Which route is easier for Subject 3?

1 Answers
McPiper
07/29/25 2:55pm
Routes 1 and 2 for Subject 3 are relatively easier. Here is more relevant information: 1. The content of the driving test Subject 3 includes: vehicle preparation, light simulation test, starting, driving in a straight line, shifting gears, changing lanes, parking by the roadside, going straight through an intersection, turning left at an intersection, turning right at an intersection, passing through a pedestrian crossing, passing through a school zone, passing through a bus station, meeting another vehicle, overtaking, making a U-turn, and driving at night. 2. Notes for the Subject 3 test: (1) Speed and gear mismatch: The errors of high gear at low speed and low gear at high speed should be avoided during the test. (2) Deviation in straight-line driving: Maintain a reasonable speed and drive at a constant speed. Do not turn the steering wheel significantly during straight-line driving. (3) Parking more than 30cm from the roadside: The Subject 3 test explicitly requires that the distance from the roadside when parking should not exceed 30cm.
Was this review help?
5
3
Share
More Forum Discussions

What is the fuel tank capacity of the Roewe RX3 when fully filled?

The Roewe RX3 has a fuel tank capacity of 48 liters when fully filled. It is a compact SUV under the SAIC Motor Corporation Limited. Taking the Roewe RX3 2020 Manual Super Cool Edition as an example, its body dimensions are: length 4408 mm, width 1804 mm, height 1651 mm, with a wheelbase of 2625 mm, and a trunk capacity ranging from 485 to 1474 liters. The Roewe RX3 2020 Manual Super Cool Edition is equipped with a 1.6L naturally aspirated 4-cylinder engine, delivering a maximum power of 92 kW at 6000 rpm. It features a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension.
16
0
Share

What Are the Effects of Starting the Car Without Turning It Off First?

Restarting the car while the engine is already running has almost negligible effects on the engine itself, but it can have some impact on the flywheel teeth and the starter motor. However, occasional mistakes in operation will not cause significant damage or lead to component failure. Here are some key points to note when starting a car: 1. First Look: Walk around the car to inspect its exterior and surroundings. Check for any obstacles in front or behind the vehicle, any suspicious oil or water stains on the ground where the car is parked, whether the front and rear light assemblies are damaged, and if the tire pressure is adequate. 2. Second Check: Verify that the engine oil and coolant levels are sufficient, and ensure that the front and rear lights, signal lights, and dashboard are functioning properly. This step mainly involves checking the car's internal technical condition. Lift the hood, pull out the dipstick to check if the oil level is normal, and unscrew the radiator cap to inspect the water level. 3. Starting: If the first two steps are normal, turn the ignition key to start the engine. Each start-up should not exceed ten seconds. It is important to note that when starting a cold engine, the throttle should be pressed gently and gradually. Avoid immediately accelerating sharply after starting, as this can cause the engine speed to rise rapidly. During a cold start, the crankshaft speed increases suddenly, and the oil may not reach the bearing positions in time, potentially causing bearing damage.
11
2
Share

How often should a car's evaporator be cleaned?

The car's evaporator should be cleaned once a year. The evaporator is a radiator device for the car engine and air conditioning system, located behind the glove compartment and integrated with the heater core. There are several types of car evaporators: 1. Horizontal evaporator; 2. Vertical tube evaporator; 3. Spiral tube evaporator; 4. Air-cooling evaporator; 5. Liquid coolant evaporator. The function of the car evaporator is to transform the refrigerant from liquid to gaseous state, absorbing substantial surrounding heat. The resulting low-temperature, low-pressure refrigerant vapor then re-enters the compressor. This repeated cycle achieves cooling, providing occupants with a comfortable environment, reducing driver fatigue, and enhancing driving safety.
3
4
Share

Should the X-Trail use 92 or 95 octane gasoline?

Both 92 and 95 octane gasoline can be used for the X-Trail. Gasoline is a volatile, flammable hydrocarbon mixture liquid obtained through distillation and cracking of petroleum, used as fuel. The X-Trail is a compact 5-door, 5-seat SUV. Taking the 2021 X-Trail model as an example, its body dimensions are: length 4675mm, width 1820mm, height 1722mm, wheelbase 2706mm, minimum ground clearance 208mm, and fuel tank capacity 65L. The 2021 X-Trail is equipped with a 2.0L naturally aspirated engine, with a maximum power of 111kW and maximum torque of 194Nm, paired with a CVT continuously variable transmission.
19
1
Share

How to flash the car's ECU?

To flash the car's ECU, the method is: use a read/write tool to reload the modified data into the system. The ECU refers to the vehicle's onboard computer, whose components include a microprocessor, memory, input/output interfaces, analog-to-digital converters, as well as shaping and driving circuits. The function of the ECU is: based on the programs and data stored in its memory, it performs calculations, processes, and judgments on the information input from the air flow meter and various sensors, then outputs commands to provide the fuel injector with a pulse signal of a certain width to control the fuel injection volume. The ECU has self-diagnosis and protection functions. When a system fault occurs, it can automatically record the fault code in RAM and take protective measures to read a substitute program from the aforementioned inherent programs to maintain engine operation.
10
0
Share

How to remove the cigarette lighter socket of Trumpchi GS4?

The method to remove the cigarette lighter socket of Trumpchi GS4 is as follows: 1. Use a screwdriver to remove the panel where the cigarette lighter is located; 2. After seeing the cigarette lighter socket and the power connection wire, unplug the power connection wire and manually remove the fixing buckle; 3. Directly pull out the plastic panel box of the cigarette lighter by hand, disconnect the connection wire, and then pull out the socket. Taking the 2021 Trumpchi GS4 manual comfort version as an example, it is a compact SUV with body dimensions of: length 4545mm, width 1856mm, height 1668mm, wheelbase of 2680mm, and a fuel tank capacity of 55l.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.