Which vehicles currently meet the China VI emission standards?

What are the precautions for new energy vehicles?

Precautions for new energy vehicles are: 1. Before driving, check whether the battery power is sufficient, whether the braking performance is good, whether the screws are loose, and any faults should be repaired and eliminated in time; 2. When parking, the power switch must be turned off, the key must be pulled out, the gear switch must be turned to the neutral position, and the handbrake must be pulled up; 3. When children play in the car, the key switch must be pulled out; 4. Charging should be carried out in a place where children cannot reach; 5. When repairing or replacing the charging fuse, the power plug must be unplugged; 6. When repairing or replacing the battery or electrical appliances, the main power switch must be turned off before operation; 7. Before driving a new energy vehicle, it is necessary to check whether the doors are closed tightly; 8. In case of fire caused by an accident or other reasons, the main power switch should be turned off immediately.

18

2

Share

How to Install a Dash Cam?

The installation method of a dash cam: First, install the dash cam on the front windshield. The dash cam comes with a suction cup, which can be directly attached to the windshield. Then, route the power cable along the edge of the windshield and secure the wire. Finally, connect the power charging device to the car's cigarette lighter. A dash cam is an instrument that records images, sounds, and other related information during vehicle travel. After installing a dash cam, it can record the entire driving process, including video and audio, which can serve as evidence in traffic accidents. For those who enjoy road trips, it can also be used to document the journey through challenging terrains. Additionally, it can be used at home as a DV to capture life's moments or as a home surveillance device.

4

Share

Can a Pickup Truck Purchased in Beijing Get a Beijing License Plate?

Purchasing a pickup truck in Beijing allows for obtaining a Beijing license plate. The requirements for obtaining a license plate in Beijing are: 1. Non-Beijing residents must have lived in Beijing for more than five years and must also participate in social insurance; 2. Beijing residents without a car can apply for a license plate; 3. Both scenarios require participation in the unified lottery for license plates. Steps for obtaining a license plate: 1. The domicile of the vehicle owner must be within the administrative area of Beijing; 2. The documents and certificates for vehicle registration must comply with laws and regulations, be complete and valid, and must not be altered or inconsistent with the vehicle origin certificate provided by the owner; 3. The vehicle must be produced or imported with permission from the State Council's vehicle product regulatory authority.

3

4

Share

Can Locked Rear Wheels During Braking Cause Side Slip or Fishtailing?

Locked rear wheels during braking can cause side slip or fishtailing because, during vehicle motion, braking may lead to wheel lock-up. This occurs due to the braking torque, causing the wheels to stop rotating and slide on the road surface—essentially, the tires stop turning, and the car slides like a brick on the road. Wheel lock-up results in pure sliding friction between the wheels and the ground. Front wheel lock-up can lead to loss of steering control, making the vehicle unable to follow the intended direction and instead veer towards the direction of least resistance. Rear wheel lock-up, on the other hand, can cause what is commonly known as drifting. Since locked wheels lose the ability to resist lateral forces, side slip and loss of vehicle control may occur. When wheels lock up, releasing the brake pedal is necessary. Vehicles equipped with ABS systems can effectively prevent such situations. Emergency braking is considered safe at speeds between 80-120 km/h, but exceeding 120 km/h during emergency braking can increase the risk of side slip or fishtailing. Emergency braking refers to the situation where, during driving, the driver quickly and correctly applies the brakes to stop the vehicle in the shortest possible distance when encountering an emergency. Methods to release locked wheels include: Releasing the brake pedal and kicking the sidewall of the tire a few times or using a spare tire; Installing an ABS system, which effectively prevents skidding and lock-up, maximizes braking efficiency, reduces braking time and distance, and prevents side slip and fishtailing during emergency braking; Maintaining good steering control during emergency braking; Avoiding excessive friction between the tires and the road surface, thereby reducing tire wear.

7

1

Share

Precautions and Details for C1 Subject 3 Driving Test

Starting with the entry actions: Before getting into the car, you must walk around the vehicle to check the tires and surrounding conditions: start from the left rear wheel → check for obstacles at the rear of the car → right rear wheel → right front wheel → check for obstacles at the front of the car → left front wheel. Observe the rear situation before opening the car door. When starting the test, report, stand 35 cm away from the door, open the door with your left hand, for large trucks, step in with the left foot first, for small cars, step in with the right foot first. Precautions for the C1 Subject 3 test are as follows: Pre-test preparation: Walk around the car before getting in, pause near the monitoring area; Light simulation: Check if the light switch is reset before starting the simulation test; Starting off: Always observe the surrounding traffic environment before starting; While driving: Keep your eyes on the road ahead and avoid following too closely. During the actual road driving test, correctly identify traffic signs, markings, comply with traffic signal regulations, and adhere to intersection driving rules (go straight at crossroads without instructions, turn right at T-junctions without instructions). Avoid pressing the center solid line unless under special circumstances. If you make a mistake during the road test, stay calm, don't dwell on the previous mistake, focus on performing the subsequent actions well, and you can still pass the test. Listen carefully to the officer's driving instructions and repeat them. After the test, complete the necessary actions and turn off the engine. Regardless of passing or failing, thank politely, close the door gently after getting out, and never slam or leave the door open. Details on the penalty points for the C1 license Subject 3 test are as follows: Failing to observe the rear and right traffic conditions through the interior and exterior rearview mirrors before parking results in failure; Failing to park within the specified distance after the examiner's instruction to pull over results in failure; Parking with the vehicle body exceeding the right edge of the road or the sidewalk edge results in failure; Failing to turn your head to observe the side and rear traffic conditions before opening the door after parking results in failure; Not using or incorrectly using the turn signal before parking deducts 10 points; Turning the steering wheel less than 3 seconds after activating the turn signal before parking deducts 10 points; Parking with the vehicle body more than 30 cm away from the right edge of the road or the sidewalk edge deducts 10 points; Failing to fully engage the parking brake lever before releasing the foot brake deducts 10 points; Releasing the foot brake before fully engaging the parking brake lever deducts 10 points; Failing to turn off the engine before getting out deducts 5 points.

8

5

Share

What to Do If a China V Vehicle Cannot Be Licensed?

Solutions for China V vehicles that cannot be licensed include: 1. Return the China V vehicle to the factory for modification. The manufacturer can replace certain parts of the vehicle to meet the China VI standards, allowing it to be driven legally. 2. License the China V model in advance to enable it to be driven on the road. However, once a new car is licensed, it becomes a so-called used car, facing significant depreciation even if it has never been driven. The classification of China's vehicle emission standards is denoted by Roman numerals: I corresponds to China I, II to China II, III to China III, IV to China IV, V to China V, and VI to China VI. Currently, China VI is being implemented, which is divided into two phases: China VIa and China VIb.

1

2

Share

Which vehicles currently meet the China VI emission standards?

What are the precautions for new energy vehicles?

How to Install a Dash Cam?

Can a Pickup Truck Purchased in Beijing Get a Beijing License Plate?

Can Locked Rear Wheels During Braking Cause Side Slip or Fishtailing?

Precautions and Details for C1 Subject 3 Driving Test

What to Do If a China V Vehicle Cannot Be Licensed?

What are the effects of forgetting to turn off the engine while refueling?

What Causes High Engine RPM Without Corresponding Speed Increase in Motorcycles?

What is the fuel consumption of the Nissan Murano?

Can New Energy Vehicles Get Blue License Plates?