Which manufacturer produces the 6AT transmission for the Haoyue?

Why Does Turning the Steering Wheel with the Handbrake On Cause Noise?

Handbrake system is damaged or the handbrake is applied before the vehicle comes to a complete stop. Handbrake Introduction: The parking brake, commonly known as the handbrake, provides resistance to prevent the vehicle from rolling when parked. The parking brake, also referred to as the handbrake or the parking gear in automatic transmissions, locks the drive shaft or rear wheels. The force applied by the parking brake is much weaker than that of the service brake. Handbrake System: The Electronic Parking Brake (EPB) system integrates temporary braking during driving with long-term braking after parking, and it achieves parking braking through electronic control. The electronic handbrake uses electronic control to implement parking braking. Its working principle is the same as that of a mechanical handbrake, both relying on the friction between the brake disc and brake pads to control parking braking. The only difference is that the control method has shifted from the traditional mechanical handbrake lever to an electronic button.

4

5

Share

Is it illegal to install solar panels on the roof of a car?

Installing solar panels on the roof of a car is not illegal, but it is not recommended. The performance of solar panels is as follows: Slow charging of solar panels: Under full sunlight, a monocrystalline silicon solar panel can charge about 1 kWh of electricity in 10 hours per square meter. However, the roof area of a general passenger car is very small. Even if two square meters of solar panels can be installed, it can only charge 1 to 2 kWh of electricity per day under sufficient sunlight. Low conversion rate of solar panels: The energy conversion rate of solar panels is still relatively low, only about 20%. Since the roof area of a car is only 1 to 1.5 square meters, the power generation is relatively low. Low-cost solar panels are also relatively heavy, and the electricity they generate may not offset the additional power consumption. Moreover, the strength of solar panels is relatively low, so they cannot replace the original roof. Thin and lightweight solar panels are also expensive, and the cost may not be recovered even if the car is worn out.

11

3

Share

What Do You Need to Prepare for the Driving Test Subject 2?

Subject 2 of the driving test has high requirements for details. The specific steps to prepare for the Subject 2 test are as follows: 1. Practice at the test site before the exam. One or two days before the test, candidates who have the opportunity can go to the test site for a few simulation practices. 2. Bring all required documents. For any subject of the test, the candidate's identity information needs to be verified on-site, so the candidate must bring their ID card to the test site. 3. Adjust your mindset for the test. For beginners, the most detrimental thing during the test is nervousness and anxiety, which can easily lead to non-standard movements, missing reference points, or even forgetting what to do next. 4. Review the stopping points for all test items. Some candidates may have no problem with their operational skills but fail the test simply because they stopped at the wrong position, which is a pity. 5. Memorize the test items. Subject 2 consists of five mandatory items: reversing into a parking space, curve driving, stopping and starting on a slope, parallel parking, and making a right-angle turn.

10

3

Share

What Size Memory Card Does a Dash Cam Need?

The memory capacity of dash cams currently includes options such as 8GB, 16GB, and 32GB. Here are some relevant details about dash cams: The function of a dash cam: A dash cam is a device that records images, sounds, and other related information during vehicle travel. After installing a dash cam, it can record the entire driving process in video and audio, providing evidence in case of traffic accidents. Choosing a dash cam: It is best to use a Class6 or higher memory card for a dash cam to ensure smooth video storage and avoid corrupted recordings. As a high-speed read-write device, dash cams have specific requirements for storage and read speeds. The Class rating is the current standard for measuring the speed of MicroSD cards, with levels including Class0, Class2, Class4, Class6, and Class10. For example, a Class2 memory card represents a minimum write speed of 2MB/s, and so on—the higher the number, the faster the write speed. It is best to use a Class6 or higher memory card for a dash cam to ensure smooth video storage and avoid corrupted recordings.

16

3

Share

What does OBD stand for in a car?

OBD in a car is the abbreviation of On-Board Diagnostics, which means the on-board automatic diagnostic system in Chinese. Its main function is to monitor the operating status of the engine and the working condition of the exhaust treatment system in real time. The following is a related introduction to the on-board automatic diagnostic system: 1. This system will continuously monitor whether the vehicle's exhaust exceeds the standard based on the engine's operating conditions. Once the standard is exceeded, it will immediately issue a warning. When a system failure occurs, the Malfunction Indicator Lamp (MIL) or Check Engine warning light will illuminate. At the same time, the Powertrain Control Module (PCM) will store the fault information in the memory. The fault code can be read from the PCM through a certain procedure. Based on the prompt of the fault code, maintenance personnel can quickly and accurately determine the nature and location of the fault. 2. After an OBD system failure occurs, it should be repaired in time. The annual vehicle inspection has a limited effect on controlling vehicle emissions, but after the vehicle is equipped with OBD, the emission level of the vehicle can be monitored at any time.

2

4

Share

What Causes the Engine Malfunction Yellow Light to Illuminate?

When the engine's yellow warning light comes on, it indicates an intermittent engine fault, meaning the engine control system has detected inaccuracies in engine operation or sensor signals. Below are three common reasons for the engine malfunction yellow light to illuminate: 1. Sensor Issues: The sensors involved include those for coolant temperature, crankshaft position, air flow, intake air temperature, and oxygen sensors. When these sensors are damaged, have poor connections, or experience signal interruptions, the vehicle's ECU cannot accurately obtain engine data, triggering the engine malfunction light. 2. Maintenance Problems: Poor engine maintenance is the most frequent cause of the engine malfunction light. Vehicles have specific maintenance schedules, and if the owner fails to adhere to these schedules or has poor driving habits, it increases the engine's operational burden, causing the malfunction light to illuminate as a warning. 3. Poor Combustion of Air-Fuel Mixture: Faulty spark plugs, ignition coils, fuel pumps, or clogged fuel lines can lead to poor combustion of the air-fuel mixture in the engine. This results in engine carbon buildup or knocking issues, which are eventually detected by the engine's oxygen sensor and reported to the ECU, triggering the malfunction light as a warning.

5

1

Share

Which manufacturer produces the 6AT transmission for the Haoyue?

Why Does Turning the Steering Wheel with the Handbrake On Cause Noise?

Is it illegal to install solar panels on the roof of a car?

What Do You Need to Prepare for the Driving Test Subject 2?

What Size Memory Card Does a Dash Cam Need?

What does OBD stand for in a car?

What Causes the Engine Malfunction Yellow Light to Illuminate?

How many kilometers can a new car run on the highway?

Does Car Wheel Hub Modification Affect Vehicle Inspection?

What is the correct sequence for engaging P gear and applying the handbrake?

How to Distinguish Good and Bad Car Paint Jobs?