Which subject does the 'Study to Reduce Points' policy belong to?

1 Answers
VanOlivia
07/30/25 1:37am
Study to Reduce Points is related to Subject 4 and Subject 1. Study to Reduce Points is not about adding points, but a policy that allows motor vehicle drivers to reduce traffic violation points by receiving education. Within one scoring cycle, a maximum of 6 points can be reduced. There are three ways to reduce points through study: 1) Participate in online learning (accumulate 30 minutes within 3 days) and pass the exam to reduce 1 point; 2) Participate in on-site learning (no less than 1 hour each time) and pass the exam to reduce 2 points; 3) Participate in traffic safety public welfare activities (1 hour each time) to reduce 1 point. There are 7 situations where drivers cannot apply for 'Study to Reduce Points': 1) Within the current scoring cycle, the driver has two or more full-score records, or the cumulative points reach 12; 2) In the previous scoring cycle, the driver has two or more full-score records; 3) In the last three scoring cycles, the driver has been penalized for hit-and-run accidents, drunk driving, using forged or altered vehicle license plates, driving licenses, school bus signs, or other vehicle documents, or buying/selling points; 4) The driver's license is in the probationary period, overdue for review, or suspended; 5) The driver has unresolved traffic violation records; 6) The driver owns a vehicle with expired safety technical inspection or unprocessed deregistration; 7) The driver has engaged in fraud or impersonation during the point reduction education or full-score education and review exams.
Was this review help?
17
0
Share
More Forum Discussions

What are the symptoms of a faulty car exhaust valve?

The symptoms of a faulty car exhaust valve: 1. Blue smoke comes out of the exhaust pipe; 2. Difficulty starting the car; 3. Engine shaking and unstable idle. The car exhaust valve, also known as the oil-gas separator or pressure control valve, is installed between the compressor outlet and the condenser inlet. It improves the heat transfer effect in the condenser and evaporator by separation, which is particularly important for systems where the lubricating oil and working fluid have poor mutual solubility. The working principle of the exhaust valve is that the high-pressure gas from the compressor enters the exhaust valve, then flows into the guide vanes of the exhaust valve in a spiral motion. The lubricating oil is separated from the working fluid gas by centrifugal force and gravity, leaving it along the inner wall of the cylinder.
14
5
Share

What to Do When a Triangle Exclamation Mark Appears in the Car?

Solutions for a triangle exclamation mark appearing in the car: 1. Check if all the bulbs in the vehicle are functioning properly, with a focus on the brake lights and license plate lights. If any bulb is damaged, replace it. 2. If the bulbs are intact and functioning normally, inspect the wiring harness in the trunk for any damage. If found, wrapping it with tape can resolve the issue. Note that if the car's headlights have been modified, this problem may also occur. Additionally, some car models display this symbol to remind the owner that the vehicle requires maintenance, and it will disappear after servicing. Other issues such as parking sensor failure, overheating of the dry dual-clutch transmission, or warnings/failures in the traction control system may also trigger this indicator light.
4
3
Share

What is the method for checking the manual transmission fluid level?

Manual transmission fluid level check method: 1. Use a lift to raise the vehicle to an appropriate height; 2. Use a special adapter and ratchet wrench to loosen the transmission fill plug; 3. Unscrew the fill plug by hand and set it aside, then check the fluid level inside the transmission. Under normal circumstances, manual transmission gear oil does not need to be changed before 100,000 kilometers. Generally, the transmission fluid should be checked again after the vehicle has been driven for 30,000 kilometers. Due to frequent gear shifting, prolonged operation at high speeds, and heavy load conditions during transmission use, the components of the transmission may wear or become damaged, leading to a decline in performance.
11
5
Share

Do Cars Still Need a Break-in Period Nowadays?

Nowadays, cars still require a break-in period. During the initial break-in phase (0 to 500 km), it's recommended not to exceed 60 km/h. The mid-term break-in period (500 to 1000 km) allows for slightly higher speeds up to 90-100 km/h, while keeping engine RPM below 2000. The final break-in stage (1000 to 1500 km) permits speeds up to 120 km/h. Most new vehicles undergo cold break-in before leaving the factory, where the engine is run on a specialized machine tool driven by an electric motor. This process removes most burrs from components. Since the engine isn't actually operating during cold break-in (no fuel combustion or high temperatures), it's referred to as cold break-in.
14
1
Share

How to use the automatic cruise control in a Toyota Camry?

The method to use the automatic cruise control in a Toyota Camry is: 1. Press the power button to turn on the system, and the cruise control indicator on the dashboard will light up; 2. Accelerate to the desired speed, then press the SET button. At this point, you can release the accelerator with your right foot, and the speed will be set at the current speed; 3. You can fine-tune the speed using the RES and SET buttons; 4. To deactivate the cruise control, press the brake, press the CANCEL button, or press the ON/OFF switch. The Toyota Camry is a model under GAC Toyota, with a body length of 4825mm, width of 1825mm, and height of 1480mm. In terms of power, the Camry offers two engine options: a 2.0L and a 2.5L naturally aspirated engine.
12
0
Share

What is the battery model of the Audi A4L?

The battery model of the Audi A4L is H9105LT2A. The battery used in the Audi A4L needs to support the start-stop function. Battery maintenance methods include: 1. Wipe the exterior of the battery with a damp cloth to clean off dust, oil stains, white powder, and other contaminants on the surface and terminals that may cause leakage; 2. Open the battery water filling cap to check if the water level is at the normal position; 3. Verify whether the battery is charging normally. The Audi A4L is a mid-size car launched by Audi. Its body dimensions are 4818mm in length, 1843mm in width, and 1432mm in height, with a wheelbase of 2908mm. In terms of appearance, the Audi A4L adopts the Audi family-style design, featuring a classic hexagonal front grille design combined with the headlights, giving the front face a high level of recognition.
20
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.