Which Lights Should Be Turned On in a Car During Snowy Weather?

1 Answers
LaLondon
07/29/25 8:38pm
In snowy or rainy weather, you can turn on the headlights, clearance lights, and rear position lights. The "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China" stipulate: 1. Article 58: When a motor vehicle is driving at night without streetlights, under poor lighting conditions, or in situations of low visibility such as fog, rain, snow, dust, or hail, the headlights, clearance lights, and rear position lights should be turned on. However, high beams should not be used when a vehicle is closely following another vehicle traveling in the same direction. Motor vehicles driving in foggy conditions should turn on fog lights and hazard warning flashers. 2. Article 59: When a motor vehicle passes through sharp curves, slopes, arched bridges, crosswalks, or intersections without traffic signal control at night, it should alternately use high and low beams to signal.
Was this review help?
13
5
Share
More Forum Discussions

Can a secondary engine start after vehicle water immersion be detected?

Vehicle secondary start after water immersion can be detected. The vehicle will only restart the starter motor after stalling in water, at which point the starter motor won't respond - this constitutes a secondary start. A secondary start refers to the situation where the engine stalls underwater and the driver attempts to turn the ignition key again underwater. Typically, if a vehicle stalls in water, there's a 50% chance of engine damage. However, if the engine is restarted after stalling, the engine will certainly be ruined. Precautions for rainy day driving are as follows: Reduce speed and drive cautiously: In severe weather conditions, strictly control your speed to allow adequate reaction time. Rain reduces tire traction and road grip, so maintain low speeds using second or third gear, not exceeding 30-40 km/h. Maintain clear visibility: Impaired visibility during rain easily leads to traffic accidents. Therefore, promptly activate wipers and adjust their speed according to rainfall intensity to ensure good visibility.
2
4
Share

What is the name of China's first Mars rover?

China's first Mars rover is named Zhurong. Here are some details about Zhurong: Introduction: Zhurong is the Mars rover for the Tianwen-1 mission. It stands 1.85 meters tall and weighs approximately 240 kilograms. Its designed operational lifespan is 3 Martian months, equivalent to about 92 Earth days. Naming Significance: In traditional Chinese culture, Zhurong is revered as the earliest god of fire, symbolizing our ancestors' use of fire to illuminate the earth and bring light. Naming the first Mars rover 'Zhurong' signifies the fire god Zhurong landing on Mars, symbolizing the ignition of China's interstellar exploration and guiding humanity's continued exploration and self-transcendence into the vast cosmos and the unknown universe.
9
1
Share

Why are license plates half yellow and half green?

License plates that are half yellow and half green, also known as yellow-green dual-color plates, are special license plates designated for large new energy vehicles. Below is expanded information about new energy vehicle license plates: 1. Compared to traditional ordinary vehicle license plates, new energy vehicle license plates feature a special emblem. The emblem uses green as the base color, symbolizing eco-friendly new energy, and includes an electric plug pattern. The license plate number for new energy vehicles has also been increased from the traditional 5 digits to 6 digits. 2. The dimensions of new energy vehicle license plates are 480mm×140mm. They are categorized into large new energy vehicle license plates and small new energy vehicle license plates, with the small ones featuring a gradient green color. New energy vehicle license plates primarily use green as the main color, making them distinctly different from regular motor vehicle license plates and easy to identify.
1
4
Share

What is the S gear in a car?

S (Sport) gear is the sports mode of a car. When the gear is shifted to S mode, the transmission can shift freely, but the shifting timing is delayed, keeping the engine at high RPM for a longer time. The car will then move at a lower gear with higher RPM for an extended period, resulting in greater torque output and acceleration. Here are some misconceptions about using S gear: During startup: It is not suitable to use S gear when starting. It can actually hinder speed improvement because, in a 6-speed forward car, staying in 1st or 2nd gear for too long prevents the speed from increasing. Without a heavy load, this only wastes the opportunity for speed gain. At high speeds: Avoid using S gear at high speeds because it will never reach 6th gear. Once S gear exceeds 90 km/h, the engine runs at excessively high RPM, producing unpleasant noise and consuming more fuel.
1
5
Share

What Causes the Squeaking Sound in the Engine When Driving Through Water?

There are generally two reasons for a sizzling sound after the engine starts: The car has not been started for a long time: If the car has not been used for an extended period, the engine oil will return to the oil pan. When the vehicle is started, the valves will lack the sealing and lubrication provided by the oil, resulting in a sizzling sound. This is a normal condition. Belt malfunction: An abnormal noise coming from the belt during startup indicates that the belt may have an issue, and it should be checked promptly. Below is relevant information: Brake pads getting wet: If the car drives through shallow water and water splashes onto the brake pads, a squealing sound when braking is normal. This situation only requires normal driving until the water on the brake pads wears off. Foreign objects on brake pads: If the car drives through deeper water, foreign objects such as plastic bags, paper, or mud may get stuck on the brake pads, causing noise when braking. In this case, the brake pads should be cleaned thoroughly.
6
5
Share

Is the Spirior produced by Dongfeng Honda or Guangzhou Honda?

The Spirior is a car produced by Dongfeng Honda, with a body length of 4.7 meters and a wheelbase of 2.7 meters. The car features sharp lines on its side profile. A distinct waistline starts from the front wheel arch, runs through the entire body, and extends to the small upturned rear spoiler, giving the Spirior a dynamic visual effect that is lower in the front and higher in the rear, creating a sense of readiness to pounce. Additional Information: 1. Dongfeng Honda: Dongfeng Honda Automobile Co., Ltd. was established on July 16, 2003. The company has 12,405 employees and currently operates three production plants. The first plant covers an area of 760,000 square meters with a building area of 310,000 square meters; the second plant covers 1,050,000 square meters with a building area of 350,000 square meters; and the third plant covers 983,000 square meters. The company has a research and development center with strong technical capabilities, as well as advanced production workshops for stamping, welding, synthetic resin, painting, engine casting, machining, drive shafts, engine assembly, and vehicle assembly. 2. Guangzhou Honda: GAC Honda Automobile Co., Ltd. (formerly Guangzhou Honda Automobile Co., Ltd.; abbreviated as GAC Honda) was established on July 1, 1998. It is a joint venture formed by Guangzhou Automobile Group Co., Ltd. and Honda Motor Co., Ltd. of Japan, with each party holding a 50% stake. The cooperation period is 30 years.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.