Which One is the Brake in a Manual Transmission Car?

1 Answers
HoldenLynn
07/24/25 8:02pm
The brake in a manual transmission car is located at the bottom left of the driver's compartment. Manual transmission cars have three pedals, arranged from left to right as follows: the clutch pedal, the brake pedal, and the accelerator pedal. The driver uses their left foot to operate the clutch and their right foot to control the brake and accelerator. In an automatic transmission car, the left pedal is the brake, and the right one is the accelerator. While driving, you should not place your left foot on the brake pedal. In a manual transmission car, the left foot is only used to press the clutch pedal when shifting gears. During normal driving, the left foot should not rest on any pedal. Both the brake and accelerator are controlled solely by the right foot. There are two key reasons why the left foot should not be placed on the pedal: During long drives, both feet can become quite tired, leading to unintentional pressing. If the left foot is on the brake pedal, pressing it could easily cause an accident, posing a serious risk. Most people are right-handed, meaning their right foot reacts faster. In an emergency, the right foot can respond in the shortest time by lifting off the accelerator and pressing the brake pedal. If the left foot is on the brake pedal, the right foot would be suspended during braking, increasing the risk of accidentally pressing both pedals simultaneously, which could be dangerous.
Was this review help?
7
4
Share
More Forum Discussions

How to Adjust the Time on a Fit?

Method to adjust the time on a Fit: With the car already started, press the clock button. When you hear a beep and the time starts flashing, adjust the time and press the clock button simultaneously to confirm. Here is an introduction to the Fit: 1. Size: The Fit is a compact car with dimensions of 4109 mm in length, 1694 mm in width, and 1537 mm in height, with a wheelbase of 2530 mm. 2. Suspension: The Fit features a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension. 3. Powertrain: The Fit is equipped with a 1.5-liter naturally aspirated engine, delivering a maximum horsepower of 131 hp, a maximum power of 96 kW, and a maximum torque of 155 Nm, paired with a continuously variable transmission (CVT).
5
0
Share

How to Reset the Maintenance Light on Emgrand GL?

Hold down the trip reset button, insert the car key and turn it to the position where the instrument lights come on, then release. The maintenance light will go off. In idle state, hold down the trip button for 2-3 seconds to reset it. Below is some related information about the Emgrand: 1. Introduction: Emgrand is one of the three sub-brands under Geely Auto, mainly selling higher-end models independently developed by Geely. With the brand proposition of "Excellence, Stability, and Prestige," Emgrand represents Geely's development direction in safety, energy efficiency, and environmental protection. 2. Powertrain: Equipped with a 1.4T turbo and a 1.8L naturally aspirated engine, paired with a 6DCT transmission.
20
1
Share

How to Replace the Key Battery for X-Trail?

Press the button on the back of the key to remove the mechanical key, then open the battery cover and replace the key battery. Below is relevant information: 1. Battery Model: The Nissan X-Trail remote key uses a CR2025 battery, which can be replaced by yourself. However, be careful not to touch the internal circuits and electronic connectors during replacement, as this may damage the circuitry and render the key inoperable. 2. Battery Status: After bringing the smart key into the vehicle, the smart key system warning light will flash for 10 seconds before turning off. If the smart key system warning light flashes green, it indicates that the smart key battery is nearly depleted. When the smart key battery is exhausted or there are strong radio waves in the operating area, the operational range of the smart key system will decrease, and the smart key may not function properly.
18
5
Share

How to Open the Front Hood of a Great Wall Haval H6?

There is a switch at the lower left corner of the driver's compartment that can unlock the hood. The following are the functions of the hood: 1. Airflow Guidance: Through airflow guidance, air resistance can be decomposed into beneficial forces, which helps improve the driving stability of the vehicle. 2. Protection for the Engine and Surrounding Pipeline Components: Under the hood are critical components of the car, including the engine, electrical circuits, fuel lines, braking system, and transmission system. By enhancing the strength and structure of the hood, it can effectively prevent adverse effects such as impacts, corrosion, rainwater, and electrical interference, ensuring the normal operation of the vehicle. 3. Assisting Driver Visibility: The shape of the hood can effectively adjust the direction and form of reflected light, thereby reducing the impact of light on the driver.
1
2
Share

How to Turn Off the Rear Wiper of the Lynk & Co 01?

The control switch for the rear wiper of the Lynk & Co 01 is located below the right side of the steering wheel. Pull the lever back one notch to turn off the rear wiper. Here is some related information: 1. Wiper Switch: The wiper switch of the Lynk & Co 01 is in the form of a lever, located behind the right side of the steering wheel. The Lynk & Co 01 also features automatic wipers, which adjust the wiper frequency based on the amount of rainfall. 2. Overview: The Lynk & Co 01 is the first model developed by Lynk & Co based on the CMA (Compact Modular Architecture) platform. It is the first to be equipped with the Drive-E series 2.0TD turbocharged engine, offering class-leading fuel efficiency and performance. The Lynk & Co 01 is also the world's first passenger car to feature Bosch's new ESP 9.3 high-dynamic version.
1
3
Share

Isn't Maybach a Mercedes-Benz?

Maybach is indeed a Mercedes-Benz, serving as a sub-brand under the Mercedes-Benz umbrella, primarily focused on crafting ultra-luxury flagship sedans. The first Maybach model was based on the Mercedes-Benz S-Class and was named the Maybach S-Class. Here are more details about Maybach vehicles: 1. Taking the 2020 Maybach as an example, its body dimensions are: length 5466mm, width 1899mm, height 1500mm, with a wheelbase of 3365mm and a fuel tank capacity of 70 liters. 2. The 2020 Maybach features a double-wishbone independent suspension at the front and rear, powered by a turbocharged engine delivering a maximum horsepower of 367ps, a maximum power of 270kw, and a maximum torque of 500nm, paired with a 9-speed automatic transmission.
14
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.