Which Reference Point to Use for Parking 30cm from the Curb?

1 Answers
JuliaDella
07/29/25 5:50pm
Driver should align with the middle of the road, then slightly adjust to the right. The front one-third of the car should overlap with the edge line of the right lane, and the body should be straightened. Slowly brake when the vehicle is approximately 30cm from the edge line to bring it to a stop. Relevant details are as follows: 1. Wiper: Observe the wiper. When the gap in the wiper aligns with the edge line while moving forward, the body is approximately 30cm from the edge line. Observe the car's front reinforcement bar, which is the raised line on the right side of the car's front. When the reinforcement bar aligns with the edge line while moving forward, the distance is also roughly 30cm. 2. Parking Location: When parking near the curb, remember that parking is prohibited at intersections, railway crossings, curves, narrow roads, narrow bridges, steep slopes, tunnels, and within 20 meters of these locations. Parking is also prohibited in sections with pedestrian guardrails (hedges), crosswalks, construction zones, opposite obstacles, as well as in front of bus stops, tram stops, emergency stations, gas stations, fire hydrants, or fire stations, and within 30 meters of these locations.
Was this review help?
1
2
Share
More Forum Discussions

Explanation of Each Button in the 2004 Mazda6?

For the hot/cold selection, turn the knob or press the button to the red end. For the fan speed, select 1 or higher; if it's automatic, choose a temperature higher than the current interior temperature. For the mode selection, choose any option except the windshield defrost. Below is an introduction to the Mazda6: Overview: The Mazda6 (Mazda6) is the latest product launched by Mazda in the 21st century, a mid-to-high-end sedan introduced at the 2001 Tokyo Motor Show. Since its launch, it has won over 30 awards in 20 countries worldwide. Selling Points: Solid chassis performance, top-tier handling standards, earning it the reputation of 'King of the Corners.' With its handsome appearance and excellent safety protection levels, the Mazda6 has taken the lead in market positioning and competition among vehicles in the same class.
14
1
Share

What is the reason for the ineffective car window lock button?

In this case, the reason is a malfunction in the power window module, which can be resolved by replacement. Below is relevant information about the window lock button: 1. Function: The window lock button is a safety feature currently available in many car models. When the driver activates this function, the rear power windows of the vehicle are forcibly locked, preventing passengers in the rear from opening them. This helps minimize the risk of children opening the windows on their own and sticking their heads or hands out. Window lock means that once locked, only the driver can control all four windows. 2. Working Principle: Currently, the lock-up clutches used in cars can be roughly categorized into hydraulic, centrifugal, and viscous types based on their working principles, with the hydraulic type being the most common. The hydraulic lock-up clutch utilizes the driving oil pressure generated by the hydraulic system in the automatic transmission to lock the pump and turbine of the torque converter together.
18
2
Share

How to Reset the Maintenance Light on a 2005 Buick Regal?

Use the Driver Information Center control buttons on the right side of the steering wheel to display the remaining oil life on the instrument cluster screen. Here are the detailed steps: Method: When the "Oil Life" display is activated, press and hold the "√" (OK/Confirm) button for several seconds to reset the oil life system. After resetting, the display will show "Oil Life 100%". Note: If the "Change Engine Oil" message reappears after starting the vehicle, it indicates the engine oil life was not reset, and you should repeat the above steps. The oil life monitoring system should be reset every time the engine oil is changed so the system can calculate the next oil change interval.
1
3
Share

Does a small scratch on a car require a full repaint?

It depends on the situation. If it's just a minor scratch or paint chip, a full repaint is not necessary. Here are specific details about paint repair: 1. Minor damage: Daily use inevitably leads to scratches on the car paint from hard objects. For such minor damage, besides passive acceptance, proactive prevention is possible. Applying wax every 1-2 months or installing wear-resistant patches on frequently affected areas can help prevent minor scratches to some extent. 2. Light damage: In most cases of this level of damage, the scratches on the paint surface are already very visible. In such situations, it is recommended to use a touch-up pen for treatment. 3. Moderate damage: When the paint shows obvious peeling, exposing the primer, it's essential to address it promptly to prevent rusting of the exposed steel from rain or other elements.
15
4
Share

What is the fuel tank capacity of the 2012 Honda City?

42 liters. Below is the detailed information: Introduction: The Honda City manual specifies that the fuel tank capacity is 42 liters, with a recommended gasoline grade of 92 octane, and it should be used consistently without frequent changes. Notes: The gasoline grade only indicates the octane rating, and the appropriate grade should be selected based on the engine's compression ratio. Always refuel in advance and do not wait until the fuel warning light comes on. The fuel pump is located inside the tank and operates at high temperatures when continuously working. Being submerged in fuel helps cool it effectively. When the fuel light comes on, it means the fuel level is below the pump. Consistently waiting for the light to come on before refueling can shorten the fuel pump's lifespan, and having too little fuel in the tank may damage the pump.
9
5
Share

Why is the Landwind X7 wiper not working?

The reasons why the wiper is not working may be as follows: 1. Fuse blown: The wiper may not work because the fuse (to prevent circuit overload) is blown, causing the wiper to malfunction. In this case, you need to open the fuse box and check whether the corresponding fuse (refer to the manual on the cover) is blown. If it is, simply replace it, but remember to turn off all the car's electrical switches before replacement. 2. Motor burned out: The probability of motor burnout is actually very low, but it may also be due to quality control issues. To determine this, turn the car's ignition switch to the power-on state, open the front hood, and activate the wiper. If it's not broken, you can hear the sound of the motor running, and the sound is quite obvious. If there is no sound and a slight burnt smell, it is likely that the motor is damaged.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.