phillips screwdriver to unscrew the screws on top; 4. Once opened, you can see the battery inside the key, remove the old battery and replace it with a new one; 5. After replacement, re-tighten the screws and reattach the cover plate. Remote key maintenance methods are: 1. Avoid frequently placing it with metal items; 2. Do not store the spare key in the car door; 3. Prevent the smart key from falling or being impacted; 4. Avoid exposing the smart key to high temperatures or contact with liquids; 5. Do not place the key together with electronic devices.

2

Share

Can trouble codes be cleared by yourself?

Trouble codes can be cleared by yourself. Automotive trouble codes are divided into temporary trouble codes and permanent trouble codes. Among these two types, the ones that can be cleared on their own are temporary trouble codes, which are faults detected momentarily during vehicle operation. Permanent trouble codes: Permanent trouble codes may have a certain impact on the judgment of the vehicle's onboard computer, sometimes leading to misjudgments. Symptoms of misjudgment include sudden idle shaking, unstable RPM, certain warning lights suddenly illuminating, etc. ECU: The ECU contains two types of memory: one that can retain data after power-off and another that does not save data after power-off. Trouble codes are stored in the latter type of memory, which does not retain data after power-off, so the trouble codes are automatically cleared once the power is cut. However, this method only addresses the symptoms, not the root cause. As long as the fault remains unresolved, the diagnostic program will continue to generate trouble codes.

10

4

Share

What is the displacement for an engine with 92kW power?

92 kilowatts equals 125 horsepower. Introduction to horsepower: The concept of horsepower as a unit was named by James Watt, the improver of the steam engine, to represent the power of his steam engine relative to the pulling power of horses. It is defined as "the power of a horse that can pull 33,000 pounds and move at a speed of one foot per minute," with the standard units being watts (W) or kilowatts (kW). Engine power: Engine power refers to how quickly the engine performs work. The work done by the engine per unit time is called the engine's power. Corresponding to indicated work and effective work, it is termed indicated power and effective power (output power), with the difference between the two called mechanical loss power.

6

0

Share

Why does fuel consumption increase after changing transmission oil?

The reasons for increased fuel consumption after changing transmission oil are as follows: Insufficient tire pressure and tire wear: Insufficient or low tire pressure increases friction between tires and the ground, resulting in greater resistance and higher fuel consumption; Severe tire wear often leads to slipping, which also increases fuel consumption; Poor fuel quality: Pay attention to fuel quality and regularly clean carbon deposits; Poor quality gasoline can increase carbon deposits, which roughens the intake pipe walls, affecting air intake efficiency and mixture quality, leading to a sharp rise in fuel consumption; Regularly check the oxygen sensor: This is a ceramic component located on the engine exhaust pipe, used to detect and control the oxygen-to-fuel ratio; After prolonged use, the electronic fuel injection system's computer can no longer obtain information about oxygen concentration in the exhaust pipe, often resulting in a higher concentration of the mixture in the engine and increased fuel consumption.

17

3

Share

What is the tire model of the Cadillac XT5?

There are two types of tires for the Cadillac XT5, which are 235/65R18 and 235/55R20. The first number 235 represents the tire width of 235MM, 65 and 55 respectively indicate the aspect ratio of the tire section is 65% and 55%, that is, the section height is 65% and 55% of the width, and 18 and 20 respectively represent the rim diameter of 18 and 20 inches. The letters or symbols in the middle have special meanings: "X" means high-pressure tire; "R" and "Z" mean radial tire; "-" means low-pressure tire. The tires of the Cadillac XT5 are original Michelin brand tires. If you want to replace the tires yourself, you can follow the steps below: Take out the spare tire and jack, place the jack under the frame of the tire to be replaced, and ensure that the jack touches the metal part of the frame; Raise the jack until it supports the car, the jack should be under the vehicle, check and ensure that the jack is at a right angle to the ground; Remove the hub cover, loosen the nuts counterclockwise, do not completely loosen the nuts, just enough to eliminate resistance. When loosening the nuts for the first time, keeping the tire on the ground ensures that the nuts are turned instead of the tire; Turn the nuts counterclockwise until they are loose, repeat this step for all lug nuts, and completely remove the nuts; Place the new tire on the hub, carefully align the tire rim with the wheel bolts, install the lug nuts, tighten the nuts by hand until all nuts are hidden, at this time the tire replacement is completed. In addition to the model, the tire is also marked with the following common data: Tire cord material: represented by Chinese pinyin, such as M-cotton cord, R-rayon cord, N-nylon cord, G-steel cord, ZG-steel radial cord tire. Speed rating: indicates the maximum speed at which the tire can carry the specified load under specified conditions. The letters A to Z represent the certified speed ratings of the tire from 4.8km/h to 300km/h. Commonly used speed ratings are: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h; Rim specification: indicates the rim specification that matches the tire. It is convenient for practical use, such as: standard rim 5.00F.

8

4

Share

Who is the manufacturer of Lynk & Co?

What is the fuel tank capacity of the 2017 Magotan?

How to Replace the Battery in a Baojun Remote Key?

Can trouble codes be cleared by yourself?

What is the displacement for an engine with 92kW power?

Why does fuel consumption increase after changing transmission oil?

What is the tire model of the Cadillac XT5?

Why is the air conditioning in Wuling Hongguang not cooling effectively?

What are the speed limits for 30, 40, 50, and 70 in Subject One?

Is the engine of the new Focus imported?

Where is the rearview mirror heating switch on the 2021 CR-V?